Hostname: page-component-7c8c6479df-24hb2 Total loading time: 0 Render date: 2024-03-29T14:10:44.587Z Has data issue: false hasContentIssue false

“Fast” and “Slow” Metastable Defects in a-Si:H

Published online by Cambridge University Press:  01 January 1993

Liyou Yang
Affiliation:
Solarex Corporation, Thin Film Division, Newtown, PA 18940
Liang-Fan Chen
Affiliation:
Solarex Corporation, Thin Film Division, Newtown, PA 18940
Get access

Abstract

A two-step light soaking experiment at high and low intensities provided convincing evidence that defect generation and annealing in a-Si:H are controlled by defect states of different characteristics. We point out that the total defect density by itself cannot uniquely determine the state of material or be described by a single rate equation, even though it might be the only quantity that is experimentally measurable. A system of rate equations for all defect components, therefore, must be established in order to accurately describe the defect kinetics. A simple two-component model in which defects are categorized as “fast” or “slow” is shown to be adequate to explain a variety of experimental results in a consistent fashion.

Type
Research Article
Copyright
Copyright © Materials Research Society 1993

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Stutzmann, M., Jackson, W., and Tsai, C.C., Phys. Rev. B32, 23 (1985).Google Scholar
2. Redfield, D. and Bube, R.H., Appl. Phys. Lett. 54, 1037 (1989).Google Scholar
3. Jackson, W.B and Kakalios, J., Phys. Rev. B 37, 1020 (1988).Google Scholar
4. Jackson, W.B., in Amorphous silicon Technology-1989, MRS Symp. Proc. Vol. 149 (Materials Research Society, Pittsburgh, 1989), p. 571.Google Scholar
5. Crandall, R.S., Phys. Rev. B 43, 4057 (1991).Google Scholar
6. Redfield, D., in Amorphous silicon Technology-1992, MRS Symp. Proc. Vol. 258 (Materials Research Society, Pittsburgh, 1992), p. 341.Google Scholar
7. Yang, L., Chen, L. and Catalano, A., Appl. Phys. Lett. 59, 840 (1991).Google Scholar
8. Chen, L. and Yang, L., J. Non-Crystalline Solids 137&138, 1185 (1991).Google Scholar
9. Bennett, M.S., Newton, J.L., Rajan, K. and Rothwarf, A., J. Appl. Phys. 62, 3968 (1987).Google Scholar
10. McMahon, T.J., in Amorphous silicon Technology-1992, MRS Symp. Proc. Vol. 258 (Materials Research Society, Pittsburgh, 1992), p. 325.Google Scholar
11. Fischer, D., Pellaton, N., Keppner, H., Shah, A., Fortmann, CM., in Amorphous silicon Technology-1992, MRS Symp. Proc. Vol. 258 (Materials Research Society, Pittsburgh, 1992), p. 893.Google Scholar
12. Smith, Z., Wagner, S., and Faughnan, B.W., Appl. Phys. Lett. 46, 1078 (1985).Google Scholar
13. Bennett, M., Rajan, K., Kritikson, K., to be published in Proc. of 23rd IEEE Photovaltaic Specialists Conf., Louisville, Kentucky, 1993.Google Scholar
14. Yang, L., et al. , to be published.Google Scholar