Skip to main content Accessibility help
×
Home

Electrodeposition of Co–Ni–P/graphene oxide composite coating with enhanced wear and corrosion resistance

  • Cansen Liu (a1), Dongdong Wei (a1), Xiaoye Huang (a1), Yongjin Mai (a1), Liuyan Zhang (a1) and Xiaohua Jie (a1)...

Abstract

Coatings with low friction coefficient and excellent anti-wear and anticorrosion performances are of great interest for fundamental research and practical applications. In the present study, Cobalt–nickel–phosphorus/graphene oxide (Co–Ni–P/GO) composite coating is prepared by a pulse electrodeposition method. Effect of the embedded GO sheets on the microstructures, microhardness, and electrochemical and tribological behaviors of the Co–Ni–P/GO composite coating are researched in detail. The results reveal that the co-deposition of GO sheets significantly improves the microhardness of the as-prepared Co–Ni–P/GO composite coating and changes the morphology of the Co–Ni–P coating from hemispheric structure to nodule structure with smaller globular particles for the Co–Ni–P/GO composite coating. In addition, friction and wear tests show that the incorporation of GO sheets endows the Co–Ni–P/GO composite coating with remarkable friction reduction and improved wear resistance. Electrochemical corrosion tests demonstrate that the Co–Ni–P/GO composite coating possesses better corrosion resistance than the Co–Ni–P coating.

