Hostname: page-component-7479d7b7d-jwnkl Total loading time: 0 Render date: 2024-07-08T19:11:24.517Z Has data issue: false hasContentIssue false
  • English
  • Français

The Compressible Laminar Boundary Layer on a Yawed Infinite Wing*

Published online by Cambridge University Press:  07 June 2016

L. F. Crabtree
Get access

Summary

A study of the laminar boundary layer on a yawed infinite wing in a compressible fluid is made. A method is presented for the investigation of compressibility effects by direct solution of the linearised equations of motion, first considerably simplified by the extension of a transformation due to Illingworth and Stewartson, which assumes a heat-insulated surface and a fluid of unit Prandtl number and a coefficient of viscosity which is proportional to the absolute temperature. As an example of this procedure the boundary layer near a stagnation point is calculated. The simplifications necessary for an extension of the momentum method, which is available for a yawed infinite wing in an incompressible fluid, are discussed, and this method is recommended for a first evaluation of the effect of compressibility.

Type
Research Article
Information
Aeronautical Quarterly , Volume 5 , Issue 2 , July 1954 , pp. 85 - 100
Copyright
Copyright © Royal Aeronautical Society. 1954

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

*

Based on part of a thesis presented in partial fulfilment of the requirements for the degree of Ph.D., Cornell University.

References

1. Rott, N. and Crabtree, L. F. (1952). Simplified Laminar Boundary Layer Calculations for Bodies of Revolution and for Yawed Wings. Journal of the Aeronautical Sciences, Vol. 19, pp. 553–565, 1952.CrossRefGoogle Scholar
2. Crabtree, L. F. (1952). The Laminar Boundary Layer on a Yawed Infinite Cylinder. Thesis, Cornell University, September 1952.Google Scholar
3. Prandtl, L. (1946). Ueber Reibungsschichten bei dreidimensionalen Strömungen. British M.A.P. Volkenrode Report and Translation No. 64, 1946.Google Scholar
4. Jones, R. T. (1947). Effects of Sweep-back on Boundary Layer and Separation. N.A.C.A. T.N. 1402 (1947), and N.A.C.A. Report 884 (1949).Google Scholar
5. Sears, W. R. (1948). The Boundary Layer of Yawed Cylinders. Journal of the Aeronautical Sciences, Vol. 15, pp. 49–52, 1948.Google Scholar
6. Struminsky, V. V. (1946). Sideslip in a Viscous Compressible Gas. Dokl. Akad. Nauk., SSSR. T.54, 1946 (also N.A.C.A. T.M. 1276).Google Scholar
7. Moore, F. K. (1951). Three-dimensional Compressible Laminar Boundary Layer Flow. N.A.C.A. T.N. 2279, 1951.Google Scholar
8. Goldstein, S. (editor) (1938). Modern Developments in Fluid Dynamics, Vol. 1, Oxford, 1938.Google Scholar
9. Howarth, L. (1934). Steady Flow in the Boundary Layer near the Surface of a Cylinder in a Stream. R. & M. 1632, 1934.Google Scholar
10. Cooke, J. C. (1950). The Boundary Layer of a Class of Infinite Yawed Cylinders. Proc. Camb. Phil. Soc, Vol. 46, pp. 645–648, 1950.Google Scholar
11. Illinoworth, C. R. (1949). Steady Flow in the Laminar Boundary Layer of a Gas. Proc. Roy. Soc, Vol. 199, pp. 533–558, 1949.Google Scholar
12. Stewartson, K. (1949). Correlated Incompressible and Compressible Boundary Layers. Proc. Roy. Soc, Vol. 200, pp. 84–100, 1949.Google Scholar