Hostname: page-component-848d4c4894-8kt4b Total loading time: 0 Render date: 2024-06-20T10:41:13.575Z Has data issue: false hasContentIssue false
  • English
  • Français

The starting mechanism of wave-induced flow through a sharp-edged orifice

Published online by Cambridge University Press:  12 April 2006

R. A. Evans  and
M. I. G. Bloor
R. A. Evans
Affiliation:
Department of Applied Mathematical Studies, University of Leeds, England
M. I. G. Bloor
Affiliation:
Department of Applied Mathematical Studies, University of Leeds, England
Get access Rights & Permissions [Opens in a new window]

Abstract

Following weak plane shock diffraction at a knife-edge situated in a duct, a two-dimensional vortex sheet springs from the salient edge. The method of ‘vortex discretization’ is used, in conjunction with a Schwarz-Christoffel transformation, to develop a two-dimensional potential model for this constrained form of vortex generation. The analysis is independent of empirical parameters and describes, qualitatively, the pattern of streamlines through the orifice.

Flow-visualization photographs are presented which illustrate the spiral shape of the starting vortex. Although of a limited nature, quantitative experimental vortex growth rates have been obtained and are compared with initial growth rates predicted theoretically. The results are discussed together with other aspects of the problem, including the limitations of the theory.

An extension of vortex discretization is developed whereby the pressure distribution remote from the vortex sheet can be calculated. The combination of flow separation and the associated static wall pressure distribution gives theoretical insight into the mechanism of flow through an orifice.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 82 , Issue 1 , 19 August 1977 , pp. 115 - 128
Copyright
© 1977 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Chorin, A. J. & Bernard, P. S. 1973 Discretisation of a vortex sheet with an example of roll-up. J. Comp. Phys. 13, 423.Google Scholar
Clements, R. R. 1973 An inviscid model of two-dimensional vortex shedding. J. Fluid Mech. 57, 321.Google Scholar
Clements, R. R. & Maull, D. J. 1975 The representation of sheets of vorticity by discrete vortices. Prog. Aerospace Sci. 16, 129.Google Scholar
Dadone, A. & Pandolfi, M. 1971 Interaction of travelling shock waves with orifices inside ducts. Int. J. Mech. Sci. 13, 1.Google Scholar
Davies, P. O. A. L., Hardin, J. C., Edwards, A. J. V. & Mason, J. P. 1975 A calculation of jet noise from a potential flow model. 2nd Aeroacoust. Specialists Conf., A.I.A.A. Paper no. 75–741.Google Scholar
Emrich, R. J. & Reichenbach, H. 1969 Photographic study of early stages of vortex formation behind an edge. Proc. 7th Shock Tube Symp., Univ. Toronto, p. 740.
Fage, A. & Johansen, F. C. 1927 The structure of vortex sheets. Phil. Mag. (7), 5, 417.
Fink, P. T. & Soh, W. K. 1974 Calculation of vortex sheets in unsteady flow and application in ship hydrodynamics. 10th Symp. Naval Hydrodyn., Cambridge, Mass.
Gerrard, J. H. 1967 Numerical computation of the magnitude and frequency of the lift on a circular cylinder. Phil. Trans. Roy. Soc. A 261, 137.Google Scholar
Howard, L. N. & Matthews, D. L. 1956 On the vortices produced in shock diffraction. J. Appl. Phys. 27, 223.Google Scholar
Küchemann, D. & Weber, J. 1965 Vortex motions. Z. angew. Math. Mech. 45, 457.Google Scholar
Kuwahara, K. 1973 Numerical study of the flow past an inclined flat plate by an inviscid model. J. Phys. Soc. Japan 35, 1545.Google Scholar
Kuwahara, K. & Takami, H. 1973 Numerical studies of two-dimensional vortex motion by a system of point vortices. J. Phys. Soc. Japan 34, 247.Google Scholar
Merzkirch, W. 1964 Theoretische und experimentalle Untersuchungen an einer instationaren Wirbelstromunug. Z. Flugwiss. 12, 395.Google Scholar
Milne-Thomson, L. M. 1968 Theoretical Hydrodynamics. Macmillan.
Moore, D. W. 1974 A numerical study of the roll-up of a finite vortex sheet. J. Fluid Mech. 63, 225.Google Scholar
Reichenbach, H. 1960 Investigation by spark cinematography of the behaviour pattern of vortices. Proc. 5th Int. Cong. High Speed Photography, p. 530.
Reichenbach, H. & Merzkirch, W. 1964 Untersuchungen uber das Ahnlichkeitsverhalten einer instationaren Wirbelspirale. Z. Flugwiss. 12, 219.Google Scholar
Rott, N. 1956 Diffraction of a weak shock wave with vortex generation. J. Fluid Mech. 1, 111.Google Scholar
Sacks, A. H., Lundberg, R. E. & Hanson, C. W. 1967 A theoretical investigation of the aerodynamics of slender wing-body combinations exhibiting leading-edge separation. N.A.S.A. Current Rep. no. 719.Google Scholar
Sarpkaya, T. 1968 An analytical study of separated flow about circular cylinders. J. Basic Engng, Trans. A.S.M.E. D 90, 511.Google Scholar
Sarpkaya, T. 1975a An inviscid model of two-dimensional vortex shedding for transient and asymptotically steady separated flow over an included plate. J. Fluid Mech. 68, 109.Google Scholar
Sarpkaya, T. 1975b Comment on ‘Theoretical study of lift-generated vortex wakes designed to avoid roll-up’. A.I.A.A. J. 13, 1680.Google Scholar
Schardin, H. 1958 Ein Beispiel zur Verwendung des Stosswellenrohres für Probleme der instationaren Gasdynamik. Z. angew. Math. Phys. 9, 606. (Ciné film available from U.S. National Committee for Fluid Mechanics Films.)Google Scholar
Waldron, H. F. 1954 An experimental study of a spiral vortex formed by shock wave diffraction. U.T.I.A. Tech. Note no. 2. University of Toronto.Google Scholar