Various wireless applications are currently under development for the unlicensed 60 GHz band. This paper describes three examples with different system requirements. The first two are point-to-multipoint wireless networks (in an airplane and in a car) and the third one is a short range point-to-point connection. Special requirements of the applications are a high number of users for the point-to-multipoint connection and a high data rate of 10 Gbit/s for the point-to-point connection system. Implementation aspects are pointed out, which are important to demonstrate the functionality of the system in a relevant environment and are key aspects to develop the related products. For example, integration aspects of the antenna into an airplane passenger seat and the receiver concept of the radio frequency-(RF) front-end to reducing the power consumption at ultrahigh data rates are described. Additionally, to determine the geometrical system architecture, ray-tracing simulations inside an aircraft and inside a car were performed.

This paper presents the development of a reconfigurable receiver to undertake challenging signal processing tasks for a novel polarimetric radar system. The field-programmable gate arrays (FPGAs)-based digital receiver samples incoming signals at intermediate frequency (IF) and processes signals digitally instead of using conventional analog approaches. It offers more robust system stability and avoids unnecessary multichannel calibrations of analog circuits for a full polarimetric radar. Two kinds of dual-orthogonal signals together with corresponding processing algorithms have been investigated; the digital implementation architectures for all algorithms are then presented. Processing algorithms implemented in FPGA chips can be reconfigured adaptively regarding to different transmitted waveforms without modification of hardware. The successful development of such reconfigurable receiver extends our radar capacity and thus yields tremendous experimental flexibility for atmospheric remote sensing and polarimetric studies of ground-based targets.

Two new designs of the L-shaped Planar Inverted–F Antenna (PIFA) antennas with single and dual polarization operating at the frequency band for IEEE 802.11b/g standard with satisfactory radiation characteristics are presented. We further propose a genetic algorithm (GA) embedded in CST Microwave Studio for optimizing these antenna parameters. The agreement of simulation and measurement results shows the performance of our joint model. Also, they show that our dual-polarization antenna is suitable for indoor Multiple Input Multiple Output (MIMO) wireless environment applications.

This study deals with a non-exhaustive overview of location systems operating in the 60 GHz frequency band. Both impulse and frequency hopping topologies are considered and the performances of the two realized systems are presented. For each system, a specific signal processing has been implemented to prevent the degradation of the location error from the impact of the multipath propagation.

Multipath propagation is still one of the major problems in local positioning systems today. Especially in indoor environments, the received signals are disturbed by blockages and reflections. This can lead to a large bias in the user's time-of-arrival (TOA) value. Thus multipath is the most dominant error source for positioning. In order to improve the positioning performance in multipath environments, recent multipath mitigation algorithms based upon the concept of sequential Bayesian estimation are used. The presented approach tries to overcome the multipath problem by estimating the channel dynamics, using unscented Kalman filters (UKF). Simulations on artificial and measured channels from indoor as well as outdoor environments show the profit of the proposed estimator model. Furthermore, the quality of channel estimation applying the UKF and the channel sounding capabilities of the estimator are shown.

An alternative approach is based on statistically computed signal analysis technique for the design of antenna array exhibiting lower side lobes in their radiation pattern. New and generalized expressions for the array factor of all physically realizable linear antenna arrays are introduced. An algorithm based on the statistically computed signal analysis is designed. By considering the random elements, distance between the sensors, their mean, variance, average amplitude pattern and correlation of the amplitude between the two angles, some mathematical formulations have been done and shown with the help of MATLAB. Based on these generalized expressions, a new way of synthesizing arrays with reduced side lobes is available. It applies to end fire antenna array, which may have either even or odd numbers of sensors with restricted elements spacing. Final expressions shown are a clear relationship between elements excitation and null location in the radiation patterns.

Near sea surface radio frequency (RF) refraction is four dimensional (4D) and can significantly impact the performance of radar systems. The refractivity field is dictated by the vertical thermodynamic structure of the constantly evolving marine atmospheric boundary layer (MABL). Logistical and budgetary restraints on meteorological measurements over water to capture the spatio-temporal structure of refractivity fields influencing radar performance have limited the knowledge of how and why radar performance is azimuth, range, and time dependent. Rapidly increasing computer processing speeds and decreasing memory capacity costs have supported the horizontal and vertical resolution requirements for mesoscale numerical weather prediction (NWP) models to resolve the thermodynamic structure in the MABL. Once modeled, refractivity structure is easily calculated from the thermodynamic structure. Mesoscale NWP models coupled with modern parabolic equation radar performance models can support the prediction of 4D radar performance in challenging non-homogeneous, near surface refractivity fields at the time and location of the modeler's choice. The NWP modeling presented in this paper demonstrates how large-scale offshore flow of warm and dry air over colder seas produces strong near surface RF trapping. Large land-sea temperature differences can produce near shore sea breezes and surface-based ducts. This paper describes modeled radar performance in such a complex ducting structure over the Persian Gulf during large-scale northwest atmospheric flow. The refractivity field was resolved by the Coupled Ocean/ Atmosphere Mesoscale Prediction System (COAMPS® is a registered trademark of the Naval Research Laboratory) and the notional radar performance was modeled by the advanced refractive effects prediction system (AREPS). The results indicate strong spatial and wavelength-dependent enhancements and degradations in radar performance relative to a standard atmosphere.

