The 22q11.2 microdeletion is found in most of DiGeorge and velocardiofacial syndromes. These individuals have a wide range of anomalies including congenital heart disease, palatal abnormalities, characteristic facial features, hypocalcaemia, immune deficiency, and learning difficulties. Congenital heart disease, particularly conotruncal malformations are associated with 29% of deletions. This syndrome may be inherited as an autosomal dominant trait, but the majority of patients (93%) have a de novo deletion. To access the presence of the microdeletion in those individuals whose phenotipic changes suggested abnormalities in chromosome 22, a study has been made in several children with congenital heart defects.

Ultrafast electron diffraction (UED) enables studies of structural dynamics at atomic length and timescales, i.e., 0.1 nm and 0.1 ps, in single-shot mode. At present UED experiments are based on femtosecond laser photoemission from solid state cathodes. These photoemission sources perform excellently, but are not sufficiently bright for single-shot studies of, for example, biomolecular samples. We propose a new type of electron source, based on near-threshold photoionization of a laser-cooled and trapped atomic gas. The electron temperature of these sources can be as low as 10 K, implying an increase in brightness by orders of magnitude. We investigate a setup consisting of an ultracold electron source and standard radio-frequency acceleration techniques by GPT tracking simulations. The simulations use realistic fields and include all pairwise Coulomb interactions. We show that in this setup 120 keV, 0.1 pC electron bunches can be produced with a longitudinal emittance sufficiently small for enabling sub-100 fs bunch lengths at 1% relative energy spread. A transverse root-mean-square normalized emittance of εx = 10 nm is obtained, significantly better than from photoemission sources. Correlations in transverse phase-space indicate that the transverse emittance can be improved even further, enabling single-shot studies of biomolecular samples.

Extended abstract of a paper presented at Microscopy and Microanalysis 2009 in Richmond, Virginia, USA, July 26 – July 30, 2009

With light and scanning electron microscopy of vascular corrosion casts, we have observed in Urobatis jamaicensis that the fourth epibranchial arteries do not merge completely with the dorsal aorta. Instead they form a brief anastomosis with a short vessel projecting ventrally from the dorsal aorta and maintain their integrity as separately distinct vessels. Posterior to the anastomosis, the right epibranchial becomes the celiac trunk and left epibranchial becomes the anterior mesenteric artery/posterior intestinal artery. This vascular configuration appears to be unique in elasmobranchs.

The rapid advance and falling costs of computing power and data storage during the last 40 years have greatly enhanced the data reduction speed and analytical capacity of energy dispersive spectroscopy (EDS) systems. At the same time, the solid state X-ray detector [until recently, the Si(Li) diode] has seen performance increases due to the use of advanced materials and processing techniques. In addition, the performance of the electronic components (field effect transistor, preamp, and pulse processor) of an EDS system has been constantly improved. These technology advances have resulted in improved spectral quality, excellent light element detection, and increased count rate performance. The results have been truly remarkable and driven by the needs of the analyst. This article will summarize the progress made in these areas in the last 40 years and make a brief reference to prospects for future development in EDS system performance.

As wood is prone to fungal degradation, fundamental research is necessary to increase our knowledge aiming at product improvement. Several imaging modalities are capable of visualizing fungi, but the X-ray equipment presented in this article can envisage fungal mycelium in wood nondestructively in three dimensions with submicron resolution. Four types of wood subjected to the action of the white rot fungus Coriolus versicolor (Linnaeus) Quélet (CTB 863 A) were scanned using an X-ray-based approach. Comparison of wood volumes before and after fungal exposure, segmented manually or semiautomatically, showed the presence of the fungal mass on and in the wood samples and therefore demonstrated the usefulness of computed X-ray tomography for mycological and wood research. Further improvements to the experimental setup are necessary to resolve individual hyphae and enhance segmentation.

A previously developed Monte Carlo code has been extended to the X-ray microanalysis in a (scanning) transmission electron microscope of plan sections, consisting of bilayers and triple layers. To test the validity of this method for quantification purposes, a commercially available NiOx (x ∼ 1) thin film, deposited on a carbon layer, has been chosen. The composition and thickness of the NiO film and the thickness of the C support layer are obtained by fitting to the three X-ray intensity ratios I(NiK)/I(OK), I(NiK)/I(CK), and I(OK)/I(CK). Moreover, it has been investigated to what extent the resulting film composition is affected by the presence of a contaminating carbon film at the sample surface. To this end, the sample has been analyzed both in the (recommended) “grid downward” geometry and in the upside/down (“grid upward”) situation. It is found that a carbon contaminating film of few tens of nanometers must be assumed in both cases, in addition to the C support film. Consequently, assuming the proper C/NiOx/C stack in the simulations, the Monte Carlo method yields the correct oxygen concentration and thickness of the NiOx film.

