Hostname: page-component-5c6d5d7d68-wtssw Total loading time: 0 Render date: 2024-08-06T23:03:34.886Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of Sc or Tb Addition on the Microstructures and Resistivities of Al Thin Films

Published online by Cambridge University Press:  10 February 2011

Shinji Takayama
Shinji Takayama*
Affiliation:
Hosei University, Dept. of System and Control Engineering, 3–7–2, Kajino-cho, Koganei, Tokyo, 184–8584, Japan
Get access

Abstract

The resistivities of Al thin films with added Sc or Tb largely decrease at over 350 °C. They reach to 5 -7 μΩcm after annealing at 450 °C, together with the segregation of fine Al3RE (RE = Sc or Tb) metallic compounds. However, the temperatures at which resistivity starts to decrease largely are much lower for Al-SC alloy films (150 °C) than for Al-Tb ones (250 °C). Furthermore, thermal defects of hillocks or whiskers start to appear on the film surface after annealing at 200 °C and 450 °C for Al-Sc and Al-Tb alloy films, respectively. It was revealed that the further addition of Zr to these binary alloy films largely retards a large decrease of resistivities on annealing and enhances the formation of hillocks or whiskers. On the contrary, the addition of Cu to Al-Tb or Al-Sc films significantly suppresses the formation of thermal defects and shows relatively low resistivities after annealing at 350 °C.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 500: Symposium EE – Electrically Based Microstructural Characterization II , 1997 , 107
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

VII. REFERENCES

1. Yamamoto, M., Kobayashi, I., Hirose, T., Bruck, S. M., Tsuboi, N., Mino, Y., Okafuji, M., and Tamura, T., Proc. of SID 94, 142 (1994).Google Scholar
2. Lee, Y. K., Fujiwara, N., and Ito, T., J. Vac. Sci. Technol. B9, 2542 (1991).Google Scholar
3. Takayama, S. and Tsutsui, N., Extended Abstracts of the 1995 Int. Conf. on Solid State Devices and Materials (SSDM '95), Osaka, 1995, pp. 318–320.Google Scholar
4. Takayama, S. and Tsutsui, N., J. Vac. Sci. Technol. A 14(4), 2499 (1996).Google Scholar
5. Takayama, S. and Tsutsui, N., Thin Solid films, Thin Solid films 289, 289 (1996).Google Scholar
6. Takayama, S. and Tsutsui, N., J. Vac. Sci. Technol. B 14(5), 3257 (1996).Google Scholar
7. Guttmann, M., Surface Sci., 53, 213 (1975).Google Scholar