Hostname: page-component-76fb5796d-zzh7m Total loading time: 0 Render date: 2024-04-26T20:29:14.480Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of Si Addition on Microstructure and Mechanical Properties of Dual Two-Phase Intermetallic Alloys Based on the Ni3Al-Ni3V Pseudo-Binary Alloy System

Published online by Cambridge University Press:  02 February 2015

Yuki Hamada ,
Yasuyuki Kaneno ,
Hiroshi Numakura  and
Takayuki Takasugi
Yuki Hamada
Affiliation:
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan.
Yasuyuki Kaneno
Affiliation:
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan.
Hiroshi Numakura
Affiliation:
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan.
Takayuki Takasugi
Affiliation:
Department of Materials Science, Graduate School of Engineering, Osaka Prefecture University, Sakai 599-8531, Japan.
Get access

Abstract

The effect of Si addition on microstructure and mechanical properties of dual two-phase intermetallic alloys was investigated. Si was added to the base alloy composition Ni75Al9V13Nb3 + 50 wt. ppm B by three substitution ways in which Si was substituted either for Ni, for Al and for V, respectively. The alloys added with 1 at.% Si showed a dual two-phase microstructure composed of Ni3Al (L12) and Ni3V (D022) phases, while the alloys added with over 2 at.% Si exhibited the same dual two-phase microstructure but contained third phases. The third phases were G phase (Ni16Si7Nb6) and A2 phase (the bcc solid solution consisting of Nb and V). Yield and tensile strength of the 1 at.% Si-added alloys were high in the alloy in which Si was substituted for Al but low in the alloys in which Si was substituted for Ni or for V, in comparison with those of the base alloy. Tensile elongation was lower than that of the base alloy irrespective of substitution ways. The density of the Si added alloys was close to or slightly lower than that of the base alloy. Oxidation resistance of the Si added alloy was increased. Si addition to the dual two-phase intermetallic alloys is beneficial for reducing the density and enhancing the oxidation resistance without a harmful reduction of strength properties.

Keywords

NiAlSi
Type
Articles
Information
MRS Online Proceedings Library (OPL) , Volume 1760: Symposium YY – Advanced Structural and Functional Intermetallic-Based Alloys , 2015 , mrsf14-1760-yy05-14
Copyright
Copyright © Materials Research Society 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

van Vucht, J. H. N., Less-Common Met., 11 (1996) 308–322.CrossRefGoogle Scholar
Sinha, A. K., Trans. Met. Soc. AIME., 245 (1969) 911–917.Google Scholar
Sinha, K., Prog. Mater. Sci. Part 2, 15 (1972) 81–185.CrossRefGoogle Scholar
Pope, D. P., Ezz, S. S., Int.Mater. Rev., 29 (1984) 136–167.CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Yoshida, M., Takasugi, T., Acta Mater., 54 (2006) 861–870.CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Yoshida, M., Shishido, T., Takasugi, T., Intermetallics, 15 (2007) 119–127.CrossRefGoogle Scholar
Shibuya, S., Kaneno, Y., Tsuda, H., Takasugi, T., Intermetallics, 15 (2007) 338–348.CrossRefGoogle Scholar
Nunomura, Y., Kaneno, Y., Takasugi, T., Intermetallics, 12 (2004) 389–399.CrossRefGoogle Scholar
Nunomura, Y., Kaneno, Y., Tsuda, H., Takasugi, T., Acta Mater., 54 (2006) 851–860.CrossRefGoogle Scholar
Kawahare, K.. Kaneno, Y.. Takasugi, T., Intermetallics, 17 (2009) 938–944.CrossRefGoogle Scholar
Kawahara, K., Moronaga, T., Kaneno, Y., Kakitsuji, A., Takasugi, T., Materials Transactions, 51 (2010) 1395–1403.CrossRefGoogle Scholar
Moronaga, T., Ishii, S., Kaneno, Y., Tsuda, H., Takasugi, T., Mater. Sci. Eng. A, 539 (2012) 30–37.CrossRefGoogle Scholar
Ochiai, S., Oya, Y. and Suzuki, T., Acta Metall, 32 (1984) 289–298.CrossRefGoogle Scholar
Eremenko, V. N., Prima, S. B. and Tretyachenko, L. A., Powder Metallurgy and Metal Ceramics, 30 (1991) 486–491.Google Scholar