The computerized multichannel analyzer running software specifically designed for X-ray analysis appeared very early in the commercialization of the energy dispersive X-ray spectrometer (EDS) and, like the solid-state X-ray detector itself, was built on a technology foundation originally developed for nuclear spectroscopy. However, software techniques employed for gamma-ray spectra could not accommodate the continuum component of EDS spectra, and a new approach was required. Least-squares fitting with “top-hat” filtered spectra proved to be an effective solution that is still widely used today. Though modern computer technology has subsequently contributed greatly to the speed and convenience of present-day EDS software, it seems that the achievable accuracy and precision of spectrum analysis has not fundamentally improved, and most of the early challenges are still quite relevant, although they may appear in new guises. The availability of the high speed silicon drift detector, however, may provide both the incentive and the data precision to drive future advances. This article traces the formative years of EDS software from the personalized perspective of a participant. Factors that shaped the development of the industry are identified, and future directions are speculated.

Electron backscatter diffraction (EBSD) is becoming a widely used technique to determine crystallographic orientation in biogenic carbonates. Despite this use, there is little information available on preparation for the analysis of biogenic carbonates. EBSD data are compared for biogenic aragonite and calcite in the common blue mussel, Mytilus edulis, using different types of resin and thicknesses of carbon coating. Results indicate that carbonate biomineral samples provide better EBSD results if they are embedded in resin, particularly epoxy resin. A uniform layer of carbon of 2.5 nm thickness provides sufficient conductivity for EBSD analyses of such insulators to avoid charging without masking the diffracted signal. Diffraction intensity decreases with carbon coating thickness of 5 nm or more. This study demonstrates the importance of optimizing sample preparation for EBSD analyses of insulators such as carbonate biominerals.

MSA's MegaBooth (Booth #258) provides many services for meeting attendees. The Internet Café offers free internet access. While you're waiting for a terminal, you can examine copies of recent microscopy books, for both adult microscopists and children. Sample DVDs of meeting tutorials are available for review. You can post a resume or job opening, or sign up for exhibitor tutorials. Free copies of Microscopy Today (MT) and Microscopy and Microanalysis are available. You can get information on MSA membership and MSA's technologist certification and undergraduate scholarship programs. Project MICRO, MSA's precollege outreach program and the Technologist Forum both have information desks.

Chronic neuropathic pain is a pathology that affects thousands of people worldwide. Antidepressants have been prescribed for the treatment of this sort of pain but the mechanisms underlying their analgesic action remain unknown. Extracellular-signal regulated kinases (ERKs) are being implicated in pain transmission and modulation as well as in the pathophysiology of depression. In order to clarify some of the mechanisms which might be related to the analgesic effect of antidepressants, we started by evaluating possible changes in the pattern of activation of ERKs in rats with chronic constriction injury (CCI), an experimental model of chronic

Extended abstract of a paper presented at Microscopy and Microanalysis 2009 in Richmond, Virginia, USA, July 26 – July 30, 2009

We investigated the chemical shift of the electron energy-loss near-edge structure (ELNES) for the nitrogen K-edge and titanium L3-edge measured from the interface region between a titanium nitride layer and a titanium layer. Both the titanium nitride and titanium layers were prepared by a sputtering method. Elemental analysis for nitride and titanium in the vicinity of the interface region was performed using a standard technique in electron energy-loss spectroscopy. It was demonstrated that both the ELNES of nitrogen K-edge and titanium L3-edge presented the chemical shift, more or less, depending on the composition of TiNx. The experimental findings were interpreted using a first-principles band structure calculation. The chemical shifts of nitrogen K-edge and titanium L3-edge can be used as fingerprinting for readily distinguishing the composition of TiNx.

This series of articles describes a method that performs (semi)quantitative phase analysis for nanocrystalline transmission electron microscope samples from selected area electron diffraction (SAED) patterns. Volume fractions of phases and their textures are obtained separately in the method. First, the two-dimensional SAED pattern is converted into an X-ray diffraction–like one-dimensional distribution. Volume fractions of the nanocrystalline components are determined by fitting the spectral components, calculated for the previously identified phases with a priori known structures. Blackman correction is also applied to take into account dynamic effects for medium grain sizes. Peak shapes and experimental parameters (camera length, etc.) are refined during the fitting iterations. Parameter space is explored with the help of the Downhill-SIMPLEX algorithm. Part I presented the principles, while Part II now elaborates current implementation, and Part III will demonstrate its usage by examples. The method is implemented in a computer program that runs under the Windows operating system on IBM PC compatible machines.

