Hostname: page-component-7479d7b7d-8zxtt Total loading time: 0 Render date: 2024-07-12T15:08:36.447Z Has data issue: false hasContentIssue false

Effects caused by small discrete two-dimensional roughness elements immersed in turbulent boundary layers

Published online by Cambridge University Press:  20 April 2006

H. H. Nigim
Affiliation:
Faculty of Engineering, Bir Zeit University, West Bank
D. J. Cockrell
Affiliation:
Department of Engineering, University of Leicester

Abstract

In order to determine the downstream consequences of the presence of small discrete surface discontinuities situated on otherwise smooth surfaces and subjected to six equilibrium two-dimensional adverse-pressure-gradient turbulent boundary-layer flows, these conditions were first established in a special-purpose wind tunnel. A surface discontinuity is small if it lies within the logarithmic region of the undisturbed boundary layer. Immediately downstream of such discontinuities flow separation ensues. After the subsequent reattachment, measurements were made of the downstream boundary-layer development. Even in strong adverse pressure gradients the local increments of momentum thickness caused by these roughness elements were well predicted by Gaudet & Johnson's zero-pressure-gradient correlation. With highly adverse pressure gradients it was found that these small surface discontinuities have little influence on the flow downstream. The essential outcome of this work is that the incremental drag of small roughness elements depends solely on local wall variables. Thus, when the pressure gradient is strongly adverse and the local skin friction is correspondingly small, the incremental drag of the roughness element becomes similarly small. After reattachment, it has an insignificant effect on the flow downstream of it.

Type
Research Article
Copyright
© 1985 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Abd Rabbo, M. F. 1976 Aerodynamic drag of ridge arrays in adverse pressure gradients. Ph.D. Thesis, Univ. of Leicester.
Arie, M. & Rouse, H. 1956 J. Fluid Mech. 1, 129.
Barnes, C. S. 1965 CP863, Aeronautical Research Centre 26, 677.
Bradshaw, P. 1967 J. Fluid Mech. 29, 625.
Bradshaw, P. & Wong, F. Y. F. 1972 J. Fluid Mech. 52, 113.
De Brederode, V. & Bradshaw, P. 1972 Imperial College Aero. Rep. 72-19.
Clauser, F. H. 1954 J. Aero. Sci. 21, 91.
Coles, D. E. & Hirst, E. A. (eds) 1969 Proceedings Computation of Turbulent Boundary Layers, Vol. II, 1968 AFOSR-IFP - Thermosciences Division Stanford University.
East, L. F., Sawyer, W. G. & Nash, C. R. 1979 Royal Aircraft Establishment Tech. Rep. 79040.
East, L. F., Smith, P. D. & Merryman, P. J. 1977 Royal Aircraft Establishment Tech. Rep. 77046.
Eaton, J. K. & Johnston, J. P. 1981 AIAA J. 19, 1093.
Gaudet, L. & Johnson, P. 1970 Royal Aircraft Establishment Tech. Rep. 70190.
Gaudet, L. & Winter, K. G. 1973 AGARD Conf. Proc. 124, Paper No. 4.
Good, M. C. & Joubert, P. N. 1968 J. Fluid Mech. 31, 547.
Keuhn, D. M. 1980 AIAA J. 18, 323.
Lacey, J. 1974 The aerodynamic drag of square ridges. M.Sc. Thesis, Univ. of Leicester.
Nash, J. F. & Bradshaw, P. 1967 J. R. Aero. Soc. 71, 44.
Pallister, K. C. 1974 Aircraft Research Association Rep. 37.
Petryk, S. & Brundrett, E. 1967 Waterloo Univ. Mech. Engng Res. Rep. No. 4.
Plate, E. J. & Lin, C. W. 1964 Colorado State Univ. CER-65-EJP-14, AD-614067.
Rotta, J. C. 1962 Prog. Aero Sci. 2, 5.
Tillmann, W. 1945 Zentralle Wissenschaftliche Berifte U & M 6627 [English transl. Ministry of Aircraft Production-VG-34-45T].
Wieghardt, K. 1942 Zentralle Wissenschaftliche Berifte FB 1563.
Winter, K. G. & Gaudet, L. 1967 Royal Aircraft Establishment Tech. Memo. Aero 1005.