Hostname: page-component-76fb5796d-dfsvx Total loading time: 0 Render date: 2024-04-26T09:03:02.697Z Has data issue: false hasContentIssue false
  • English
  • Français

One-dimensional closure models for three-dimensional incompressible viscoelastic free jets: von Kármán flow geometry and elliptical cross-section

Published online by Cambridge University Press:  21 April 2006

S. E. Bechtel ,
M. G. Forest ,
D. D. Holm  and
K. J. Lin
S. E. Bechtel
Affiliation:
Department of Engineering Mechanics, The Ohio State University, Columbus, OH 43210, USA
M. G. Forest
Affiliation:
Department of Mathematics, The Ohio State University, Columbus, OH 43210, USA
D. D. Holm
Affiliation:
Center for Nonlinear Studies and Theoretical Division, Los Alamos National Laboratory, MS B284, Los Alamos, NM 87545, USA
K. J. Lin
Affiliation:
Department of Engineering Mechanics, The Ohio State University, Columbus, OH 43210, USA
Get access Rights & Permissions [Opens in a new window]

Abstract

In this paper we derive one-space-dimensional, reduced systems of equations (one-dimensional closure models) for viscoelastic free jets. We begin with the three-dimensional system of conservation laws and a Maxwell-Jeffreys constitutive law for an incompressible viscoelastic fluid. First, we exhibit exact truncations to a finite, closed system of one-dimensional equations based on classical velocity assumptions of von Kármán (1921). Next, we demonstrate that the three-dimensional free-surface boundary conditions overconstrain these truncated systems, so that only a very limited class of solutions exist. We then proceed to derive approximate one-dimensional closure theories through a slender-jet asymptotic scaling, combined with appropriate definitions of velocity, pressure and stress unknowns. Our non-axisymmetric one-dimensional slender-jet models incorporate the physical effects of inertia, viscoelasticity (viscosity, relaxation and retardation), gravity, surface tension, and properties of the ambient fluid, and include shear stresses and time dependence. Previous special one-dimensional slender-jet models correspond to the lowest-order equations in the present asymptotic theory by an a posteriori suppression to leading order of some of these effects, and a reduction to axisymmetry. We thereby: (i) derive existing one-dimensional models from the three-dimensional free surface boundary-value problem; (ii) clarify the sense of the one-dimensional approximation; (iii) deduce new one-dimensional closure models for non-axisymmetric viscoelastic free jets.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 196 , November 1988 , pp. 241 - 262
Copyright
© 1988 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Antmann, S. S. 1972 The theory of rods. In Handbuch der Physik, vol. 6, pp. 641–703. Springer.
Bechtel, S. E., Bogy, D. B. & Forest, M. G. 1986 A one-dimensional theory for viscoelastic fluid jets, with application to extrudate swell and draw-down under gravity. J. Non-Newtonian Fluid Mech. 21, 273–308.Google Scholar
Bechtel, S. E., Bolinger, K. D. & Forest, M. G. 1988 Axisymmetric viscoelastic free jets with torsion. In preparation.
Bechtel, S. E. & Forest, M. G. 1988 On free surface boundary conditions in closure models for viscoelastic jets. In preparation.
Bechtel, S. E., Forest, M. G. & Hyman, J. M. 1988 Effective relaxation and retardation times for viscoelastic free jets. In preparation.
Bechtel, S. E., Forest, M. G. & Lin, K. J. 1987 Effective stress rates of viscoelastic free jets. J. Non-Newtonian Fluid Mech. 26, 1–41.Google Scholar
