Hostname: page-component-76fb5796d-skm99 Total loading time: 0 Render date: 2024-04-26T08:11:39.147Z Has data issue: false hasContentIssue false
  • English
  • Français

Synthesis and dielectric properties of tungsten-based complex perovskites

Published online by Cambridge University Press:  31 January 2011

D.D. Khalyavin ,
Jiaping Han ,
A.M.R Senos  and
P.Q. Mantas
D.D. Khalyavin
Affiliation:
Department of Ceramics and Glass Engineering, CICECO, University of Aveiro, 3810-193 Aveiro, Portugal
Jiaping Han
Affiliation:
Department of Ceramics and Glass Engineering, CICECO, University of Aveiro, 3810-193 Aveiro, Portugal
A.M.R Senos
Affiliation:
Department of Ceramics and Glass Engineering, CICECO, University of Aveiro, 3810-193 Aveiro, Portugal
P.Q. Mantas*
Affiliation:
Department of Ceramics and Glass Engineering, CICECO, University of Aveiro, 3810-193 Aveiro, Portugal
*
bAddress all correspondence to this author. e-mail: pmantas@cv.ua.pt
Get access

Abstract

Ba2MeWO6 (Me=Mg, Ni, Zn) double perovskites were prepared by the conventional solid-state reaction in a wide temperature range. Single-phase ceramics were obtained only at low temperatures approximately 1200°C, whereas a small amount of second phases existed in the samples sintered at higher temperatures. All the compounds are characterized by the cubic perovskite structure (space group Fm3m) with a complete NaCl type ordering between B-site ions. Anomalous temperature variation of the dielectric loss tangent found in the Ba2NiWO6 perovskite is supposed to be connected with a dielectric relaxation due to electronic hopping within thermally activated Ni3+-6W(6-1/6)+/W5+-6Ni(2+1/6)+ clusters. Dielectric measurements showed that the other two perovskites—Ba2ZnWO6 and Ba2MgWO6—exhibit a positive value of the temperature coefficient of permittivity. Such temperature variation is assumed to be caused by a considerable influence of the second polar mode involving B-site ion vibrations on the low-frequency dielectric properties.

Type
Articles
Information
Journal of Materials Research , Volume 18 , Issue 11 , November 2003 , pp. 2600 - 2607
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Nomura, S., Toyama, K., and Kaneta, K., Jpn. J. Appl. Phys. 21, L624 (1982).CrossRefGoogle Scholar
2.Kawashima, S., Nishida, M., Ueda, I., and Ouchi, H., J. Am. Ceram. Soc. 66, 421 (1983).CrossRefGoogle Scholar
3.Desu, S.B. and O'Bryan, H.M., J. Am. Ceram. Soc. 68, 546 (1985).CrossRefGoogle Scholar
4.Davies, P.K., Tong, J., and Negas, T., J. Am. Ceram. Soc. 80, 1727 (1997).CrossRefGoogle Scholar
5.Akbas, M.A. and Davies, P.K., J. Am. Ceram. Soc. 81, 670 (1998).CrossRefGoogle Scholar
6.Zurmühlen, R., Petzelt, J., Kamba, S., Kozlov, G., Volkov, A., Gorshunov, B., Dube, D., Tagantsev, A., and Setter, N., J. Appl. Phys. 77, 5351 (1995).CrossRefGoogle Scholar
7.Zurmühlen, R., Colla, E., Dude, D.C., Petzelt, J., Reaney, I., Bell, A., and Setter, N., J. Appl. Phys. 76, 5864 (1994).CrossRefGoogle Scholar
8.Takahashi, H., Ayusawa, K., and Sakamoto, N., Jpn. J. Appl. Phys. 36, 5597 (1997).CrossRefGoogle Scholar
9.Reaney, I.M., Colla, E.L., and Setter, N., Jpn. J. Appl. Phys. 33, 3984 (1994).CrossRefGoogle Scholar
10.Muller, O. and Roy, R., The Major Ternary Structural Families (Springer Verlag, Berlin, Germany, 1974).CrossRefGoogle Scholar
11.Wersing, W. in Electronic Ceramics, Steele, B.C.H. (Elsevier Science Publishing, New York, 1991), pp. 67–119.Google Scholar
12.Perry, C.H., McCarthy, D.J., and Pupprecht, G., Phys. Rev. 138, A1537 (1965).CrossRefGoogle Scholar
13.Harrop, P.J., J. Mater. Sci. 4, 370 (1960).CrossRefGoogle Scholar