Hostname: page-component-848d4c4894-2xdlg Total loading time: 0 Render date: 2024-06-29T09:16:50.207Z Has data issue: false hasContentIssue false

Composition dependence of morphology, structure, and thermoelectric properties of FeSi2 films prepared by sputtering deposition

Published online by Cambridge University Press:  31 January 2011

Tatsuo Tsunoda
Affiliation:
Department of Inorganic Materials, National Institute of Materials and Chemical Research, Higashi 1–1, Tsukuba, Ibaraki 305, Japan
Masakazu Mukaida
Affiliation:
Department of Inorganic Materials, National Institute of Materials and Chemical Research, Higashi 1–1, Tsukuba, Ibaraki 305, Japan
Akio Watanabe
Affiliation:
Department of Inorganic Materials, National Institute of Materials and Chemical Research, Higashi 1–1, Tsukuba, Ibaraki 305, Japan
Yoji Imai
Affiliation:
Department of Inorganic Materials, National Institute of Materials and Chemical Research, Higashi 1–1, Tsukuba, Ibaraki 305, Japan
Get access

Abstract

Direct β–FeSi2 film preparation from gaseous phase was examined using a radio-frequency (rf) sputtering deposition apparatus equipped with a composite target of iron and silicon. Films composed of only β–FeSi2 phase were formed at substrate temperatures above 573 K when the chemical composition of the film was very close to stoichiometric FeSi2. The β–FeSi2 films thus formed showed rather large positive Seebeck coefficient. When the chemical composition of the films were deviated to the Fe-rich side, ∈–FeSi phase was formed along with β–FeSi2. On the other hand, α–FeSi2 phase, which is stable above 1210 K in the equilibrium phase diagram, was formed at the substrate temperature as low as 723 K when the chemical composition was deviated to the Si-rich side. The formation of α–FeSi2 phase induced drastic changes in the morphology and thermoelectric properties of the films. The α–FeSi2 phase formed in the films was easily transformed to β–FeSi2 phase by a thermal treatment.

Type
Articles
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Birkholz, U. and Scelm, J., Phys. Status Solidi 27, 413 (1968).CrossRefGoogle Scholar
2.Kojima, T., Phys. Status Solidi (a) 111, 233 (1989).CrossRefGoogle Scholar
3.Nishida, I., Zairyou Kagaku 15, 72 (1978), and references therein.Google Scholar
4.von Kanel, H., Onda, N.Sirringhaus, H., Muller-Gubler, E., Goncalves-Conto, S., and Schwarz, C., Appl. Surf. Sci. 70/71, 559 (1993).CrossRefGoogle Scholar
5.Konuma, K., Vrijmoeth, J., Zagwijn, P.M., Frenken, J.W.M., Vlieg, E. and van der Veen, J.F., J. Appl. Phys. 73 (3), 1104 (1993).CrossRefGoogle Scholar
6.Raunau, W., Niehus, H., Schilling, T., and Cosma, G., Surf. Sci. 286, 203 (1993).CrossRefGoogle Scholar
7.Lin, X. W., Behar, M., Desimoni, J., Bernas, H., Washburn, J., and Liliental-Weber, Z., Appl. Phys. Lett. 63, 105 (1993).CrossRefGoogle Scholar
8.Mahan, J. E., Thanh, V.Le., Chevrier, J., Berbezier, I., Derrien, J., and Long, R. G., J. Appl. Phys. 74, 1747 (1993).CrossRefGoogle Scholar
9.Vazquez de Parga, A. L., de la Figuera, J., Prieto, J. E., Ocal, C., and Miranda, R., Appl. Phys. A 57, 477 (1993).CrossRefGoogle Scholar
10.Matsubara, K., Koyanagi, T., and Takagi, T., Proc. 6th Int. Conf. Thermoelectric Energy Conversion (IEEE, New York, 1986), p. 16.Google Scholar
11.Sorimachi, Y., Honda, K., Tsubata, I., Ichinose, Y., and Miyauchi, S., '90 Int. Electron. Manufact. Technol. Symp. 8, 414418 (1990).Google Scholar
12.Kobayashi, M., Hijikata, K., and Ido, S., Jpn. J. Appl. Phys. 29 (6), 1118 (1990).CrossRefGoogle Scholar
13.Gmelins Handbuch der anorg. Chemie 35 Teil B (Verlag Chemie GmbH, Berlin, 1934), p. 84.Google Scholar
14.Gmelins Handbuch der anorg. Chemie 59 Teil AII (Verlag Chemie GmbH, Berlin, 1934), p. 1753.Google Scholar
15.Kubaschewski, O., Iron-Binary Phase Diagrams (Springer-Verlag, Berlin, 1982), p. 136.Google Scholar