Crossref Citations
This article has been cited by the following publications. This list is generated based on data provided by
Crossref.
Stolyarov, V.V.
Zhu, Y.T.
Raab, G.I.
Zharikov, A.I.
and
Valiev, R.Z.
2004.
Effect of initial microstructure on the microstructural evolution and mechanical properties of Ti during cold rolling.
Materials Science and Engineering: A,
Vol. 385,
Issue. 1-2,
p.
309.
Zhu, Yuntian T.
and
Langdon, Terence G.
2004.
The fundamentals of nanostructured materials processed by severe plastic deformation.
JOM,
Vol. 56,
Issue. 10,
p.
58.
Stolyarov, V.V.
Shuster, L.Sh.
Migranov, M.Sh.
Valiev, R.Z.
and
Zhu, Y.T.
2004.
Reduction of friction coefficient of ultrafine-grained CP titanium.
Materials Science and Engineering: A,
Vol. 371,
Issue. 1-2,
p.
313.
Yapici, Guney Guven
Karaman, Ibrahim
and
Maier, Hans J.
2006.
Mechanical flow anisotropy in severely deformed pure titanium.
Materials Science and Engineering: A,
Vol. 434,
Issue. 1-2,
p.
294.
Kolobov, Yu.R.
and
Ivanov, Konstantin
2006.
Grain Boundary Diffusion-Controlled Processes and Properties of Bulk Nanostructured Alloys and Steels.
Materials Science Forum,
Vol. 503-504,
Issue. ,
p.
141.
Fan, G.J.
Fu, L.F.
Qiao, D.C.
Choo, H.
Liaw, P.K.
and
Browning, N.D.
2006.
Grain growth in a bulk nanocrystalline Co alloy during tensile plastic deformation.
Scripta Materialia,
Vol. 54,
Issue. 12,
p.
2137.
Stolyarov, V. V.
Valiev, R. Z.
and
Zhu, Y. T.
2006.
Enhanced low-temperature impact toughness of nanostructured Ti.
Applied Physics Letters,
Vol. 88,
Issue. 4,
Mingler, Bernhard
Stolyarov, V.V.
Zehetbauer, Michael
Lacom, Wolfgang
and
Karnthaler, Hans Peter
2006.
TEM Investigations of Titanium Processed by ECAP Followed by Cold Rolling.
Materials Science Forum,
Vol. 503-504,
Issue. ,
p.
805.
Zhu, Q.S.
Wang, Z.G.
Zeng, Q.L.
Wu, S.D.
and
Shang, J.K.
2008.
Rapid cycle-dependent softening of equal channel angularly pressed Sn–Ag–Cu alloy.
Journal of Materials Research,
Vol. 23,
Issue. 10,
p.
2630.
Xu, W.
Wu, X.
Sadedin, D.
Wellwood, G.
and
Xia, K.
2008.
Ultrafine-grained titanium of high interstitial contents with a good combination of strength and ductility.
Applied Physics Letters,
Vol. 92,
Issue. 1,
Zhao, Xicheng
Fu, Wenjie
Yang, Xirong
and
Langdon, Terence G.
2008.
Microstructure and properties of pure titanium processed by equal-channel angular pressing at room temperature.
Scripta Materialia,
Vol. 59,
Issue. 5,
p.
542.
Stolyarov, V.V.
Zeipper, L.
Mingler, B.
and
Zehetbauer, M.
2008.
Influence of post-deformation on CP-Ti processed by equal channel angular pressing.
Materials Science and Engineering: A,
Vol. 476,
Issue. 1-2,
p.
98.
Sun, Pei-Ling
Zhao, Y.H.
Cooley, J.C.
Kassner, M.E.
Horita, Z.
Langdon, T.G.
Lavernia, E.J.
and
Zhu, Y.T.
2009.
Effect of stacking fault energy on strength and ductility of nanostructured alloys: An evaluation with minimum solution hardening.
Materials Science and Engineering: A,
Vol. 525,
Issue. 1-2,
p.
83.
Alexandrov, Igor V.
2009.
Bulk Nanostructured Materials.
p.
311.
Bae, Gyuyeol
Kang, Kicheol
Kim, Jay-Jung
and
Lee, Changhee
2010.
Nanostructure formation and its effects on the mechanical properties of kinetic sprayed titanium coating.
Materials Science and Engineering: A,
Vol. 527,
Issue. 23,
p.
6313.
Li, Hui
Zheng, Lingxia
Shu, Shiwei
Cheng, Hua
and
Li, Yang Yang
2011.
Morphology Control of Anodic TiO2 Nanomaterials via Cold Work Pretreatment of Ti Foils.
Journal of The Electrochemical Society,
Vol. 158,
Issue. 10,
p.
C346.
Cheng, Lian Ping
Liang, Xiao Guang
San, Xing Yuan
Gong, Yu Lan
and
Zhu, Xin Kun
2011.
Effect of Stacking Fault Energy on the Mechanical Properties of Cold-Rolling Cu and Cu-Al-Zn Alloys.
Advanced Materials Research,
Vol. 399-401,
Issue. ,
p.
708.
Kumar, N.
Mishra, R. S.
Huskamp, C. S.
and
Sankaran, K. K.
2011.
The effect of friction stir processing on the microstructure and mechanical properties of equal channel angular pressed 5052Al alloy sheet.
Journal of Materials Science,
Vol. 46,
Issue. 16,
p.
5527.
Wang, Li Min
Gong, Zhi Hua
Yang, Gang
Liu, Zheng Dong
and
Bao, Han Sheng
2012.
Microstructure Evolution and Property of Austenitic Stainless Steel after ECAP.
Applied Mechanics and Materials,
Vol. 268-270,
Issue. ,
p.
291.
Zhu, Y.T.
Liao, X.Z.
and
Wu, X.L.
2012.
Deformation twinning in nanocrystalline materials.
Progress in Materials Science,
Vol. 57,
Issue. 1,
p.
1.