This work evaluates the use of light microscopes (LMs) as a tool for interlaminar fracture of polymer composite investigation with the aid of correlative fractography. Correlative fractography consists of an association of the extended depth of focus (EDF) method, based on reflected LM, with scanning electron microscopy (SEM) to evaluate interlaminar fractures. The use of these combined techniques is exemplified here for the mode I fracture of carbon–epoxy plain-weave reinforced composite. The EDF-LM is a digital image-processing method that consists of the extraction of in-focus pixels for each x-y coordinate in an image from a stack of Z-ordered digital pictures from an LM, resulting in a fully focused picture and a height elevation map for each stack. SEM is the most used tool for the identification of fracture mechanisms in a qualitative approach, with the combined advantages of a large focus depth and fine lateral resolution. However, LMs, with EDF software, may bypass the restriction on focus depth and present enough lateral resolution at low magnification. Finally, correlative fractography can provide the general comprehension of fracture processes, with the benefits of the association of different resolution scales and contrast modes.

α-viniferin, an active component of the plant Carex baccans L., is known for its anticancer, antidiabetic, and anti-inflammatory properties. In Northeast India, different tribes traditionally consume C. baccans to control intestinal helminth infections. Therefore, the present study was carried out to assess the extent of tegumental alteration caused by α-viniferin in Raillietina echinobothrida, a widely prevalent poultry helminth in northeast India. Helminths were exposed in vitro to various doses of α-viniferin (50, 100, and 200 µM/mL of physiological buffered saline) and their motility and mortality were recorded. Stereoscan observations on the parasite exposed to the active compound showed extensive distortion and destruction of the surface fine topography of the tegument compared with controls. The compound also caused extensive damage to the tegument by disintegration of microtriches, disorganization of muscle bundles, and loss of cellular organelles combined with distortion and disruption of the plasma membrane, nuclear membrane, nucleolus, mitochondrial membrane, and cristae. Histochemical and biochemical studies carried out parasites exposed to α-viniferin revealed a decline in the activity of vital tegumental enzymes like acid phosphatase, alkaline phosphatase, and adenosine triphosphatase. Extensive structural and functional alterations observed in the treated parasites are indicative of efficient cestocidal activity of the compound.

Owing to exceptional heterogeneity in the outcome of invasive breast cancer it is essential to develop highly accurate prognostic tools for effective therapeutic management. Based on this pressing need, we aimed to improve breast cancer prognosis by exploring the prognostic value of tumor histology image analysis. Patient group (n=78) selection was based on invasive breast cancer diagnosis without systemic treatment with a median follow-up of 147 months. Gray-level co-occurrence matrix texture analysis was performed retrospectively on primary tumor tissue section digital images stained either nonspecifically with hematoxylin and eosin or specifically with a pan-cytokeratin antibody cocktail for epithelial malignant cells. Univariate analysis revealed stronger association with metastasis risk by texture analysis when compared with clinicopathological parameters. The combination of individual clinicopathological and texture variables into composite scores resulted in further powerful enhancement of prognostic performance, with an accuracy of up to 90%, discrimination efficiency by the area under the curve [95% confidence interval (CI)] of 0.94 (0.87–0.99) and hazard ratio (95% CI) of 20.1 (7.5–109.4). Internal validation was successfully performed by bootstrap and split-sample cross-validation, suggesting that the models are generalizable. Whereas further validation is needed on an external set of patients, this preliminary study indicates the potential use of primary breast tumor histology texture as a highly accurate, simple, and cost-effective prognostic indicator of distant metastasis risk.

