Hostname: page-component-848d4c4894-75dct Total loading time: 0 Render date: 2024-06-04T05:49:41.507Z Has data issue: false hasContentIssue false
  • English
  • Français

Measurements and predictions of fully developed turbulent flow in a simulated rod bundle

Published online by Cambridge University Press:  20 April 2006

W. J. Seale
W. J. Seale
Affiliation:
School of Mechanical Engineering, University of Bradford, Richmond Road, Bradford BD7 1DP, U.K.
Get access Rights & Permissions [Opens in a new window]

Abstract

Fully developed air flow has been investigated over a Reynolds-number range of 82800-346700 in a duct that simulates two interconnected subchannels of a rod bundle with a pitchldiameter ratio of 1.20. Based on equivalent hydraulic diameter, friction factors were found to be 2% lower than for pipe flow. Detailed measurements were made at a Reynolds number of 200000 of axial velocities, secondary velocities, and the Reynolds stresses. The distribution of axial velocity near the walls (normalized with the local friction velocity) could be expressed by an inner law of the wall for y+ up to 1500. Distributions of the normal Reynolds stresses and the mean turbulence kinetic energy were similar to those observed in a number of pipe and two-dimensional channel flows and could be correlated using the axial-velocity fluct,uations normalized with the local friction velocity. Maximum secondary velocities were about 1.5 % of the bulk axial velocity. The ‘k-ε’ turbulence model and an algebraic vorticity source for generating secondary velocities enabled the computation of axial velocities, secondary velocities, and mean turbulence kinetic energies that are in satisfactory agreement with those measured.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 123 , October 1982 , pp. 399 - 423
Copyright
© 1982 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Alshamani, K. M. M. 1978 A.I.A.A. J. 16, 859.
Alshamani, K. M. M. 1979 Aero. J. 83, 159.
Aly, A. M. M., Trupp, A. C. & Gerrard, A. D. 1978 J. Fluid Mech. 85, 57.
Bartzis, J. G. & Todreas, N. E. 1979 Trans. A.S.M.E. C: J. Heat Transfer 101, 628.
Bearman, P. W. 1971 DISA Info. no. 11, p. 25.
Brundrett, E. & Baines, W. D. 1964 J. Fluid Mech. 19, 375.
Carajilescov, P. & Todreas, N. E. 1976 Trans. A.S.M.E. C: J. Heat Transfer 98, 262.
Gosman, A. D., Pun, W. M., Runchal, A. K., Spalding, D. B. & Wolfshtein, M. 1969 Heat and Mass Transfer in Recirculating Flows. Academic.
Gosman, A. D. & Rapley, C. W. 1980 Recent Advances in Numerical Methods in Fluids. Pineridge.
Hanjalic, K. & Launder, B. E. 1972 J. Fluid Mech. 52, 609.
Head, M. R. & Vasanta Ram, V. 1971 Aero. Q. 22, 295.
Hoagland, L. L. 1960 Ph.D. thesis, M.I.T.
Hooper, J. D. 1980 Nucl. Engng Des. 60, 365.
Kacker, S. C. 1973 J. Fluid Mech. 57, 583.
Kjellström, B. 1974 AB Atomenergi Rep. AE-487.
Launder, B. E. & Spalding, D. B. 1974 Comp. Methods Appl. Mech. & Engng 3, 269.
Launder, B. E. & Ying, W. M. 1972 J. Fluid Mech. 54, 289.
Launder, B. E. & Ying, W. M. 1973 Proc. Inst. Mech. Engrs 187, 455.
Malak, J., Hejna, J. & Schmid, J. 1975 Int. J. Heat Mass Transfer 18, 139.
Melling, A. & Whitelaw, J. H. 1976 J. Fluid Mech. 78, 289.
Mogola, O. O. 1974 DISA Info. no. 16, p. 11.
Nijsing, R. & Eifler, W. 1970 Des Deutschen Atomforums, Berlin.
Ota, S. & Kostic, Z. 1972 DISA Info. no. 13, p. 29.
Ower, E. & Pankhurst, R. C. 1966 The Measurement of Air Flow. Pergamon.
Patankar, S. V. & Spalding, D. B. 1970 Heat and Mass Transfer in Boundary Layers. Intertext.
Patel, V. C. 1965 J. Fluid Mech. 23, 185.
Rehme, K. 1973 Int. J. Heat Mass Transfer 16, 933.
Rehme, K. 1977 INR Rep. KFK 2441 (English Transl. UKAEA W.H. Transl. no. 404).
Rehme, K. 1978 Nucl. Engng Des. 45, 311.
Rowe, D. S., Johnson, B. M. & Knudsen, J. G. 1974 Int. J. Heat Mass Transfer 17, 407.
Seale, W. J. 1977 Ph.D. thesis, University of Bradford.
Seale, W. J. 1979 Nucl. Engng Des. 54, 197.
Seale, W. J. 1981 University of Bradford Mech. Engng Rep. no. 93.
Seale, W. J. 1982 J. Mech. Engng Sci. (to be published).
Trupp, A. C. & Aly, A. M. M. 1979 Trans. A.S.M.E. I: J. Fluids Engng 101, 354.
Trupp, A. C. & Azad, R. S. 1975 Nucl. Engng Des. 32, 47.