In this article, analog fiber optic links (radio-over-fiber, RoF, links) are presented as a flexible, low-cost solution for in-house distribution of millimeter-wave (mmw) signals. Mode-locked laser diodes (MLLD) serve as inexpensive mmw sources for the downlink distribution of mmw signals across an optical fiber link. We compare the robustness of direct and external RF modulation for such MLLD-based RoF systems, whereas the error vector magnitude (EVM) of the received symbols serves as a figure of merit. On the eve of 60 GHz WLAN standardization, we experimentally investigate the transmission of narrowband WLAN (IEEE 802.11a) signals in the millimetric range at moderate data rates. We also demonstrate broadband transmission of multi-band orthogonal frequency-division multiplexing (MB-OFDM) ultra-wideband (UWB) european computer manufacturers association (ECMA 368) signals in the 60 GHz band for data rates of up to 480 Mbps.

This paper deals with the numerical dosimetry for adult and children models exposed to CW signals of several wireless communication systems (UMTS, WiMax, and Bluetooth) within a partly shielded environment represented by a realistic car model. More than 20 mono- and multi-source exposure scenarios are considered. Computational results demonstrate that, for all considered exposure scenarios, the specific absorption rate (SAR) is at least 40 times (whole-body average) and 10 times (local SAR) lower than the exposure limits fixed by the International Commission on Non-Ionizing Radiation Protection (ICNIRP). The whole-body average SAR values for children are found to be typically 1.1–1.3 times higher than those of adults. Under several exposure scenarios, the local SAR in the limbs of children models is 2–3 times higher than corresponding values in adult models. The power density distributions within the car have been also analyzed for one, two, and three simultaneously emitting devices. The results show that the homogeneity of the power density distribution increases with increasing number of simultaneously operating transmitters. These data suggest that the use of several wireless communication devices within a car leads to exposure levels that are several orders of magnitude below international exposure limits, even for the multi-exposure scenarios for both adult and children models.

In this paper we propose a photonic technique for a reconfigurable microwave signal generation based on the beating of two laser modes coming from a regenerative fiber mode-locked laser (FMLL) into a photodiode. The excellent performance of this kind of pulsed laser guarantees high stability on the directly generated microwave signal even at ultrahigh frequencies (up to W band). Therefore, by using the proposed architecture, the performance of a reconfigurable full digital coherent radar system can be enhanced for example in terms of moving target indicator (MTI) improvement factor and analog to digital converter maximum signal to noise ratio. Differently from the conventional radar oscillators, whose performance strongly deteriorate with increasing frequencies, the photonic radio frequency (RF) generation always shows an excellent spectral purity. Moreover, thanks to the achievable high repetition rates and the coherence properties of the FMLL, this laser scheme has also been proposed for digitizing, directly at RF, the received signal by electro-optical sampling. Thus the advantage of using just one device for signal generation in both the transmitter and receiver chain, makes the proposed solution a cost-effective architecture for microwave signal generation.

The biocompatibility of millimeter-wave devices and systems is an important issue due to the wide number of emerging body-centric wireless applications at millimeter waves. This review article provides the state of knowledge in this field and mainly focuses on recent results and advances related to the different aspects of millimeter-wave interactions with the human body. Electromagnetic, thermal, and biological aspects are considered and analyzed for exposures in the 30-100 GHz range with a particular emphasis on the 60-GHz band. Recently introduced dosimetric techniques and specific instrumentation for bioelectromagnetic laboratory studies are also presented. Finally, future trends are discussed.

In this paper, we have analyzed the performance of correlated Nakagami-m fading channel by using the maximal-ratio-combing diversity at the receiver. A closed-form mathematical expression is derived for the average bit error rate (BER) for binary phase-shift keying (BPSK) and average symbol-error-rate (SER) for M-Quardrature amplitude modulation (M-QAM) scheme in terms of the higher transcendental function such as Appell hypergeometric function by using the well-known moment generating function (MGF)-based approach with arbitrary fading index for the orthogonal frequency division multiplexing (OFDM) communication systems. Moreover, we also derived an expression for the outage probability and the proposed numerical results are compared with the reported literature.