An experimental high-aspect ratio wing aeroelastic model with a device to provide a controllable slender body tip mass distribution has been constructed and the model response due to flutter and limit cycle oscillations has been measured in a wind tunnel test. A theoretical model has also been developed and calculations made to correlate with the experimental data. Structural equations of motion based on nonlinear beam theory are combined with the ONERA aerodynamic stall model (an empirical extension of Theodorsen aerodynamic theory that accounts for flow separation). A dynamic perturbation analysis about a nonlinear static equilibrium is used to determine the small perturbation flutter boundary which is compared to the experimentally determined flutter velocity and flutter frequency. Time simulation is used to compute the limit cycle oscillations response when the flutter/LCO control system is ON or OFF. Theory and experiment are in good agreement for predicting the flutter/LCO suppression that can be achieved with the control device.

An ultrasonic guided wave technique based on time delay comb transducers is introduced for aircraft inspection. It is demonstrated that for isotropic plate structures the time delay comb transducers with appropriate excitation are capable of performing discontinuity detections without knowing the precise isotropic material properties of the objects being inspected. Fibre-reinforced composite plates are also considered. The wave skew effects are investigated using both the slowness curve and the Poynting vector. A composite inspection technique that takes advantage of the skew effects is proposed. Using time delay comb transducers to excite the guided wave modes with different skew angles, the proposed technique is capable of scanning the composite plate in different directions without moving or rotating the transducers. By contrast with the applications in the isotropic cases, knowledge of the material properties and other necessary information that is needed to produce dispersion curves is generally required. Experimental results are provided as a validation of the proposed techniques.

This paper presents the highlights of the F-35 STOVL Jet Effects (SJE) test effort during the complete four years of the System Development and Demonstration phase. A new 12%-scale F-35 SJE model was tested in the German-Dutch wind-tunnels Large Low Speed Facility in order to gather STOVL jet-induced Forces and Moments. Ten separate test entries were conducted, covering all STOVL flight regimes from pure hover in ground effect through transition to wing borne flight. This paper will present an overview of this program, including a detailed description of the wind-tunnel model, testing techniques, test conditions, and accomplishments.