Hostname: page-component-848d4c4894-hfldf Total loading time: 0 Render date: 2024-05-13T09:35:31.364Z Has data issue: false hasContentIssue false

The Effect Of The Crystal Orientation Of The Formation Of The Oxygen-Deficient Magnetite

Published online by Cambridge University Press:  15 February 2011

Y. Wada
Affiliation:
Tokyo Institute of Technology, Ookayama, Meguro-ku, Tokyo, 152, Japan
T. Togawa
Affiliation:
Tokyo Institute of Technology, Ookayama, Meguro-ku, Tokyo, 152, Japan
H. Kato
Affiliation:
Tokyo Institute of Technology, Ookayama, Meguro-ku, Tokyo, 152, Japan
M. Tsuji
Affiliation:
Tokyo Institute of Technology, Ookayama, Meguro-ku, Tokyo, 152, Japan
Y. Tamaura
Affiliation:
Department of Chemistry, Research Center for Carbon Recycling & Utilization
Get access

Abstract

An oxygen-deficient magnetite (Fe3O4–8) has been found to form by passing H2 gas through magnetite powder at 300°C with its spinel structure retained. The oxygen-deficient magnetite is a metastable phase in the transformation of magnetite into α-Fe. The lattice constant of the oxygen-deficient magnetite enlarged to 0.8407nm in the maximum value which is substantially larger than that of the stoichiometric magnetite (a0=0.8396nm). The formation mechanism of the oxygen-deficient magnetite was studied at 300°C using two specimens of magnetite powders with developed orientations on the (111) and (100) planes. These are referred to as (111)- and (100)-magnetite, respectively. The formation of α-Fe was suppressed over the crystal of (111)-magnetite, where wUstite and oxygen-deficient magnetite were formed while keeping the f.c.c. arrangement of the oxygen ions in the solid. On the other hand, over the (100)-magnetite, the formation of a-Fe was enhanced. It is considered that, on the (111)- magnetite, the Fe2+ ion formed by H2-reduction on the surface can move into interstices of the f.c.c. lattice of bulk to form the oxygen deficient state. This will come from the fact that the Fe2+ ion on the surface is so strongly supported with three Fe-O bondings that the Fe2+ ions cannot readily diffuse on the surface when the surface oxygen ions are removed on the (111)- magnetite.

Type
Research Article
Copyright
Copyright © Materials Research Society 1994

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Smith, J. and Wijin, J. I. J., Ferrite (Philips Technical Library Tokyo, 1965), p. 136.Google Scholar
2. Flood, H. and Hill, D. G., Ber. Bunsenges. Phys. Chem. 61 18 (1957).Google Scholar
3. Brynestad, J. and Flood, H., Ber. Bunsenges. Phys. Chem. 62 953 (1958).Google Scholar
4. Dieckmann, R., Ber. Bunsenges. Phys. Chem. 86 112 (1982).Google Scholar
5. Tamaura, Y. and Tabata, M., Nature 346 255 (1990).Google Scholar
6. Dieckmann, R. and Schmalzried, H., Ber. Bunsenges. Phys. Chem. 81 414 (1977).Google Scholar
7. Tarnaura, Y., Proc. Int. Symp. Chemical Fixation Carbon Dioxide, Nagoya, 1991, ed. Ito, K., The chemical Society of Japan; the Research Group on Fixation of Carbon Dioxide, Nagoya, 1991, pp. 167172.Google Scholar
8. Tamaura, Y., The 6th International Conference on Ferrites, Tokyo, Japan, 1992, pp. 195198. Google Scholar
9. Iwasaki, I., Katsura, T., Ozawa, T., Yoshida, M., Mashima, M., Haramura, H. and Iwasaki, B., Bull. Volcanol. Soc. Jpn. Ser.II 5 9 (1960).Google Scholar
10. JCPDS card 19–629 (Joint Comittee on Powder Diffraction Standard, Swarth more, (1989).Google Scholar
11. Jette, E. R. and Foote, F., J. Chem. Phys. 1 29 (1933).Google Scholar