Hostname: page-component-848d4c4894-sjtt6 Total loading time: 0 Render date: 2024-06-23T11:52:53.118Z Has data issue: false hasContentIssue false
  • English
  • Français

Using Microscopy and Image Analysis to Show Density and Property Variations in Additive Manufactured Ti-6Al-4V

Published online by Cambridge University Press:  05 August 2019

Erica Stevens ,
Samantha Schloder ,
Eric Bono ,
David Schmidt  and
Markus Chmielus
Erica Stevens
Affiliation:
Dept. of Mechanical Engineering and Materials Science, Univ. of Pittsburgh, Pittsburgh, PA, USA
Samantha Schloder
Affiliation:
Dept. of Mechanical Engineering and Materials Science, Univ. of Pittsburgh, Pittsburgh, PA, USA
Eric Bono
Affiliation:
Carpenter Technology Corporation, Philadelphia, PA, USA
David Schmidt
Affiliation:
Dept. of Mechanical Engineering and Materials Science, Univ. of Pittsburgh, Pittsburgh, PA, USA
Markus Chmielus*
Affiliation:
Dept. of Mechanical Engineering and Materials Science, Univ. of Pittsburgh, Pittsburgh, PA, USA
*
*Corresponding author: chmielus@pitt.edu

Abstract

An abstract is not available for this content so a preview has been provided. As you have access to this content, a full PDF is available via the ‘Save PDF’ action button.
Image of the first page of this content. For PDF version, please use the ‘Save PDF’ preceeding this image.'
Type
Advanced Characterization of Components Fabricated by Additive Manufacturing
Information
Microscopy and Microanalysis , Volume 25 , Supplement S2 , August 2019 , pp. 2590 - 2591
Copyright
Copyright © Microscopy Society of America 2019 

References

[1]Stevens, E et al. , Additive Manufacturing 22 (2018), p. 746-752.Google Scholar
[2]Schneider, CA, Rasband, WS, Eliceiri, KW, Nature Methods 9 (2012), p.671-675.Google Scholar
[3]Miyanaji, H, Zhang, S and Yang, L, Int J Mach Tool Manu 24 (2018), p. 1-11.Google Scholar
[4]DebRoy, T et al. , Progress in Materials Science 92 (2018), p 112-224.Google Scholar
[5]The authors acknowledge Fred Yolton and Adam Byrd from Carpenter Technology Corporation. E. Stevens was partially supported by the Department of Defense (DoD) through the National Defense Science & Engineering Graduate Fellowship (NDSEG) Program. S. Schloder was funded by the PPG foundation, and would like to thank the Swanson School of Engineering for supporting undergraduate research. University of Pittsburgh MMCL facilities were used in this research.Google Scholar