Hostname: page-component-848d4c4894-wg55d Total loading time: 0 Render date: 2024-04-30T13:40:01.804Z Has data issue: false hasContentIssue false
  • English
  • Français

Experimental investigation on wall pressure distribution in flaps’ separating regions

Published online by Cambridge University Press:  03 February 2016

P. F. Zhang ,
J. J. Wang  and
Y. C. Li
P. F. Zhang
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
J. J. Wang
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
Y. C. Li
Affiliation:
Institute of Fluid Mechanics, Beijing University of Aeronautics and Astronautics, Beijing, Peoples Republic of China
Get access Rights & Permissions [Opens in a new window]

Abstract

The effects on the wall pressure of the plate caused by the introduction of a gap near the ground and the flaps were investigated experimentally. The mean pressure on the plate surface was found to decrease with the size changing of the gap near the ground when the gap size (g) is larger than the flap height (h), but the one in the recirculation region increase with the size of the gap when the gap size is about 0 ≤ g ≤ 2h. Three kinds of flow structure appear with increasing the gap sizes, and the transit point is at g/h = 0·2, 0·8 respectively. For the zigzag flap (d/h = 0·19, d is the height of the zigzag), the variation of wall pressure with g/h is similar to the flat flap in general. The zigzag affects the mean wall pressure in the region of 0 ≤ x/h ≤ 20 (the recirculation zone) and can decrease the fluctuating pressure in the region of x/h > 20 downstream.

Type
Research Article
Information
The Aeronautical Journal , Volume 108 , Issue 1080 , February 2004 , pp. 103 - 107
Copyright
Copyright © Royal Aeronautical Society 2004 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Bradley, E.F. and Mulhearn, P.J. Development of velocity and shear stress distributions in the wake of a porous shelter fence. J Wind Eng and Industrial Aero, 1983, 15, (1), pp 145–156.Google Scholar
2. Rangaraju, K.G., Garde, R.J., Singh, S.K. and Singh, N. Experimental study on characteristics of flow past porous fences. J Wind Eng and Industrial Aero, 1988, 29, (1), pp 155–163.Google Scholar
3. Yaragal, S.C., Govinda, H.S. and Murthy, K.K. An experimental investigation of flow fields downstream of solid and porous fences. J Wind Eng and Industrial Aero, 1997, 66, (1), pp 127–140.Google Scholar
4. Lee, S.J. and Kim, H.B. Laboratory measurements of velocity and turbulence field behind porous fences. J Wind Eng and Industrial Aero, 1999, 80, (2), pp 311–326.Google Scholar
5. Fang, F.M. and Wang, D.Y. On the flow around a vertical porous fence. J Wind Eng and Industrial Aero, 1997, 66/68, (4), pp 415–424.Google Scholar
6. Yeung, W.W.H., Xu, C. and Gu, W.D. Reduction of transient adverse effect of spoilers. J Aircr, 1997, 34, (4), pp 479–484.Google Scholar
7. Yeung, W.W.H. and Xu, C. Separated flows around spoilers and forward-facing flaps. J Aircr, 1998, 35, (1), pp 53–59.Google Scholar
8. Harvey, J.K. and Perry, F.J. Flowfield produced by trailing vortices in the vicinity of the ground, AIAA J, 1971, 9, (8), pp 1659–1660.Google Scholar