Hostname: page-component-76fb5796d-r6qrq Total loading time: 0 Render date: 2024-04-27T06:27:42.798Z Has data issue: false hasContentIssue false
  • English
  • Français

Experimental Measurement of Transmission Electron Microscope Specimen Temperature during Ion Milling

Published online by Cambridge University Press:  16 February 2011

D. Bahnck  and
R. Hull
D. Bahnck
Affiliation:
AT&T Bell Laboratories, Murray Hill, NJ 07974
R. Hull
Affiliation:
AT&T Bell Laboratories, Murray Hill, NJ 07974
Get access

Abstract

Semiconductor materials and devices are commonly investigated by transmission electron microscopy to obtain microstructural information. The results are useful only when a thinned sample is representative of the parent material. The technique of ion milling can introduce artifacts arising from beam heating during specimen preparation. A survey of specimen temperatures during argon and iodine ion milling of silicon, indium phosphide and gallium arsenide was made by encasing a thermocouple in a specimen and varying ion beam energy and beam angle of incidence. The results indicate, for example, that the typical temperature of silicon specimen preparation is less than 140°C. By decreasing the beam energy and incident angle, the milling temperature can be reduced. Design improvements on the ion mill can also sink heat away from the specimen.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 199: Symposium W – Specimen Preparation for Transmission Electron Microscopy of Materials II , 1990 , 253
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Gatan, Inc., 780 Commonwealth Drive, Warrendale, PA 15086.Google Scholar
[2] “Techniques of Insulator/Semiconductor Heterostructure Specimen Preparation”, Bahnck, D., Batstone, J. L., and Phillips, Julia M., Materials Research Society Symposium Proceedings, Vol. 115, p. 63, Specimen Preparation for Transmission Electron Microscopy of Materials.Google Scholar
[3] TEM Specimen Heating During Ion Beam Thinning: Microstructural Instability, Kim, M. J. and Carpenter, R. W., Ultramicroscopy 21, (1987) pp. 327–334.Google Scholar
[4] Omega Engineering, Inc., P.O. Box 2669, Stamford, CT 06906.Google Scholar
[5] Aremco Products, Inc., P.O. Box 429, Ossining, NY 10562-0429.Google Scholar
[6] “Ion Milling of Compound Semiconductors for Transmission Electron Microscopy”, Cullis, A. G. and Chew, N. G., Materials Research Society Symposium Proceedings, Vol. 115, p. 3, Specimen Preparation for Transmission Electron Microscopy of Materials.Google Scholar