Hostname: page-component-848d4c4894-pjpqr Total loading time: 0 Render date: 2024-06-23T05:26:27.141Z Has data issue: false hasContentIssue false

Incubation Time Free CVD-TiO2 Film Preparation Using Novel Precursor of Ti-DOT

Published online by Cambridge University Press:  23 March 2011

Hirokazu Chiba
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan
Ken-ichi Tada
Affiliation:
Sagami Chemical Research Institute, Hayakawa 2743-1, Ayase, Kanagawa, 252-1193, Japan
Toshiki Yamamoto
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan Sagami Chemical Research Institute, Hayakawa 2743-1, Ayase, Kanagawa, 252-1193, Japan
Kohei Iwanaga
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan Sagami Chemical Research Institute, Hayakawa 2743-1, Ayase, Kanagawa, 252-1193, Japan
Atsushi Maniwa
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan
Tadahiro Yotsuya
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan Sagami Chemical Research Institute, Hayakawa 2743-1, Ayase, Kanagawa, 252-1193, Japan
Noriaki Oshima
Affiliation:
TOSOH Corporation, Hayakawa 2743-1, Ayase, Kanagawa, 252-1123, Japan Sagami Chemical Research Institute, Hayakawa 2743-1, Ayase, Kanagawa, 252-1193, Japan
Hiroshi Funakubo
Affiliation:
Department of Innovative and Engineered Materials, Tokyo Institute of Technology, J2-43, 4259 Nagatsuta-cho, Midori-ku, Yokohama, Kanagawa, 226-8502, Japan
Get access

Abstract

Titanium oxide thin films were deposited at 250 – 400 °C on amorphous SiO2 prepared on n-type Si substrates by chemical vapor deposition (CVD) using a novel precursor, ethene-1,2-diylbis(tert-butylaminido)diisopropoxotitanium [Ti[N(tBu)C=CN(tBu)](OiPr)2 , Ti-DOT], with oxygen gas as an oxidant. Deposition characteristics of thin films were compared with those using titanium tetraisopropoxide [Ti(OiPr)4, TTIP]. As a result, the deposition amount of TiO2 thin films using Ti-DOT was larger than that of TTIP because of the shorter incubation time in the case of Ti-DOT. Smaller surface roughness was observed for the films using Ti-DOT. In addition, a good conformability was obtained on amorphous SiO2 hole prepared on n-type Si substrate substrate with aspect ratio of 5.

Type
Research Article
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Durand, H. A., Brimaud, J. H., Hellman, O., Shibata, H., Sakuragi, S., Makita, Y., Gesbert, D., and Meyrueis, P., Appl. Surf. Sci., 86, 122 (1995).Google Scholar
2. Inoue, T., Fujishima, A., Konishi, S., and Honda, K., Nature (London), 277, 637 (1979).Google Scholar
3. Keshmiri, M. and Troczynski, T., J. Non-Cryst. Solids, 324, 289 (2003).Google Scholar
4. Watanabe, T., Hoffmann-Eifert, S., Yang, L., Rüdiger, A., Kügeler, C., Hwang, C. S. and Waser, R., J. Electrochem. Soc., 154, G134 (2007).Google Scholar
5. Fitzgibbons, E. T., Sladek, K. J., and Hartwig, W. H., J. Electrochem. Soc., 119, 735 (1972).Google Scholar
6. Fictorie, C. P., Evans, J. F., and Gladfelter, W. L., J. Va. Sci. Technol A, 12, 1108 (1994).Google Scholar
7. Black, K., Jones, A. C., Bacsa, J., Chalker, P. R., Marshall, P. A., Davies, H. O., Heys, P. N., O’Brien, P., Afzaal, M., Raftery, J., and Critchlow, G. W., Chem. Vap. Depo., 16, 93 (2010).Google Scholar
8. Piszczek, P., Polyhedron, 26, 93 (2007).Google Scholar
9. Haaf, M.; Schmiedl, A.; Schmedake, T. A.; Powell, D. R.; Millevolte, A. J.; Denk, M.; West, R. J. Am. Chem. Soc., 120, 12714 (1998).Google Scholar