The reliability of plastic packaged integrated circuits was assessed from the point of view of interfacial mechanical integrity. It is shown that the effect of structural weaknesses caused by poor bonding, voids, microcracks or delamination may not be evident in the electrical performance characteristics, but may cause premature failure. Acoustic microscopy (C-SAM) was selected for nondestructive failure analysis of the plastic integrated circuit (IC) packages. Integrated circuits in plastic dual in line packages were initially subjected to temperature (25 °C to 85 °C) and humidity cycling (50 to 85 %) where each cycle was of one hour duration and for over 100 cycles and then analyzed. Delamination at the interfaces between the different materials within the package, which is a major cause of moisture ingress and subsequent premature package failure, was measured. The principal areas of delamination were found along the leads extending from the chip to the edge of the molded body and along the die surface itself. Images of the 3-D internal structure were produced that were used to determine the mechanism for a package failure. The evidence of corrosion and stress corrosion cracks in the regions of delamination was identified.