Hostname: page-component-68945f75b7-s56hc Total loading time: 0 Render date: 2024-08-05T09:58:02.432Z Has data issue: false hasContentIssue false

An experimental study of the steady and unsteady flow characteristics of stirred reactors

Published online by Cambridge University Press:  21 April 2006

M. Yianneskis
Affiliation:
Kings College London, Mechanical Engineering Department, Strand, London WC2R2LS, UK
Z. Popiolek
Affiliation:
Instytut Ogrzewnictwa, Wentylacji, i Ochrony Powietrza, Politechnika Slaska, 44 – 101 Gliwice, Poland
J. H. Whitelaw
Affiliation:
Fluids Section, Mechanical Engineering Department, Imperial College of Science and Technology, Exhibition Road, London SW7 2BK, UK

Abstract

Liquid flow in a baffled stirred reactor vessel driven by a six-blade disk impeller has been investigated experimentally. Laser-slit photography provided an overview of the flows which were quantified by measurements of velocity characteristics, obtained with a laser-Doppler anemometer, for an impeller rotational speed of 300 r.p.m. and for three impeller clearances from the bottom of the vessel. The mean flow results show an inclination of the impeller stream and the formation of ring vortices above and below the impeller, which depend on the clearance; the flow was strongly three-dimensional with large regions having circumferential velocities in a direction opposite to that of the impeller rotation. Impeller-induced torque measurements show that the Power number is invariant with clearance for turbulent-flow Reynolds numbers ([ges ] 40000) and increases with impeller diameter. The flow structure was controlled mainly by convection and pressure forces with turbulent mixing important in the impeller region.

Type
Research Article
Copyright
© 1987 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Cutter, L. A. 1966 Flow and turbulence in a stirred tank. AIChE J. 12, 35.Google Scholar
Günkel, A. A. & Weber, M. E. 1975 Flow phenomena in stirred tanks. AIChE J. 21, 931.Google Scholar
Issa, R. I. & Gosman, A. D. 1981 The computation of three-dimensional turbulent two-phase flows in mixer vessels. Proc. Second Intl Conf. on Numerical Methods in Laminar and Turbulent flow, Venice, 13–16 July 1981.Google Scholar
Melling, A. & Whitelaw, J. H. 1976 Turbulent flow in a rectangular duct. J. Fluid Mech. 78, 289.Google Scholar
Mujumdar, A. S., Huang, B., Wolf, D., Weber, M. E. & Douglas, W. J. M. 1970 Turbulence parameters in a stirred tank. Can. J. Chem. Engng 48, 475.Google Scholar
Reed, X. B., Princz, M. & Hartland, S. 1977 Laser-Doppler measurements of turbulence in a standard stirred tank. Second European Conf. on Mixing, Cambridge, 30 March-1 April 1977.
Revill, B. K 1982 Pumping capacity of disc turbine agitators - a literature review. Fourth European Conf. on Mixing, Noordwijkerhout, Netherlands, 27–29 April 1982.
Uhl, V. W. & Gray, J. B. 1966 Mixing-Theory and Practice. Academic.
van der Molen, K. & van Maanen, H. R. E. 1978 Laser-Doppler measurements of the turbulent flow in stirred vessels to establish scaling rules. Chem. Engng Sci. 33, 1161.Google Scholar
van't Riet, K. & Smith, J. M. 1973 The behaviour of gas-liquid mixtures near Rushton turbine blades. Chem. Engng Sci. 28, 1031.Google Scholar
van't Riet, K. & Smith, J. M. 1975 The trailing vortex system produced by Rushton turbine agitators. Chem. Engng Sci. 30, 1093.Google Scholar
van't Riet, K., Bruijn, W. & Smith, J. M. 1976 Real and pseudo-turbulence in the discharge stream from a Rushton turbine. Chem. Engng Sci. 31, 407.Google Scholar
Yianneskis, M., Popiolek, Z. & Whitelaw, J. H. 1984 Imperial College. Mech. Engng Dept Rep. FS/84/02.