Hostname: page-component-77c89778f8-vpsfw Total loading time: 0 Render date: 2024-07-20T00:10:00.183Z Has data issue: false hasContentIssue false
  • English
  • Français

Transient Creep Behavior of γ-TiAl Polycrystals

Published online by Cambridge University Press:  15 February 2011

B. Viguier ,
J. Bonneville ,
P. Spätig  and
J. L. Martin
B. Viguier
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Institut de Génie Atomique, Département de Physique, 1015 - Lausanne (Switzerland), viguier@epfl.ch
J. Bonneville
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Institut de Génie Atomique, Département de Physique, 1015 - Lausanne (Switzerland), viguier@epfl.ch
P. Spätig
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Institut de Génie Atomique, Département de Physique, 1015 - Lausanne (Switzerland), viguier@epfl.ch
J. L. Martin
Affiliation:
Ecole Polytechnique Fédérale de Lausanne, Institut de Génie Atomique, Département de Physique, 1015 - Lausanne (Switzerland), viguier@epfl.ch
Get access

Abstract

Two types of transient creep experiments performed along stress-strain curves are described and successfully applied to γ TiAl polycrystals at room temperature. They allow to determine activation volumes in good agreement with those measured through successive load relaxation tests. In addition, the combination of the latter method and the present ones provides relevant values of the plastic strain hardening coefficient. This latter parameter is found to exhibit similar values in transient as well as during constant strain rate tests.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 460: Symposium Z – High-Temperature Ordered Intermetallic Alloys VII , 1996 , 263
Copyright
Copyright © Materials Research Society 1997

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Guiu, F., Pratt, P.L., Phys. Stat. Sol., 6, 111 (1964).Google Scholar
2. Spätig, P., Bonneville, J. and Martin, J.L., Mat. Science Eng. A 167, 73 (1993).Google Scholar
3. Spätig, P., Bonneville, J. and Martin, J.L., High-Temperature Ordered Intermetallic Alloys VI edited by Horton, J.A. Baker, I., Hanada, S., Noebe, R.D., Schwartz, D.S. (Mat. Res. Soc. Symp. Proc. 364 Part 2, Pittsburg, PA, 1995) pp. 713–718.Google Scholar
4. Bonneville, J., Spätig, P., Orlova, A., Martin, J.L., in Strength of Materials, edited by Oikawa, H., Maruyama, K., Takeuchi, S. and Yamaguchi, M. (Proc. of the 10th Int Conf. on the Strength of Materials, Sendai, the Japan Institute of Metals 1994) pp. 199–202.Google Scholar
5. Bonneville, J., Spätig, P., Martin, J.L., High-Temperature Ordered Intermetallic Alloys VI edited by Horton, J.A. Baker, I., Hanada, S., Noebe, R.D., Schwartz, D.S. (Mat. Res. Soc. Symp. Proc. 364 Part 1, Pittsburg, PA, 1995) pp. 369–374.Google Scholar
6. Spätig, P., PhD Thesis no 1407, Lausanne (1995).Google Scholar
7. Orlova, A., Bonneville, J., Spätig, P., Mat. Science Eng. A 191, 85 (1995).Google Scholar
8. Bonneville, J., Viguier, B. and Spätig, P., Scripta Met., in press.Google Scholar