Hostname: page-component-8448b6f56d-mp689 Total loading time: 0 Render date: 2024-04-25T04:14:21.168Z Has data issue: false hasContentIssue false
  • English
  • Français

Fatigue of Unmachined Aluminium Alloy Extrusions

Published online by Cambridge University Press:  07 June 2016

K. W. Gunn  and
A. R. Woodward
K. W. Gunn
Affiliation:
Aluminium Laboratories Limited
A. R. Woodward
Affiliation:
Aluminium Laboratories Limited
Get access

Summary

The fatigue properties of unmachined extrusions of high-strength aluminium-copper alloys are known to be lower than those of conventional fully-machined test pieces. Work described in this note has shown that the removal of a layer of metal 0·025 in. thick from the surface of B.S. L65-type extrusions results in an increase in fatigue properties to values approaching those obtained from the conventional laboratory test pieces. Because the removal of material from the surface is not always a practical proposition, other methods of improving strength have been examined and the effect of surface compressive stresses has been shown to be beneficial. Sufficient compressive stress can be induced by surface-rolling to increase the fatigue properties to those of conventional specimens, but this method can only be easily applied to round sections and it is suggested that shot-peening or vapour-blasting could be used for more complicated sections.

Type
Research Article
Information
Aeronautical Quarterly , Volume 13 , Issue 3 , August 1962 , pp. 271 - 274
Copyright
Copyright © Royal Aeronautical Society. 1962

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Forrest, G. and Woodward, A. R. Report on Fatigue of Complete Extruded Sections. Ministry of Supply S. & T. Memo. No. 10/50, 1950.Google Scholar
2. Cox, H. L. and Coleman, E. P. A Note on Repeated Loading Tests on Components and Complete Structures. Journal of the Royal Aeronautical Society, Vol. 54, p. 1, 1950.CrossRefGoogle Scholar
3. Forrest, G. Some Experiments on the Effects of Residual Stresses on the Fatigue of Aluminium Alloys. Journal of the Institute of Metals, Vol. 72, Part 1, p. 1, 1946.Google Scholar
4. Harris, W. J. Metallic Fatigue. Pergamon Press, 1961.Google Scholar