Copyright

Corresponding author

a)Address all correspondence to this author. e-mail: cnxyyz3@gdut.edu.cn

References

Hide All
1.Leimbach, M., Tschaar, C., Schmidt, U., and Bund, A.: Electrochemical characterization of chromium deposition from trivalent solutions for decorative applications by EQCM and near-surface pH measurements. Electrochim. Acta 270, 104 (2018).
2.Tamilarasan, T.R., Sanjith, U., Shankar, M.S., and Rajagopal, G.: Effect of reduced graphene oxide (rGO) on corrosion and erosion-corrosion behaviour of electroless Ni–P coatings. Wear 390, 385 (2017).
3.Sadeghzadeh-Attar, A., AyubiKia, G., and Ehteshamzadeh, M.: Improvement in tribological behavior of novel sol-enhanced electroless Ni–P–SiO2 nanocomposite coatings. Surf. Coat. Technol. 307, 837 (2016).
4.Wang, L., Gao, Y., Xue, Q., Liu, H., and Xu, T.: A novel electrodeposited Ni–P gradient deposit for replacement of conventional hard chromium. Surf. Coat. Technol. 200, 3719 (2006).
5.Wang, J., Zhang, F.L., Zhang, T., Liu, W.G., Li, W.X., and Zhou, Y.M.: Preparation of Ni–P-diamond coatings with dry friction characteristics and abrasive wear resistance. Int. J. Refract. Met. Hard Mater. 70, 32 (2017).
6.Wang, L., Gao, Y., Xue, Q., Liu, H., and Xu, T.: Microstructure and tribological properties of electrodeposited Ni–Co alloy deposits. Appl. Surf. Sci. 242, 326 (2005).
7.Jain, R. and Pitchumani, R.: Facile fabrication of durable copper based superhydrophobic surfaces via electrodeposition. Langmuir 34, 3159 (2017).
8.Nicolenco, A., Tsyntsaru, N., Fornell, J., Pellicer, E., Reklaitis, J., Baltrunas, D., Cesiulis, H., and Sort, J.: Mapping of magnetic and mechanical properties of Fe–W alloys electrodeposited from Fe(III)-based glycolate-citrate bath. Mater. Des. 139, 429 (2018).
9.Beltowska-Lehman, E., Indyka, P., Bigos, A., Szczerba, M.J., Guspiel, J., Koscielny, H., and Kot, M.: Effect of current density on properties of Ni–W nanocomposite coatings reinforced with zirconia particles. Mater. Chem. Phys. 173, 524 (2016).
10.Fernandez, A.M., Turner, J.A., Lara-Lara, B., and Deutsch, T.G.: Preparation and characterization of Cu–Ga–Se thin films synthesized by electrodeposition: Effect of complexing agent and supporting electrolyte. Mater. Chem. Phys. 213, 324 (2018).
11.Najafi, M., Rafati, A.A., Fart, M.K., and Zare, A.: Effect of the pH and electrodeposition frequency on magnetic properties of binary Co1−xSnx nanowire arrays. J. Mater. Res. 29, 190 (2014).
12.Park, D.Y., Myung, N.V., Schwartz, M., and Nobe, K.: Nanostructured magnetic CoNiP electrodeposits: Structure–property relationships. Electrochim. Acta 47, 2893 (2003).
13.Wang, H., Wan, L., Zhang, J., Chen, Y., Hu, W., Liu, L., Zhong, C., and Deng, Y.: Enhanced microwave absorbing properties of surface-modified Co–Ni–P nanotubes. Mater. Lett. 169, 193 (2016).
14.Rakap, M., Kalu, E.E., and Özkar, S.: Hydrogen generation from the hydrolysis of ammonia borane using cobalt–nickel–phosphorus (Co–Ni–P) catalyst supported on Pd-activated TiO2 by electroless deposition. Int. J. Hydrogen Energy 36, 254 (2011).
15.Mirzamohammadi, S., Khorsand, H., Aliofkhazraei, M., and Shtansky, D.V.: Effect of carbamide concentration on electrodeposition and tribological properties of Al2O3 nanoparticle reinforced nickel nanocomposite coatings. Tribol. Int. 117, 68 (2017).
16.He, T., He, Y., Li, H., Fan, Y., Yang, Q., and He, Z.: A comparative study of effect of mechanical and ultrasound agitation on the properties of pulse electrodeposited Ni–W/MWCNTs composite coatings. J. Alloys Compd. 743, 63 (2018).
17.Zhou, M., Mai, Y., Ling, H., Chen, F., Lian, W., and Jie, X.: Electrodeposition of CNTs/copper composite coatings with enhanced tribological performance from a low concentration CNTs colloidal solution. Mater. Res. Bull. 97, 537 (2018).
18.Wang, S., Han, S., Xin, G., Lin, J., Wei, R., Lian, J., Sun, K., Zu, X., and Yu, Q.: High-quality graphene directly grown on Cu nanoparticles for Cu–graphene nanocomposites. Mater. Des. 139, 181 (2018).
19.Stenberg, K., Dittrick, S., Bose, S., and Bandyopadhyay, A.: Influence of simultaneous addition of carbon nanotubes and calcium phosphate on wear resistance of 3D-printed Ti6Al4V. J. Mater. Res. 33, 2077 (2018).
20.Wang, J., Wang, W., and Jia, J.: The oxidation resistance and tribological properties of Ni-based composites with in situ/ex situ Al2O3 and TiC ceramic phases at high temperatures. J. Mater. Res. 31, 3262 (2016).
21.Qiu, S., Liu, G., Li, W., Zhao, H., and Wang, L.: Noncovalent exfoliation of graphene and its multifunctional composite coating with enhanced anticorrosion and tribological performance. J. Alloys Compd. 747, 60 (2018).
22.Mirzaee, M., Dehghanian, C., and Bokati, K.S.: One-step electrodeposition of reduced graphene oxide on three-dimensional porous nano nickel–copper foam electrode and its use in supercapacitor. J. Electroanal. Chem. 813, 152 (2018).
23.Mai, Y.J., Zhou, M.P., Ling, H.J., Chen, F.X., Lian, W.Q., and Jie, X.H.: Surfactant-free electrodeposition of reduced graphene oxide/copper composite coatings with enhanced wear resistance. Appl. Surf. Sci. 433, 232 (2018).
24.Liu, C., Su, F., and Liang, J.: Producing cobalt–graphene composite coating by pulse electrodeposition with excellent wear and corrosion resistance. Appl. Surf. Sci. 351, 889 (2015).
25.Kumar, C.M.P., Venkatesha, T.V., and Shabadi, R.: Preparation and corrosion behavior of Ni and Ni–graphene composite coatings. Mater. Res. Bull. 48, 1477 (2013).
26.Jiang, J., Feng, C., Qian, W., Zhu, L., Han, S., and Lin, H.: Effect of graphene oxide nanosheets and ultrasonic electrodeposition technique on Ni–Mo/graphene oxide composite coatings. Mater. Chem. Phys. 199, 239 (2017).
27.Xue, Z., Lei, W., Wang, Y., Qian, H., and Li, Q.: Effect of pulse duty cycle on mechanical properties and microstructure of nickel–graphene composite coating produced by pulse electrodeposition under supercritical carbon dioxide. Surf. Coat. Technol. 325, 417 (2017).
28.Zhang, Q., Qin, Z., Luo, Q., Wu, Z., Liu, L., Shen, B., and Hu, W.: Microstructure and nanoindentation behavior of Cu composites reinforced with graphene nanoplatelets by electroless co-deposition technique. Sci. Rep. 7, 1338 (2017).
29.Sankara Narayanan, T.S.N., Baskaran, I., Krishnaveni, K., and Parthiban, S.: Deposition of electroless Ni–P graded coatings and evaluation of their corrosion resistance. Surf. Coat. Technol. 200, 3438 (2006).
30.Qiao, L., Wu, Y., Hong, S., Qin, Y., Shi, W., and Li, G.: Corrosion behavior of HVOF-sprayed Fe-based alloy coating in various solutions. J. Mater. Eng. Perform. 26, 3813 (2017).
31.Aal, A.A., El-Sheikh, S.M., and Ahmed, Y.M.Z.: Electrodeposited composite coating of Ni–W–P with nano-sized rod- and spherical-shaped SiC particles. Mater. Res. Bull. 44, 151 (2009).
32.Qu, N.S., Zhu, D., and Chan, K.C.: Fabrication of Ni–CeO2 nanocomposite by electrodeposition. Scr. Mater. 54, 1421 (2006).
33.Mai, Y.J., Tu, J.P., Gu, C.D., and Wang, X.L.: Graphene anchored with nickel nanoparticles as a high-performance anode material for lithium ion batteries. J. Power Sources 209, 1 (2012).
34.Mai, Y.J., Wang, X.L., Xiang, J.Y., Qiao, Y.Q., Zhang, D., Gu, C.D., and Tu, J.P.: CuO/graphene composite as anode materials for lithium-ion batteries. Electrochim. Acta 56, 2306 (2011).

Keywords

Metrics

Full text views

Total number of HTML views: 0
Total number of PDF views: 0 *
Loading metrics...

Abstract views

Total abstract views: 0 *
Loading metrics...

* Views captured on Cambridge Core between <date>. This data will be updated every 24 hours.

Usage data cannot currently be displayed