Hostname: page-component-5c6d5d7d68-pkt8n Total loading time: 0 Render date: 2024-08-17T15:30:39.861Z Has data issue: false hasContentIssue false

Proton Induced X-Ray Fluorescence Analysis Using a Cockcroft-Walton Accelerator

Published online by Cambridge University Press:  06 March 2019

D. I. Bales
Affiliation:
Bionucleonics Department, Purdue University, West Lafayette, Indiana 47907
R. R. Landolt
Affiliation:
Bionucleonics Department, Purdue University, West Lafayette, Indiana 47907
W. E. Toll
Affiliation:
Bionucleonics Department, Purdue University, West Lafayette, Indiana 47907
Get access

Abstract

The production of characteristic x rays by 100-keV protons has been studied to determine the feasibility of using a Cockcroft- Walton accelerator as an excitation source for x ray fluorescence analysis. Because of the low cross sections at this proton energy, it was necessary to concentrate on characteristic x rays below 6 keV and to use beam currents of 10 to 100 μA. The x rays were measured by a high resolution Si(Li) detector.

The preparation of various types of samples and the problems that arise when working at low proton energies and high beam currents are discussed.

It was found that the technique is useful for low atomic number elements down to less than 1 ppm in a water sample when there are no other significant impurities. When other elements are present, however, proton absorption becomes an important factor and quantitative determinations become very difficult. Proton absorption and its effect upon the usefulness of the technique are discussed.

The precision for the technique was determined and found to be better than 20% for most measurements. This includes errors in sample preparation which was considered to be a significant portion of the uncertainty.

Type
Research Article
Copyright
Copyright © International Centre for Diffraction Data 1974

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Johansson, T. B., Akselsson, R. and Johansson, S. A. E., “Proton- Induced X-Ray Emission Spectroscopy in Elemental Trace Analysis,” Advan. X-Ray Anal., 15, 373387 (1971).Google Scholar
2. Spaulding, J, D., “K-Shell Ionization Cross Sections of Te, V, Cr, Mn, Fe, Co, Ni, and Cu for Protons at 100, 125, and 150 keV,” M. S. thesis, University of Tennessee, Knoxville, Tennessee, 1970.Google Scholar
3. Brandt, W., Laubert, R. and Sellin, I., “Characteristic X-Ray Production in Magnesium, Aluminum, and Copper by Low-Energy Hydrogen and Helium Ions,” Phys. Rev., 151, no. 1, 5659 (1966).Google Scholar
4. Khan, J. M. and Potter, D. L., “Characteristic K-Shell X-Ray Production in Magnesium, Aluminum, and Copper by 60 to 500- keV Protons,” Phys. Rev., 133, no. 3A, A890-A894 (1964).Google Scholar
5. Beck, W. L., “K-Shell Ionization Cross Section for Ag and L-Shell Ionization Cross Sections for Au, Bi, and U for Protons from 1.0 to 5.0 MeV,” M. S. thesis, University of Tennessee, Knoxville, Tennessee, 1971.Google Scholar
6. Khan, J. M., Potter, D. L. and Worley, R. D., “Studies in X-Ray Production by Proton Bombardment of C, Mg, A l, Nd, Sm, Gd, Tb, Dy, and Ho,” Phys. Rev., 139, no. 6A, A1735-A1746 (1965).Google Scholar