Sugarcane brown rust, caused by Puccinia melanocephala, is one of the main diseases of sugarcane in China. The identification and discovery of new resistance genes have important theoretical and practical significance for preventing outbreaks of brown rust and ensuring the sustainable production of sugarcane. To screen for polymorphic simple-sequence repeat (SSR) molecular markers for localization of brown rust resistance genes, we used two populations that are suitable for genetic linkage map construction and mapping of new resistance genes to construct resistant and susceptible genetic pools. We then screened 449 pairs of primers to identify polymorphic SSR markers in the parental lines and the resistant/susceptible genetic pools. The results showed that 25 pairs of primers directed amplification of polymorphic DNA fragments between the parents of the cross combination ‘Yuetang 03-393’ × ‘ROC 24’, and 16 pairs of primers amplified polymorphic fragments between the parents of the cross combination ‘Liucheng 03-1137’ × ‘Dezhe 93-88’. Four pairs of primers (SMC236CG, SCESSR0928, SCESSR0636 and SCESSR2551) amplified polymorphic DNA fragments between the parental lines and the resistant/susceptible genetic pools in ‘Yuetang 03-393’ × ‘ROC 24’. The results of this study will establish a solid foundation for the mapping of new brown rust resistance genes, genetic linkage map construction and the development of closely-associated molecular markers in sugarcane.

We assessed inheritance of resistance to sugarcane brown rust (Puccinia melanocephala) in selfing F1 populations of wild sugarcane germplasm Erianthus rockii ‘Yundian 95-19’ and E. rockii ‘Yundian 95-20’. We tested parent and selfing F1 individuals for the brown rust resistance gene, Bru1, that has been shown to confer resistance to brown rust in sugarcane. The Bru1 gene was not detected in E. rockii ‘Yundian 95-19’, E. rockii ‘Yundian 95-20’ or their selfing F1 individuals, and we found there was segregation of resistance in the two selfing F1 populations (segregation ratio: 3:1). The results confirmed resistance in E. rockii ‘Yundian 95-19’ and E. rockii ‘Yundian 95-20’ to sugarcane brown rust is controlled by a novel, single dominant gene.

Owing to energy conservation of waste heat, Lead telluride, PbTe, based materials have promising good thermoelectric properties around a range of middle temperature (Fig. 1, from 300 to 600°C), due to their high melting point, fine chemical stability, and the high figure of merit Z. The general physical properties and factors affecting the figure of merit have been reviewed. This research is focused on the n-type of PbTe materials and collocated with analysis of densities, hardness, elastic modulus, and thermoelectric properties thermoelectric figure of merit ZT=GS2T/κ (where G is electrical conductivity, S is Seebeck coefficient , T is absolute temperature, and κ is thermal conductivity). Room temperature hardness and Young’s modulus are measured by nano-indentation. In this study, the hot-press compacts under the pressure of 4 ton/cm2 can reach the maximum density about 8.2 g/cm3, and hardness and elastic modulus are 0.6 GPa and 70 GPa, respectively. The figure of merit value (ZT) of PbTe in low temperature (around 340°C) was found about 1 with carrier concentration above 1019 cm−3. These results also indicate that the powder metallurgy parameters provide potentialities for further increase of the high efficiency of energy conversion in PbTe materials.

Spectroscopic Ellipsometry (SE) was chosen to study thin film growth in atomic layer deposition (ALD). It was shown that Cauchy model had limitations in predicting the ultrathin film thickness at initial few deposition cycles, and the fitting results depend on wavelengths range greatly. Effective Medium Approximation (EMA) model is capable of predicting ultrathin film’s physical properties. Our experiments on Al2O3 growth give supporting evidence on the applicability of EMA model, where it is used to successfully explain the initial nucleation and island like growth. EMA model can be extended to be used for Palladium thin film, which can give reasonable thickness and void content.

Eupatorium adenophorum (crofton weed) is one of the most widespread invasive species in China. Its genetic diversity and population structure in China were analysed by amplified fragment length polymorphism (AFLP). Three primer pairs were selected for the analysis and 490 bands were produced from 62 E. adenophorum populations selected from five major geographic areas. A total of 328 of the bands showed polymorphism [percentage of polymorphic bands (PPB)=59.4%]. Diversity levels of populations were relatively high (mean expected heterozygosity=0.154, mean Shannon index=0.241). At the regional level, the AMOVA indicated that about 70.25% of variation in the data set was from genotypic variations within populations, whereas 8.04% of the variation was due to regional differences, and the remaining 21.71% to differences among populations within the provincial regions. Cluster analysis based on the unweighted pair-group method using the method of arithmetic averages (UPGMA) grouped the majority of E. adenophorum populations into four main clusters, which correspond to their geographic regions. It is concluded that E. adenophorum spread mainly by wind or water and its genetic diversity level in newly invaded areas was lower than that in formerly colonized areas.