Hostname: page-component-848d4c4894-2xdlg Total loading time: 0 Render date: 2024-07-01T17:34:07.506Z Has data issue: false hasContentIssue false

Ultra Low-K Inorganic Silsesquioxane Films with Tunable Electrical and Mechanical Properties

Published online by Cambridge University Press:  17 March 2011

Thomas A. Deis
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Chandan Saha
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Eric Moyer
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Kyuha Chung
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Youfan Liu
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Mike Spaulding
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
John Albaugh
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Wei Chen
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Jeff Bremmer
Affiliation:
Dow Corning Corporation, Midland, MI 48611, U.S.A
Get access

Abstract

Low-k dielectric films have been developed using a new silsesquioxane based chemistry that allows both the electrical and mechanical properties to be tuned to specific values. By controlling the composition and film processing conditions of spin-on formulations, dielectric constants in the range 1.5 to 3.0 are obtained with modulus values that range from 1 to 30 GPa. The modulus and dielectric constant are tuned by controlling porosity, which varies from 0 to >60%, and final film composition which varies from HSiO3/2 to SiO4/2. The spin-on formulation includes hydrogen silsesquioxane resin and solvents. Adjusting the ratio of solvents to resin in the spin-on formulation controls porosity. As-spun films are treated with ammonia and moisture to oxidize the resin and form a mechanically self-supporting gel. Solvent removal and further conversion to a more “silica-like” composition occur during thermal curing at temperatures of 400 to 450°C. The final film composition was controlled through both room temperature oxidation and thermal processing. Final film properties are optimized for a balance of electrical, mechanical and thermal properties to meet the specific requirements of a wide range of applications. Processed films exhibit no stress corrosion cracking or delamination upon indentation, with indenter penetration exceeding the film thickness, and followed by exposure to water at room temperature. Films also exhibit high adhesive strength (> 60MPa) and low moisture absorption. Processing conditions, composition and properties of thin are discussed.

Type
Research Article
Copyright
Copyright © Materials Research Society 2000

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)