Diffusion bonding of TiAl alloys can be enhanced by the use of reactive nanolayer thin films as interlayers. Using these interlayers, it is possible to reduce the conventional bonding conditions (temperature, time, and pressure) and obtain sound and reliable joints. The microstructural characterization of the diffusion bond interfaces is a fundamental step toward understanding and identifying the bonding mechanisms and relating them to the strength of the joints. The interface of TiAl samples joined using Ni/Al nanolayers was characterized by transmission electron microscopy and scanning transmission electron microscopy. Microstructural characterization of the bond revealed that the interfaces consist of several thin layers of different composition and grain size (nanometric and micrometric). The bonding temperature (800, 900, or 1,000°C) determines the grain size and thickness of the layers present at the interface. Phase identification by high-resolution transmission electron microscopy combined with fast Fourier transform and electron energy-loss spectroscopy analyses reveals the presence of several intermetallic compounds: AlTiNi, NiAl, and Al2TiNi. For bonds produced at 800 and 900°C, nanometric grains of Ti were detected at the center of the interface.

The preparation of transmission electron microcopy (TEM) samples from powders with particle sizes larger than ~100 nm poses a challenge. The existing methods are complicated and expensive, or have a low probability of success. Herein, we report a modified methodology for preparation of TEM samples from powders, which is efficient, cost-effective, and easy to perform. This method involves mixing powders with an epoxy on a piece of weighing paper, curing the powder–epoxy mixture to form a bulk material, grinding the bulk to obtain a thin foil, punching TEM discs from the foil, dimpling the discs, and ion milling the dimpled discs to electron transparency. Compared with the well established and robust grinding–dimpling–ion-milling method for TEM sample preparation for bulk materials, our modified approach for preparing TEM samples from powders only requires two additional simple steps. In this article, step-by-step procedures for our methodology are described in detail, and important strategies to ensure success are elucidated. Our methodology has been applied successfully for preparing TEM samples with large thin areas and high quality for many different mechanically milled metallic powders.

The present communication reports toxic effects of bleached sulfite pulp mill effluents in fish (Heteropneustes fossilis) gills, with optical, scanning electron, and transmission electron microscopy. The general adverse effects include dilation of the primary lamellar wall, curling of secondary lamellar terminals, displacement of epithelial cell layers, degeneration of secondary lamella, deposition of mucous, and severe congestion in the gill arch. The significant shortening of secondary lamellae, widening of lamellar tips, and significant decrease in the number of mitochondria in chloride cells as compared to controls are some specific effects of bleached sulfite pulp mill effluents. Scanning electron microscopy demonstrated tearing of tissues in gill lamellae and arches. Transmission electron microscopy revealed membrane distortion of mitochondria in chloride cells, loss of uniformity of microvilli in pavement cells, and abnormalities in nuclear shape in different cells of effluent-exposed fish gills. Toxicity of the bleached sulfite pulp mill effluents and its impact on fish are discussed in the light of existing literature. Further, the importance of microscopy in toxicological evaluation of environmental pollutants is emphasized in view of its specific application potential.

Skin samples were used to compare microscopy methods used to quantify collagen with potential applicability to resolve time-dependent collagen deposition during skin wound healing in rats. Skin wounds by secondary intention were made in rats and tissue fragments were collected every 7 days for 21 days. Collagen content determined by biochemical analysis was compared with collagen measured by point counting (PC) on histological skin sections stained by Gomori’s trichrome method (Trichrome/PC), Sirius red under polarized light (PL) microscopy (Sirius red/PL-PC), and computational color segmentation (CS) applied to sections stained with Sirius red (Sirius red/PL-CS). All microscopy methods investigated resolved the time-dependent dynamics of collagen deposition in scar tissue during skin wound healing in rats. Collagen content measured by Sirius red/PL-PC and Sirius red/PL-CS was significantly lower when compared with Trichrome/PC. The Trichrome/PC method provided overestimated values of collagen compared with biochemical analysis. In the early stages of wound healing, which shows high production of noncollagenous molecules, Sirius red/PL-CS and Sirius red/PL-PC methods were more suitable for quantification of collagen fibers. Trichrome staining did not allow clear separation between collagenous and noncollagenous elements in skin samples, introducing a marked bias in collagen quantification.

This paper presents experimental results obtained from a scanning electron microscope (SEM) second-order focusing toroidal electron energy analyzer attachment. The results demonstrate that the analyzer can be used to obtain high signal-to-noise voltage and dopant concentration measurements on semiconductors in the presence of different electric field conditions at the sample. The experimentally calculated relative error of measurement typically varies from 31 to 63, corresponding to secondary electron (SE) signal mean shifts of 9–18 mV. The millivolt accuracy of these results is over one order of magnitude better than earlier quantitative dopant concentration measurements made by a retarding field analyzer.

