Hostname: page-component-848d4c4894-8bljj Total loading time: 0 Render date: 2024-06-20T21:51:58.202Z Has data issue: false hasContentIssue false

Characterization of InGaN/GaN Multiple Quantum Wells Grown on Sapphire Substrates by Nano-scale Epitaxial Lateral Overgrowth Technique

Published online by Cambridge University Press:  14 January 2011

W.K. Fong
Affiliation:
Department of Electronic and Information Engineering and Photonics Research Centre, The Hong Kong Polytechnic University, Hong Kong
K.K. Leung
Affiliation:
Department of Electronic and Information Engineering and Photonics Research Centre, The Hong Kong Polytechnic University, Hong Kong
Charles Surya
Affiliation:
Department of Electronic and Information Engineering and Photonics Research Centre, The Hong Kong Polytechnic University, Hong Kong
Get access

Abstract

High-quality InGaN/GaN multiple quantum wells (MQWs) were fabricated on nano-scale epitaxial lateral overgrown (NELO) GaN layers which was prepared using nanometer-scale SiO2 islands, with an average diameter and interdistance of 300nm and 200nm respectively, as the growth mask. The active region of the device consists of five periods of GaN/InGaN MQWs were grown on top of the NELO layer using MOCVD technique. It is observed that some of the dislocations from the undoped GaN were blocked by the SiO2 growth mask and typical threading dislocation (TD) density found in the NELO samples is ~7.5×107cm-2. Significant improvement in the electroluminescence (EL) is observed which is believed to partly arise from the improvement in the internal quantum efficiency (ηi). The experimental data on the temperature dependence of the photoluminescence (PL) were fitted to a proposed model using Levenberg-Marquardt approximation. Based on our analyses it is found that the relative improvement in ηi at 300K over a control device grown in the same growth condition but without the NELO layer to a NELO device is only 0.59. It is generally accepted that TD is the non-radiative recombination center which affects the IQE. Therefore, room-temperature IQE values also support that NELO device exhibits lower TD density.

Type
Research Article
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Cho, H.K., Lee, J.Y., Kim, K.S., Yang, G.M., Song, J.H. and Yu, P.W., Journal of Applied Physics 89, 2617 (2001).Google Scholar
2. Yihwan, K., Subramanya, S.G., Siegle, H., Kruger, J., Perlin, P., Weber, E.R. and Ruvimov, S., Lilliental-Weber, Z., Journal of Applied Physics 88, 6032 (2000).Google Scholar
3. Morita, D., Fujioka, A., Mukai, T. and Fukui, M., Japanese Journal of Applied Physics 46, 2895 (2007).Google Scholar
4. Zheleva, T.S., Nam, O.H., Ashmawi, W.M., Griffin, J.D. and Davis, R.F., Journal of Crystal Growth 222, 706 (2001).Google Scholar
5. Beaumont, B., Bousquet, V., Vennégués, P., Vaille, M., Bouillé, A., Gibart, P., Dassonneville, S., Amokrane, A. and Sieber, B., Physica Status Solidi A 176, 567 (1999).Google Scholar
6. Fong, W.K., Leung, K.K. and Surya, C., Journal of Crystal Growth (2010) (in press).Google Scholar
7. Sasaki, A., Shibakawa, S., Kawakami, Y., Nishizuka, K., Narukawa, Y. and Mukai, T., Japanese Journal of Applied Physics 45, 8719 (2006).Google Scholar