Hostname: page-component-848d4c4894-4rdrl Total loading time: 0 Render date: 2024-07-03T05:08:09.822Z Has data issue: false hasContentIssue false
  • English
  • Français

Direct tapping practice at the LWS converters of the steel shop of Sollac Lorraine

Published online by Cambridge University Press:  25 October 2002

G. Blondey ,
G. Didry ,
C. A. Dubois ,
R. Schutz ,
C. Grisvard  and
J. C. Huber
Get access

Abstract

Sollac Lorraine is equipped with two bottom blowing converters which are the bottleneck of the steel shop. A dynamic guide based on a temperature measurement of the metal during blowing and an original use of the analysis of the gases coming out of the converter permit tapping immediately at the end of the blowing. The industrial start up of this process in July 2001 has resulted in an increase in converter productivity and efficiency.

Type
Research Article
Information
Metallurgical Research & Technology , Volume 99 , Issue 4: AciériesCoulées continuesRéfractaires , April 2002 , pp. 317 - 323
Copyright
© La Revue de Métallurgie, 2002

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)