Hostname: page-component-77c89778f8-sh8wx Total loading time: 0 Render date: 2024-07-17T11:05:03.424Z Has data issue: false hasContentIssue false

Comparison Of Gettering Ability between I/I Defects And Si Substrate

Published online by Cambridge University Press:  15 February 2011

Mitsuhiro Horikawa
Affiliation:
ULSI Device Development Laboratories NEC Corporation, 1120, Shimokuzawa, Sagamihara, Kanagawa 229, Japan
Tomohisa Kitano
Affiliation:
ULSI Device Development Laboratories NEC Corporation, 1120, Shimokuzawa, Sagamihara, Kanagawa 229, Japan
Get access

Abstract

A Si wafer is contaminated with 1.5 × 1013 Fe/cm3 and the Fe gettering ability of low dose I/I defects is compared with that of a Si substrate with/without a poly-silicon back seal. Polysilicon has higher gettering ability than I/I defects and prevents Fe from gettering at these defects. When there is no poly-silicon and temperature is as low as 700°C, however, I/I defects act as gettering sites for Fe, even if the dose is as low as 2 × 1013 cm−2. Fe gettering by I/I defects leads to a decrease in minority carrier diffusion length. DLTS measurement reveals that Fe getters at I/I defects in the interstitial atom state.

Type
Research Article
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Gregor, R. W. and Stinebaugh, W. H. Jr., J. Appl. Phys., 64, 2079 (1988)Google Scholar
[2] Gilles, D., Weber, E. R., and Hahn, S., Phys. Rev. Lett., 64, 196 (1990)Google Scholar
[3] Hayamizu, Y., Ushio, S., and Takenaka, T., in MRS Symposia Proceedings Vol. 263 (1992) p. 1005.Google Scholar
[4] Aoki, M., Hara, A., and Ohsawa, A., J. Appl. Phys. 72, 895 (1992)Google Scholar
[5] Sano, S., Sumita, S., Shigematsu, T., and Fujino, N., in Semiconductor Silicon/1994, Proceedings of The Electrochemical Society, edited by Huff, H. R., Bergholz, W., and Sumino, K. (The Electrochemical Society, Pennington, 1994), p. 784Google Scholar
[6] Zoth, G. and Bergholz, W., J. Appl. Phys., 67, 6764 (1990)Google Scholar
[7] Lang, D. V., J. Appl. Phys. 45, 3023 (1974)Google Scholar
[8] Hourai, M., Naridomi, T., Oka, Y., Murakami, K., Sumita, S., Fujino, N. and Shiraiwa, T., Jpn. J. Appl. Phys. 27 (1988) L2361Google Scholar
[9] Benton, J. L. and Kimerling, L.C., J. Electrochem. Soc. 129, 2098 (1982)Google Scholar
[10] Brotherton, S. D., Bradley, P., and Gill, A., J. Appl. Phys. 57, 1941 (1985)Google Scholar