Hostname: page-component-7c8c6479df-27gpq Total loading time: 0 Render date: 2024-03-19T08:07:37.540Z Has data issue: false hasContentIssue false

Surface Passivation of p-GaTe Layered Crystals for Improved p-GaTe/n-InSe Heterojunction Solar Cells

Published online by Cambridge University Press:  01 February 2011

Krishna C. Mandal
Affiliation:
mandalk@cec.sc.edu, University of South Carolina, Department of Electrical Engineering, Columbia, South Carolina, United States
Sandip Das
Affiliation:
mandalk@cec.sc.edu, University of South Carolina, Department of Electrical Engineering, Columbia, South Carolina, United States
Ramesh Krishna
Affiliation:
krishna@email.sc.edu, University of South Carolina, Department of Electrical Engineering, Columbia, South Carolina, United States
Peter G. Muzykov
Affiliation:
muzykovp@cec.sc.edu, University of South Carolina, Department of Electrical Engineering, Columbia, South Carolina, United States
Shuguo Ma
Affiliation:
mas@engr.sc.edu, University of South Carolina, Nanocenter, Columbia, South Carolina, United States
Feng Zhao
Affiliation:
zhaof2@cec.sc.edu, University of South Carolina, Department of Electrical Engineering, Columbia, South Carolina, United States
Get access

Abstract

GaTe and GaTe:In single crystals were grown from high purity Ga (7N) and zone refined Te (>7N) precursor materials. InSe thin films were deposited by thermal evaporation onto the sulfur passivated GaTe:In substrates at various substrate temperatures from 450K-550K to fabricate p-GaTe:In/n-InSe heterojunction solar cells. Scanning electron microscopy (SEM), X-ray diffraction (XRD), electron probe microanalysis (EPMA), and X-ray photoelectron spectroscopy (XPS) were used to characterize GaTe:In crystals and InSe thin film surfaces. The current-voltage characteristics of p-GaTe:In/n-InSe solar cells were measured under dark and under illumination of 75mW/cm2. Dark J-V measurements showed that the reverse saturation current density (J0) decreased from 3.8 x 10-6 A/cm2 to 1.5 x 10-9 A/cm2 and the ideality factor was reduced from 2.04 to 1.15 as a result of surface passivation. Under illumination of 75 mW/cm2, the open-circuit voltage (Voc) increased from 0.54V to 0.68V and short-circuit current density (Jsc) increased from 7.19 mA/cm2 to 8.65 mA/cm2 for solar cells with surface passivated GaTe:In substrates, leading to an increased solar cell efficiency of 5.03%. EPMA measurements revealed that the InSe thin films deposited at 550 K on GaTe:In substrates were near stoichiometric with enhanced grain size contributing also to better solar cell performance.

Type
Research Article
Copyright
Copyright © Materials Research Society 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Mandal, K. C., Kang, S., Choi, M., Chen, J., Zhang, X.-C., Schleicher, J., Schmuttenmaer, C., and Fernelius, N. C., IEEE J. Selected Topics in Quantum Electron., 14, 284 (2008).Google Scholar
[2] Nelson, A.J., Conway, A.M., Strum, B.W., Behymer, E.M., Reinhardt, C.E., Nikolic, R.J., Payne, S.A., Pabst, G., and Mandal, K.C., J. Appl. Phys., 106, 023717 (2009).Google Scholar
[3] Xu, G., Sun, G., Ding, Y. J., Zotova, I. B., Mandal, K. C., Mertiri, A., Pabst, G., and Fernelius, N.C., IEEE J. Selected Topics in Quantum Electronics, (2010) in press.Google Scholar
[4] Mandal, K. C., Choi, M., Kang, S. H., Raugh, R.D., Wei, J., Zhang, H, Zheng, L., Cui, Y., Groza, M., and Burger, A., Proc. SPIE, 6706, 67060E (2007).Google Scholar
[5] Mandal, K. C., Mertiri, A., Pabst, G., Roy, R., Cui, Y., Bhattacharya, P., Groza, M., Burger, A., Conway, A., Nikolic, R. J., Nelson, A.J., and Payne, S.A., SPIE, 7079, 70790O (2007).Google Scholar
[6] Bose, D.N. and Pal, S., Philos. Mag. B, 75, 311 (1997).Google Scholar
[7] Mandal, K.C., Kang, S.H., and Choi, M., Proc. MRS, 969, 111 (2007).Google Scholar
[8] Rak, Zs, Mahanti, S.D., Mandal, Krishna C., and Fernelius, N. C., J. Phys.: Condens. Mater., 21, 015504 (2009).Google Scholar
[9] Nelson, R.J., Williams, J.S., Leamy, H.J., Miller, B., Casey, H.C., Parkinson, B.A., and Hiller, A., Appl. Phys. Lett., 36, 76 (1980).Google Scholar
[10] Mandal, K.C., Basu, S., and Bose, D.N., J. Phys. Chem., 97, 4011 (1987).Google Scholar
[11] Hoffmann, J, Lehnert, T, Hoffmann, D, and Fouckhardt, H, Semicond. Sci. Technol., 24, 065008 (2009).Google Scholar
[12] Jin, P., Panb, S. H., Lib, Y., Zhang, C. Z., and Wang, Z. G., Appl. Surf. Sci., 218, 211 (2003).Google Scholar
[13] Bose, D.N., Basu, S., Mandal, K.C., and Mazumdar, D., Appl. Phys. Lett., 46, 472 (1986).Google Scholar
[14] Mandal, K. C., Basu, S., and Bose, D. N., J. Solid State Chem., 71, 559 (1987).Google Scholar
[15] Mandal, K. C., Basu, S., and Bose, D. N., Surface Science, 188, 235 (1987).Google Scholar
[16] Nelson, A.J., Laurence, T.A., Conway, A.M., Behymer, E.M., Strum, B.W., Voss, L.F., Nikolic, R.J., Payne, S.A., Mertiri, A., Pabst, G., Mandal, K.C., and Burger, A., Mater. Lett., 64, 393 (2010).Google Scholar
[17] Minder, R., Ottaviani, G., and Canali, C., J. Phys. Chem. Solids, 37, 417 (1976).Google Scholar
[18] Balitskii, O. A. and Jaegermann, W., Matter. Chem. Phys., 97, 98 (2006).Google Scholar