Electrophoretic mobility of imogolite has been reported as positive (migration toward the negative electrode) below pH 9, and zero above pH 9. However, when mobility of dilute imogolite suspensions (5 × 10−3 kg/m3) was measured, it was found to be negative above pH 9. The reason that imogolite does not behave as a negative colloid when the clay concentration is not very dilute is because the imogolite forms floccules large enough to prevent migration. Imogolite has a PZNC at about pH 6, and has a PZC at pH 8.5–9.0 showing a relatively low absolute mobility under alkaline conditions compared to that under acid conditions. The fact that imogolite behaves like this is understandable given the location of negative charge appearing on the inside surface of the thin fibrous tube, according to the structural model of imogolite.

Decomposition of complex X-ray diffraction profiles is used on well characterized (image analysis of transmission electron micrographs, X-ray fluorescence chemical analyses) diagenetic samples from the Paris basin. The simultaneous occurrence of three “illitic” phases (mixed-layer illite/smectite or I/S, poorly crystallized illite, and mica-like phase) is shown on the various diffraction peaks of the 2–50 °2θ CuKα (44–1.8 Å) range. However, because of theoretical and experimental constraints, it is easier to perform the decomposition routine in the 5–11 °2θ CuKα (17.6–8.0 Å) range. The identification (i.e., illite content and mean coherent scattering domain size) of the various phases is performed by comparing the associated elementary peak characteristics (position, full width at half maximum intensity) with simulated X-ray patterns. When available, the characteristics obtained from the various angular regions are mutually consistent; however, the precise structures of smectite and illite end-members, on the one hand, and the structure of I/S crystallites, on the other hand, are not well known. Consequently, on some angular regions, there is a discrepancy between the characteristics obtained on experimental and calculated X-ray profiles. The definition of more realistic simulation hypotheses for I/S minerals, and for other interstratified clay minerals, would make this powerful and reliable tool to describe X-ray patterns a precise and sensitive identification tool even for complex clay parageneses.

Electroacoustic measurements at 1 MHz, using the Electro-Sonic Amplitude (ESA), on a kaolinite suspension provide a ready method for following the adsorption of hydrolyzable metal ions onto the clay surface. Co2+, Cd2+ and Cu2+ ions show similar behavior: The initially negative surface becomes less negative, approaches zero, and may become positive at pH values around neutral, depending on the initial metal concentration. At higher pH, electrokinetic potential goes through a maximum. If the surface has become positive, it becomes less so; and at still higher pH values it may become negative again, depending on the metal ion concentration. The behavior can be interpreted using the model proposed by James and Healy.

Batch reactor experiments were performed at 150°C, 175°C, and 200°C to determine the effect of high pH NaOH solutions on the mineralogy of the Opalinus shale. In these experiments, the change in solution quench pH at 25°C, solution composition, and mineralogy were monitored as a function of time for up to ≈40 days. Runs were performed in 50 ml titanium hydrothermal reactor vessels. Each reactor was charged with 0.5–5.0 g of the 80–200 mesh size fraction of Opalinus shale, and 25 ml of solution (0.1 and 0.01 M NaOH). The general sequence of reaction products observed under these high pH conditions include first the formation of analcime, followed by vermiculite, and finally Na-rectorite formation.

The oxidation state of structural iron greatly influences the physical-chemical properties of clay minerals, a phenomenon that may have significant implications for pollutant fate in the environment, for agricultural productivity, and for industrial uses of clays. Knowledge of redox mechanisms is fundamental to understanding the underlying basis for iron's effects on clays. Past studies revealed that the extent of Fe reduction varied depending on the reducing agent used, but this variation may not have been a simple function of the reduction potential of the reducing agent. The objective of this study was to identify the relationship between the Fe reduction mechanism and free radical activity in the reducing agent. Several reducing agents and their mixtures with the Na-saturated, 0.5 to 2 μm size fraction of ferruginous smectite (SWa-1) were analyzed by electron spin resonance (ESR) spectroscopy to determine the presence of unpaired electrons or free radicals. Only Na2S2O4 exhibited paramagnetic free-radical behavior with a signal at about g = 2.011, which was attributed to the sulphoxylate (S02− ·) free radical. The free radical was labile in aqueous solution, and the ability of Na2S2O4 solution to reduce structural Fe in the smectite decreased with age of the solution and paralleled the disappearance of the free radical signal in the ESR spectrum. The paramagnetic species was preserved and enhanced if Na2S2O4 was added to the clay suspension, indicating that either the clay surface stabilized the SO2− · radical or the additional unpaired electrons were produced in the clay structure.

Experimental alteration of volcanic glass has been carried out in distilled water at 200°C and 150°C. The formation and transformation processes of alteration products have been examined by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray powder diffraction (XRD), infrared absorption analysis, and X-ray photoelectron spectroscopy. SEM and TEM clearly show that amorphous aluminum-silicate coatings with allophane particles precipitate on the surface of volcanic glass during the earliest alteration stage. Noncrystalline flaky and/or fibrous materials are formed from the allophane aggregates and from the amorphous coatings as new reaction products. The flaky and/or fibrous materials curl inward and transform into 100–500 nm circular smectite. The Al/Si atomic ratio of 1.09 for allophane decreases progressively to 0.65 for smectite through 0.86 for noncrystalline transitional material. The smectite has d(06) spacing of 1.497 Å and consists mainly of Si, Al, and small amounts of Fe, Ca, and Na.