For many cancers, liver metastasis is common and usually indicates poor prognosis. Gastro-enteropancreatic neuroendocrine tumors (GEPNETs) of the midgut are a heterogeneous group of cancers that typically remain asymptomatic until they metastasize to the liver. However, the mechanisms by which these usually indolent cancers establish distal metastasis remain unclear.

To begin to elucidate this process, we performed standard in vitro assays to assess cell motility, transendothelial migration, and invasion using BON cells, a widely used model GEPNET cell line. In addition, transmission electron microscopy was used in combination with a novel ex vivo organ slice xenograft model to reveal ultrastructural details of the initial events of BON cell extravasation and re-distribution within the liver. The ultrastructural resolution of the extravasation process revealed the route, sequence, and time course by which tumor cells migrated from the sinusoidal lumen into the hepatic parenchyma in this organ slice model. Both standard in vitro assays and our organ slice model indicated that tumor cells migrated through the discontinuous sinusoidal endothelium to invade the liver parenchyma.

The aim of this paper is to determine the effects of forces exerted on the cantilever probe tip of an atomic force microscope (AFM). These forces vary according to the separation distance between the probe tip and the surface of the sample being examined. Hence, at a distance away from the surface (farther than don), these forces have an attractive nature and are of Van der Waals type, and when the probe tip is situated in the range of a0≤dts≤don, the capillary force is added to the Van der Waals force. At a distance of dts≤a0, the Van der Waals and capillary forces remain constant at intermolecular distances, and the contact repulsive force repels the probe tip from the surface of sample. The capillary force emerges due to the contact of thin water films with a thickness of hc which have accumulated on the sample and probe. Under environmental conditions a layer of water or hydrocarbon often forms between the probe tip and sample. The capillary meniscus can grow until the rate of evaporation equals the rate of condensation. For each of the above forces, different models are presented. The smoothness or roughness of the surfaces and the geometry of the cantilever tip have a significant effect on the modeling of forces applied on the probe tip. Van der Waals and the repulsive forces are considered to be the same in all the simulations, and only the capillary force is altered in order to evaluate the role of this force in the AFM-based modeling. Therefore, in view of the remarkable advantages of the piezoelectric microcantilever and also the extensive applications of the tapping mode, we investigate vibrational motion of the piezoelectric microcantilever in the tapping mode. The cantilever mentioned is entirely covered by two piezoelectric layers that carry out both the actuation of the probe tip and the measuringof its position.

Angiogenesis is a closely controlled biological process that takes place during fetal development of blood vessels and wound healing, and includes the development of new blood vessels from preexisting blood vessels. Tumor angiogenesis is a means by which tumors obtain oxygen, nutrition and promote tumor growth. Angiogenesis-regulating proteins are therefore ideal biomarkers in the study of tumor pathophysiology. In our laboratory, a new in silico-designed analogue of 2-methoxyestradiol has been synthesized with angiogenic properties, namely 2-ethyl-3-O-sulfamoyl-estra-1,3,5(10)16-tetraene (ESE-16). The ex vivo influence of ESE-16 on angiogenesis and morphology in platelets of healthy participants was investigated. Scanning electron microscopy revealed no morphological changes in ESE-16-treated platelets. The possible antiangiogenic effect of ESE-16-exposed platelets was determined by means of flow cytometry measurement of angiogenic protein levels, which were significantly increased after platelets were added to tumorigenic breast epithelial cells. This indicates that binding of platelets to cancer cells causes differential release of platelet constituents. Vascular endothelial growth factor levels were decreased in platelets, whereas platelet-derived growth factor and matrix metallopeptidase-9 levels were not significantly affected in platelets. In light of the above-mentioned data, further investigation of ESE-16’s influence on morphology and angiogenic markers in platelets of cancer patients is warranted.