Hostname: page-component-76fb5796d-r6qrq Total loading time: 0 Render date: 2024-04-26T10:47:30.776Z Has data issue: false hasContentIssue false
  • English
  • Français

Evaluation of B-Values Of Telecom Fibers, Objectives and Methods

Published online by Cambridge University Press:  10 February 2011

Torbjörn Svensson
Torbjörn Svensson*
Affiliation:
Telia Research AB Network Research S-123 86 Farsta, Sweden
Get access

Abstract

Stress corrosion in silica may end the lifetime of optical fibers in telecom networks. Since the lifetime demanded usually exceeds 25 years, a careful strategy is necessary in order to preserve cable reliability. The toolbox therefore includes equations for estimating lifetime of fibers, some of them related to the so-called B-parameter. The lifetime is proportional to B, but a value specific for the environment andfiber used has turned out to be difficult to achieve.

Among various experimental methods proposed, the mechanical testing at high stress rates is a physically sound way to confirm the B-value of coated fibers, since testing can be made under similar conditions as prevail during network application. Fatigue tests including high-speed tensile tests have been run on coated silica fibers for a long time. Lately, a new high-stress-rate bending method has been investigated, pushing forward the previous experimental limits.

Values of B from tensile- and bending tests are presented, being 0.004 - 0.10 GPa2 s in tension and considerably less in bending, about 0.0007 GPa2s. A study on some acrylate-coated silica fibers including draw-abraded fibers indicates that the B-value also depends on fiber strength.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 531: Symposium DD – Reliabilty of Photonics Materials & Structures , 1998 , 47
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Mitsunaga, Y., Katsuyama, K. and Ishida, Y., “Reliability assurance for long-length optical fibre based on proof testing”, Electronics Letters 17, 567–568 (1981)Google Scholar
2. Svensson, T., “High strain-rate testing of optical fibers”, Proc 37th IWCS, 217–224 (1988)Google Scholar
3. Gouronnec, A. and Evanno, N., “High speed axial strength setup for the measurement of the B-value”, Proc 4 5th IWCS (International Wire & Cable Symposium), 906–913 (1996)Google Scholar
4. Garvey, P. T., Hanson, T. A., Estep, M. G., and Glaesemann, G. S., “Mechanical reliability predictions: an attempt at measuring the initial strength of draw abraded optical fiber using high stressing rates”, Proc 4 6th IWCS, 883–888 (1997)Google Scholar
5. Griffioen, W., Svensson, T. and Friedrich, B., “Optical fiber inert strength and B-value”, Proc 4 3rd IWCS, 750–758 (1994)Google Scholar
6. Hjorth, A. and Svensson, T., “Tapered slot test. A high-speed bending test method for measurement of B-value of fibers”, Proc 4 5th IWCS, 490–494 (1996)Google Scholar
7. Svensson, T., “Tensile test of titania-doped, carbon coated, and all-silica base optical fibres”, in Materials Science and Reliability of Optical Fibres and Cables COST218 Final Report (1994)Google Scholar