Hostname: page-component-848d4c4894-nmvwc Total loading time: 0 Render date: 2024-07-01T09:58:30.714Z Has data issue: false hasContentIssue false
  • English
  • Français

Characteristics of Ultra Shallow B Implantation with Decaborane

Published online by Cambridge University Press:  11 February 2011

Cheng Li ,
Maria A. Albano ,
Leszek Gladczuk  and
Marek Sosnowski
Cheng Li
Affiliation:
New Jersey Institute of Technology, Newark, NJ 07102, U.S.A.
Maria A. Albano
Affiliation:
Applied Optronics, South Plainfield, NJ 07080, U.S.A.
Leszek Gladczuk
Affiliation:
New Jersey Institute of Technology, Newark, NJ 07102, U.S.A.
Marek Sosnowski
Affiliation:
New Jersey Institute of Technology, Newark, NJ 07102, U.S.A.
Get access

Abstract

The characteristics of ultra shallow B implantation with mass-analyzed decaborane cluster ions (B10Hx+) are presented. Depth profiles of B and co-implanted H were measured by SIMS, before and after annealing. Annealing results in the increase in the depth of B distribution, due to diffusion, but most of H diffuses out of Si. While the sputtering yield of Si per incoming B in a cluster was found to be comparable to the estimated sputtering yield of Si with B+ ions of the equivalent energy (∼ 1.2 keV), the surface effects of the two types of ions may be quite different. Atomic force microscopy revealed that the smoothing effect of the small decaborane cluster ions, observed previously by us on a surface of amorphous Si, is also present on crystalline Si and even on a much rougher surface of polycrystalline Ta film. The smoothing affects different parts of the power density spectra as functions of spatial frequency in the amorphous and crystalline materials. The smoothing on c-Si surfaces is in sharp contrast to roughening of these surfaces by irradiation with monomer Ar ions, which was done for reference. This indicates that different ion-surface interaction mechanisms are needed to describe impacts of cluster and of monomer ions. All other effects of Si implantation with B10Hx+ measured to date were found to be the same as those with B+ ions of equivalent energy and dose, which confirms that decaborane implantation is an alternative to the very low energy B implantation for ultra shallow p-type junctions in Si devices.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 745: Symposium N – Novel Materials and Processes for Advanced CMOS , 2002 , N6.3
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. “The International Technology Roadmap for Semiconductors”, Semiconductor Industry Association (2001).Google Scholar
2. Goto, K., Matsuo, J., Sugii, T., Minakata, H., Yamada, I., and Hisatsugu, T., IEDM-96 Tech. Digest, 435–438 (1996).Google Scholar
3. Jacobson, D. C., Bourdelle, K., Gossmann, H. J., Sosnowski, M., Albano, M. A., Babaram, V., Poate, J. M., Agarwal, A., Perel, A., and Horsky, T., in Proceedings of the 2000 International Conference on Ion Implantation Technology, ed. Ryssel, H., Frey, L., Gyulai, J., and Glawischnig, H. (IEEE, 2000) pp. 300–303.Google Scholar
4. Perel, A. S., Krull, W., and Hoglund, D., in Proceedings of the 2000 International Conference on Ion Implantation Technology, ed. Ryssel, H., Frey, L., Gyulai, J., and Glawischnig, H. (IEEE, 2000) pp. 304–307.Google Scholar
5. Sosnowski, M., Gurudath, R., Poate, J. M., Mujsce, A., and Jacobson, D. C., in Silicon FrontEnd Processing-Physics and Technology of Dopant-Defect Interactions, ed. Gossmann, H-J.L., Haynes, T.E., Law, M.E., Larsen, A.N., Odanaka, S., (Mater. Res. Soc. Symp. Proc. 568, 1999) pp. 49–54.Google Scholar
6. Dirks, A.G., Bancken, P.H.L., Politiek, J., Cowern, N.E.B., Snijders, J.H.M., Van Berkum, J.G.M., and Verheijen, M.A., in Proceedings of the 2000 International Conference on Ion Implantation Technology Vol. 2, (IEEE, 1998) pp. 1167 –1170.Google Scholar
7. Takeuchi, D., Shimada, N., Matsuo, J., and Yamada, I., Nucl. Instr. and Meth. in Phys. Res. B 121, 345–348 (1997).Google Scholar
8. Agarwal, A., Gossman, H-J., Jacobson, D.C., Eaglesman, D. J., Sosnowski, M., Poate, J. M., Yamada, I., Matsuo, J., and Haynes, T. E., Appl. Phys. Lett. 73, 2015–2017 (1998).Google Scholar
9. Sosnowski, M., Albano, M. A., Li, C., Gossmann, H-J. L., and Jacobson, D. C., J. Electrochem. Soc. 149, G474–G476 (2002).Google Scholar
10. Yamada, I., Matsuo, J., Toyoda, N., and Kirkpatrick, A., Mat. Sci. and Eng. R 34, 231–295 (2001).Google Scholar
11. Sosnowski, M., Albano, M. A., Babaram, V., Gurudath, R., Poate, J. M., and Jacobson, D. C., J. Electrochem. Soc. 147, 4329 (2000).Google Scholar
12. Sosnowski, M., Albano, M. A., Li, C., Gossmann, H-J. L., and Jacobson, D. C., Appl. Phys. Lett. 80, 592–594 (2002).Google Scholar
13. Yamamura, Y., Natsunami, M., and Itoh, N., Radiat. Eff. 71, 65 (1983).Google Scholar