Radio-frequency (RF) photoinjector-based relativistic ultrafast electron diffraction (UED) is a promising new technique that has the potential to probe structural changes at the atomic scale with sub-100 fs temporal resolution in a single shot. We analyze the limitations on the temporal and spatial resolution of this technique considering the operating parameters of a standard 1.6 cell RF gun (which is the RF photoinjector used for the first experimental tests of relativistic UED at Stanford Linear Accelerator Center; University of California, Los Angeles; Brookhaven National Laboratory), and study the possibility of employing novel RF structures to circumvent some of these limits.

The ultrastructural study of rare cells within their niche in situ is very difficult. We have developed a method for locating individual transplanted cells and simultaneously identifying and analyzing the molecules and cellular phenotypes surrounding them in situ using transmission electron microscopy. This innovative method involves triple immunogold labeling combined with serial ultrathin sectioning. We demonstrate the validity of this approach by examining the niche of individual transplanted cells from a population highly enriched for hemopoietic stem cells and the ultrastructural expression of two key stem cell regulatory molecules, hyaluronic acid and osteopontin. In addition, we describe the phenotypes of the surrounding cells.

An in situ electron energy loss spectroscopy (EELS) technique has been developed to investigate the dynamic processes associated with electron-beam nanofabrication on thin membranes. In this article, practical applications germane to e-beam nanofabrication are illustrated with a case study of the drilling of nanometer-sized pores in silicon nitride membranes. This technique involves successive acquisitions of the plasmon-loss and the core-level ionization-loss spectra in real time, both of which provide the information regarding the hole-drilling kinetics, including two respective rates for total mass loss, individual nitrogen and silicon element depletion, and the change of the atomic bonding environment. In addition, the in situ EELS also provides an alternative method for endpoint detection with a potentially higher time resolution than by imaging. On the basis of the time evolution of in situ EELS spectra, a qualitative working model combining knock-on sputtering, irradiation-induced mass transport, and phase separation can be proposed.

A comprehensive electron energy-loss spectroscopy study of niobium (Nb) and stable Nb-oxide phases (NbO, NbO2, Nb2O5) was carried out. In this work (Part I), the plasmons and energy-loss near-edge structures (ELNES) of all relevant Nb edges (Nb-N2,3, Nb-M4,5, Nb-M2,3, Nb-M1, and Nb-L2,3) up to energy losses of about 2600 eV and the O-K edge are analyzed with respect to achieving characteristic fingerprints of Nb in different formal oxidation states (0 for metallic Nb, +2 for NbO, +4 for NbO2, and +5 for Nb2O5). Chemical shifts of the Nb-N2,3, Nb-M4,5, Nb-M2,3, and Nb-L2,3 edges are extracted from the spectra that amount to about 4 eV as the oxidation state increases from 0 for Nb to +5 for Nb2O5. Four different microscopes, including a 200 keV ZEISS Libra with monochromator, were used. The corresponding wide range of experimental parameters with respect to the primary electron energy, convergence, and collection semi-angles as well as energy resolution allows an assessment of the influence of the experimental setup on the ELNES of the different edges. Finally, the intensity of the Nb-L2,3 white-line edges is correlated with niobium 4d-state occupancy in the different reference materials.

This article discusses the results of transmission electron microscopy (TEM)-based characterization of strontium-doped lead zirconate titanate (PSZT) thin films. The thin films were deposited by radio frequency magnetron sputtering at 300°C on gold-coated silicon substrates, which used a 15 nm titanium adhesion layer between the 150 nm thick gold film and (100) silicon. The TEM analysis was carried out using a combination of high-resolution imaging, energy filtered imaging, energy dispersive X-ray (EDX) analysis, and hollow cone illumination. At the interface between the PSZT films and gold, an amorphous silicon-rich layer (about 4 nm thick) was observed, with the film composition remaining uniform otherwise. The films were found to be polycrystalline with a columnar structure perpendicular to the substrate. Interdiffusion between the bottom metal layers and silicon was observed and was confirmed using secondary ion mass spectrometry. This occurs due to the temperature of deposition (300°C) being close to the eutectic point of gold and silicon (363°C). The diffused regions in silicon were composed primarily of gold (analyzed by EDX) and were bounded by (111) silicon planes, highlighted by the triangular diffused regions observed in the two-dimensional TEM image.

Several species of the chain-forming marine diatom genus Pseudo-nitzschia produce domoic acid (DA), a neuroexcitant amino acid, responsible for a human amnesic syndrome after consumption of toxified shellfish (ASP). Since 1995, the Portuguese monitoring program has regularly detected the presence of DA in shellfish. So far only P. australis has been implicated, and references therein. Identification of the causative species of Pseudo-nitzchia in natural samples is hampered by difficulties in identification at the light microscope level. Recent studies have shown that ultrastructural details of the wall, observed by transmission electron microscopy, allow the identification of species in good agreement with the phylogenetic and biological species concept.