Hostname: page-component-848d4c4894-v5vhk Total loading time: 0 Render date: 2024-07-05T20:17:00.722Z Has data issue: false hasContentIssue false
  • English
  • Français

Simulation of the Organization of Heteroepitaxial Monolayer Islands Under Anisotropic Conditions

Published online by Cambridge University Press:  01 February 2011

Gajendra Pandey  and
Robert V. Kukta
Gajendra Pandey
Affiliation:
Department of Mechanical Engineering, State University of New York at Stony Brook, Stony Brook, NY 11794–2300, U.S.A.
Robert V. Kukta
Affiliation:
Department of Mechanical Engineering, State University of New York at Stony Brook, Stony Brook, NY 11794–2300, U.S.A.
Get access

Abstract

This paper addresses the effect of anisotropy on the organization of epitaxial islands deposited on a substrate. Focus is on in-plane anisotropies in surface stress and lattice mismatch between the film and substrate materials. Starting from a configuration where island sizes and position are random, evolution towards equilibrium through mass transport via condensation/evaporation is simulated. The effect of the degree of anisotropy is investigated. An efficient numerical method is obtained by reducing a model of square monolayer islands of finite size to point defects that interact through their elastic fields. Models for both the kinetics and energetics of the system are obtained by this reduction. It is found that the point source model is accurate for island separations larger than about 3 times the width of an island. Under isotropic conditions islands tend to form into hexagonal arrays, and as there is no preferred orientation of these arrays, defects analogous to grain boundaries in a crystalline material tend to arise. With anisotropy islands tend to align in particular directions. This is found to enhance organization in cases of modest anisotropy and cause islands to form into zigzagged lines in cases of high anisotropy.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 854: Symposium U – Stability of Thin Films and Nanostructures , 2004 , U3.7
Copyright
Copyright © Materials Research Society 2005

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Mo, Y. W., Savage, D. E., Swartzentruber, B. S., and Lagally, M. G., Phys. Rev. Lett. 65(8), 1020 (1990).Google Scholar
[2] Ross, F. M., Tersoff, J., and Tromp, R. M., Phys. Rev. Lett. 80 (5), 984 (1998).Google Scholar
[3] Floro, J. A., Sinclair, M. B., Chason, E., Freund, L. B., Twesten, R. D., Hwang, R. Q., and Lucadamo, G. A., Phys. Rev. Let. 84 (4), 701 (2000).Google Scholar
[4] Avery, A. R., Dobbs, H. T., Holmes, D. M., Joyce, B. A., and Vvedensky, D. D., Phys. Rev. Lett. 79(20), 3938 (1997).Google Scholar
[5] Liu, F., Li, Adam H., and Lagally, M. G., Phys. Rev. Lett. 87 (12), 126103(4), (2001).Google Scholar
[6] Alerhand, O. L., Vanderbilt, D., Meade, R.D., Joannopoulos, J. D., Phys. Rev. Lett. 61 (17), 1973 (1988).Google Scholar
[7] Tersoff, J., Phys. Rev. Lett. 74 (24), 4962 (1995).Google Scholar
[8] Tersoff, J., Phang, Y. H., Zhang, Z. and Lagally, M. G., Phys. Rev. Lett. 75 (14), 2730 (1995).Google Scholar
[9] Marchenko, V. I., and Parshin, A. Ya., Sov. Phys. JEPT 52 (1), 129 (1980).Google Scholar
[10] Kukta, R. V., Liu, P., and Kouris, D., J. Mech. Phys. Solids, 51, 2149 (2003)Google Scholar
[11] Gao, Y. F., Lu, W., and Suo, Z., Acta Materialia 50, 2297 (2002).Google Scholar