Hostname: page-component-76fb5796d-wq484 Total loading time: 0 Render date: 2024-04-25T13:25:20.434Z Has data issue: false hasContentIssue false

Modeling of a-Si:H Alloy Solar Cells on Textured Substrates

Published online by Cambridge University Press:  15 February 2011

M. Zeman
Affiliation:
Delft University of Technology - DIMES, P.O.Box 5053, 2600 GB Delft, The Netherlands, m.zeman@et.tudelft.nl
J. H. van den Berg
Affiliation:
Delft University of Technology - DIMES, P.O.Box 5053, 2600 GB Delft, The Netherlands, m.zeman@et.tudelft.nl
L. L. A. Vosteen
Affiliation:
Delft University of Technology - DIMES, P.O.Box 5053, 2600 GB Delft, The Netherlands, m.zeman@et.tudelft.nl
J. A. Willemen
Affiliation:
Delft University of Technology - DIMES, P.O.Box 5053, 2600 GB Delft, The Netherlands, m.zeman@et.tudelft.nl
J. W. Metselaar
Affiliation:
Delft University of Technology - DIMES, P.O.Box 5053, 2600 GB Delft, The Netherlands, m.zeman@et.tudelft.nl
R. E. I. Schropp
Affiliation:
Utrecht University, Debey Institute, P.O.Box, 80000, 3508 TA Utrecht, the Netherlands
Get access

Abstract

Computer modeling is used as a tool for determining current matching in hydrogenated amorphous silicon (a-Si:H) alloy tandem cells on textured substrates. The increasing complexity of a-Si:H based solar cells requires continuous extending and testing of the computer models which are used for their simulation. To take light scattering at the textured interfaces of the cell into account we developed a multi-rough-interface optical model GENPR02 which was used for calculating the absorption profiles in the solar cells. The results of a sensitivity study of the parameters of this optical model such as the scattering coefficients of the reflected and transmitted light and the dependence of scattered light on the in-going and out-going angle are presented. In order to simulate multi-junction solar cell as a complete device we implemented a novel model for tunnel/recombination junction (TRJ), which combines the trap assisted tunneling and enhanced carrier transport in the high field region of the TRJ.

The current matching conditions were determined both for a-Si:H and a-SiGe:H bottom cells, while the top cell was an a-Si:H cell. We investigated the influence of light scattering at the textured interfaces and of the thickness of the intrinsic layer of the bottom cell on the optimal ratio (i2/i1) between the thicknesses of the bottom (i2) and top (il) intrinsic layers in the current-matched cell. The results show that increasing amount of scattering at the textured interfaces leads to higher efficiencies and lower ratio (i2/i1) in the current-matched cell. The use of a-SiGe:H material in the bottom cell leads to higher efficiency and 3 to 4 times lower i2/i1 ratio than in case of a-Si:H/a-Si:H cells.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Ikegaki, T., Itoh, H., Muramatsu, S., Matsubara, S., Nakamura, N., Shimada, T., Umeda, J., and Migitaka, M., J.Appl. Phys. 58 (6), 15 September 1985, p. 23522359 Google Scholar
2. van den Heuvel, J., PhD thesis, Delft University of Technology, 1989.Google Scholar
3. Popovic, P., Furlan, J., Kussian, W., Solar Energy materials and Solar Cells 34 (1994) p. 393 Google Scholar
4. Furlan, J., J.A., , Amon, S., Popovič, P., Smole, F., Proc. of WCPC-1, Hawaii, (1994), p. 658661 Google Scholar
5. Sawada, T., Terada, N., Takahama, T., Tarui, H., Tanaka, M., Tsuda, S. and Nakano, S., Solar Energy Materials and Solar Cells 34 (1994) p. 367372 Google Scholar
6. Tao, G., Zeman, M. and Metselaar, J.W., Solar Energy Materials and Solar Cells 34 (1994), p. 359366.Google Scholar
7. Leblanc, F., Perrin, J., and Schmitt, J., J.Appl. Phys. 75 (2), 15 January (1994), p. 10741086 Google Scholar
8. Yang, J. and Guha, S., Appl. Phys. Lett. 61 (24), 14 December 1992, p. 29172919.Google Scholar
9. Willemen, J.A., Zeman, M. and Metselaar, J.W., Proc. of WCPC-1, Hawaii, (1994), p. 599602.Google Scholar
10. Wentinck, H.M., PhD thesis, Delft University of Technology, 1988.Google Scholar
11. Powell, M.J. and Deane, S.C., Phys. Rev. B, 48, (15) 10815, (1993)Google Scholar
12. Zeman, M, Tao, G., Trijssenaar, M., Willemen, J.A., Metselaar, J.W., and Schropp, R.,, in Amorphous Silicon Technology - 1995, ed. by Hack, M. et al., (Mat. Res. Soc. Proc. 377, San Francisco, CA 1995), p 639644.Google Scholar
13. Hishikawa, Y., Maruyama, E., Yata, S., Tanaka, M., Kiyama, S., and Tsuda, S., Techn. Digest of the Int'l PVSEC-9, Miyazaki, Japan (1996), pp. 639640 Google Scholar