X-ray diffraction of four natural samples of ferrihydrite indicates the presence of crystalline domains within the primary particles. The average diameter of the primary particles (determined from low-angle powder patterns) decreases from 4.1 nm to 2.5 nm as the domain size in the xy-plane (determined by applying the Scherrer equation to the broad [110] XRD peak at 0.26–0.27 nm) decreases from 1.0 nm to 0.77 nm. The Si content (measured by acid-oxalate extraction) increases from 4.1% to 6.1% as both the domain and particle sizes decrease; other factors, however, are likely to be important in influencing particle size. For one sample of ferrihydrite, the smallest possible domain (i.e., c = 0.94 nm in the z-direction) contains 36 O atoms and three Si atoms. A model for ferrihydrite is suggested in which silicate bonds to, and bridges, the surfaces of the domains. The model can account for several aspects of the behavior of siliceous ferrihydrites.

Shales have often been cited as the source of authigenic material that occurs in coarser grained sediments, but there are few comprehensive studies of diagenesis in shales that rigorously attempt to determine if they are sources for potentially mobile constituents or if they retain those constituents within the shale body. The silicate diagenesis of a Lower Cretaceous marine mudstone, the Harmon Member, was investigated by determining the bulk chemistry, clay mineral compositions and mineral modes using standard analytical techniques and linear programming. Changes in mineralogy are observed in hemipelagic laminated mudstones (LM) that are attributable to diagenesis despite relatively constant bulk compositions. These include authigenic kaolinite formation and illitization of detrital muscovite, K-feld-spar and authigenic kaolinite. No diagenetic trends in mineralogy are observed in rapid and episodically deposited transition zone (TZ) sediments because of primary (depositional) mineralogical variability. Diagenetic changes in mineral modes for shales of the Harmon Member are small, suggesting that silicate diagenesis proceeds under relatively “closed system” conditions. The occurrence of authigenic quartz suggests that much of the Si released from the dissolution of quartz and chert is precipitated within the Harmon Member. Al, Ti, and K apparently are conserved. Burial induced increase in temperature is inferred to be the primary control on silicate diagenesis within the Harmon Member.

Noncrystalline aluminosilicates termed allophane and imogolite are common constituents of spodosols, soils derived from volcanic ash, and many inceptisols. The surface charge characteristics of their synthetic analogues may be used to better understand their ion retention properties. In this study, we determined the point of zero salt effect (PZSE) by potentiometric titration of allophanes with Al/Si ratios of 1.12, 1.52, and 2.04 and of imogolite with an Al/Si ratio of 2.02. We also used microelectrophoresis to determine the point of zero charge (PZC) at the particle shear plane for the same materials in CI solutions of Li, Na, Cs, and tetramethyl ammonium. The PZSE decreased with decreasing Al/Si ratio for the allophanes, but the imogolite PZSE was much lower than that of the allophane with 2.04 Al/Si. The PZC was always higher than the PZSE of the same material, especially for imogolite. The results are best explained if cations reside within the hollow tubes of imogolite. This conclusion is supported by a fluorescence study that showed that only quenchers smaller than the inner diameter of the imogolite tube could fully quench Ce-imogolite.

Silcretes developed within the in situ regolith in the Barr Smith Range, Western Australia, were investigated using optical and electron-beam techniques. One of the cementing agents in these silcretes showed gel-like optical properties and had a variable aluminosilicate chemical composition at the scale of electron microprobe analysis so that it might be considered as allophane-like material. High resolution transmission electron microscopy demonstrated that the material consists of a fine-grained and poorly ordered kaolinite embedded in a matrix of amorphous silica.

Interaction of water with montmorillonite exchanged with Na+, K+, Co2+, and Cu2+ cations as a function of water content was examined using an FTIR/gravimetric cell designed to collect spectroscopic and sorption data simultaneously. Correlation of water desorption isotherms with infrared spectra of the clay-water complex showed that the position of the HOH bending band of water decreased as a function of water content. The largest decreases in frequency were observed for Cu2+ and Co2+; smaller decreases were found for Na+ and K+. In addition, the molar absorptivity of sorbed water increased upon decreasing the water content. The decrease in frequency and the concomitant increase in molar absorptivity were attributed to polarization effects on the sorbed water molecules by exchangeable cations. The interference fringes of a self supporting clay film permitted d-spacings to be determined optically and, therefore, changes in frequency, molar absorptivity, and water sorption behavior to be related directly to changes in interlayer spacing. The d-spacings obtained from the interference fringes were consistently larger by approximately 0.5 Å than those determined using powder XRD.

The objectives of the study were to determine the chemical composition and layer charge of smectite found in calcareous till of the Interior Plains region of western Canada and to examine the effects of acidification on alteration of the smectite. Samples of acidified and non-acidified (calcareous) late-Wisconsin till were obtained from four soil pits located immediately adjacent to an elemental sulfur block located in southern Alberta. Samples of the surface material (0–10 cm depth) had been subjected to extreme acidity for 25 years due to the oxidation of elemental sulfur and displayed pH values of about 2.0. Samples of the till obtained at depth (65–75 cm) remained calcareous with pH values between 7.3 and 7.6. A combination of analytical methods was used to determine the chemical composition of the smectite found in the samples. The layer charge of the smectite was determined independently using X-ray diffraction data for n-alkylammoniurn saturated specimens. Smectite found in the non-acidified calcareous material was characteristic of montmorillonite with a low content of Fe and very little substitution of Al for Si in the tetrahedral sheet. The smectite had a structural formula of M+0.40(Si3.96Al0.04)(Al1.56Fe3+0.10Mg0.33)O10(OH)2, which compared well with a mean value for layer charge of 0.399 mol(−)/O10(OH)2 determined using X-ray diffraction data for n-alkylammonium treated specimens. Smectite remaining in the till material subjected to extreme acidity underwent incongruent dissolution with a net loss of layer charge and preferential loss of octahedral Mg.