Bechtel, S. E., Forest, M. G. & Lin, K. J. 1988a On the behavior of viscoelastic free jets with elliptical cross section. J. Non-Newtonian Fluid Mech. 27, 87–126.Google Scholar
Bechtel, S. E., Forest, M. G. & Lin, K. J. 1988b One-dimensional closure models for three-dimensional incompressible viscoelastic free jets: higher-order flow perturbations. Submitted to J. Fluid Mech.Google Scholar
Beris, A. N. & Liu, B. 1988 Time-dependent fiber spinning equations. 1. Analysis of the mathematical behavior. J. Non-Newtonian Fluid Mech. 26, 341–361.Google Scholar
Caulk, D. A. & Naghdi, P. M. 1979a The influence of twist on the motion of straight elliptical jets. Arch. Rat. Mech. Anal. 69, 1–30.Google Scholar
Caulk, D. A. & Naghdi, P. M. 1979b On the onset of breakup in inviscid and viscous jets. J. Appl. Mech. 46, 291–297.Google Scholar
Caulk, D. A. & Naghdi, P. M. 1987 Axisymmetric motion of a viscous fluid inside a slender surface of revolution. J. Appl. Mech. 54, 190–196.Google Scholar
Denn, M. M. 1983 Fiber spinning. In Computational Analysis of Polymer Processing (ed. J. R. A. Pearson & S. M. Richardson), pp. 179–216. Applied Science.
Denn, M. M. & Marrucci, G. 1977 Effect of a relaxation time spectrum on mechanics of polymer melt spinning. J. Non-Newtonian Fluid Mech. 2, 159–167.Google Scholar
Denn, M. M., Petrie, C. J. S. & Avenas, P. 1975 Mechanics of steady spinning of a viscoelastic liquid. AIChE J. 21, 791–799.Google Scholar
Fisher, R. J. & Denn, M. M. 1976 A theory of isothermal melt spinning and draw resonance. AIChE. J. 22, 236–246.Google Scholar
Green, A. E. 1975 Compressible fluid jets. Arch. Rat. Mech. Anal. 59, 189–205.Google Scholar
Green, A. E. 1976 On the non-linear behavior of fluid jets. Intl J. Engng Sci. 14, 49–63.Google Scholar
Green, A. E., Naghdi, P. M. & Wenner, M. L. 1974a On the theory of rods. 1. Derivations from the three-dimensional equations. Proc. R. Soc. Lond. A 337, 451–483.Google Scholar
Green, A. E., Naghdi, P. M. & Wenner, M. L. 1974a On the theory of rods. 2. Developments by direct approach. Proc. R. Soc. Lond. A 337, 485–507.Google Scholar
Gupta, R. K., Puszynski, J. & Sridhar, T. 1986 Steady spinning of the Oldroyd fluid B. 1. Theory. J. Non-Newtonian Fluid Mech. 21, 99–113.Google Scholar
Joseph, D. D., Matta, J. E. & Nguyen, K. 1983 Jets into liquid under gravity. J. Fluid Mech. 128, 443–468.Google Scholar
Kármán, T. von 1921 Über Laminare und Turbulente Reibung. Z. angew. Math. Mech. 1, 233–252.Google Scholar
Kase, S. 1974 Studies on melt spinning. 3. Velocity field within the thread. J. Appl. Polymer Sci. 18, 3267–3278.Google Scholar
Matovich, M. A. & Pearson, J. R. A. 1969 Spinning a molten threadline. Ind. Engng Chem. Fundam. 8, 512–520.Google Scholar
Naghdi, P. M. 1979 Fluid jets and fluid sheets: a direct formulation. Proc. 12th Symp. on Naval Hydrodynamics, pp. 500–515. National Academy of Sciences, Washington, DC.
Naghdi, P. M. 1981 Finite deformation of elastic rods and shells. In Proc. of IUTAM Symp. on Finite Elasticity, Lehigh University (ed. R. T. Shield), pp. 47–103. The Hague: Martinus Nijhoff.
Petrie, C. J. S. 1979 Elongational Flows. Pitman.
Phan-Thien, N. 1983 Coaxial-disk flow and flow about a rotating disk of a Maxwellian fluid. J. Fluid Mech. 128, 427–442.Google Scholar
Phan-Thien, N. & Caswell, B. 1986 A nearly-elongational flow analysis of the fibre spinning flow. J. Non-Newtonian Fluid Mech. 21, 225–234.Google Scholar
Schultz, W. W. & Davis, S. H. 1982 One-dimensional liquid fibers. J. Rheol. 26, 331–345.Google Scholar
Tanner, R. I. 1985 Engineering Rheology. Clarendon Press.