Hostname: page-component-76fb5796d-dfsvx Total loading time: 0 Render date: 2024-04-28T16:08:58.015Z Has data issue: false hasContentIssue false
  • English
  • Français

Thermally Induced Imprint of PZT and SBT Thin Films

Published online by Cambridge University Press:  10 February 2011

Dong-Joo Kim ,
Seung-Hyun Kim ,
Jon-Paul Maria  and
Angus I. Kingon
Dong-Joo Kim
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695
Seung-Hyun Kim
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695
Jon-Paul Maria
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695
Angus I. Kingon
Affiliation:
Department of Materials Science and Engineering, North Carolina State University, Raleigh, NC 27695
Get access

Abstract

The imprint characteristics of chemical solution deposited Pb(Zr,Ti)O3 (PZT) and SrBi2Ta2O9(SBT) thin films have been investigated. The imprint properties were evaluated by polarization-electric field hysteresis measurements. Imprint was measured at the elevated temperatures to accelerate imprint rate. Several parametric variables such as voltage and DC bias were also used to investigate possible imprint mechanisms. To quantify imprint, two different standards for evaluation of ferroelectric capacitors were compared: voltage shift and asymmetric polarization shift. Two types of PZT thin films with the same Zr/Ti composition were prepared to investigate the influence of loop shape on the rate of imprint. In addition, the imprint behavior of SBT was also investigated. It is shown that the imprint rate is strongly dependent upon the method of evaluation as well as the loop shape.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 541: Symposium O – Ferroelectric Thin Films VII , 1998 , 469
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Kim, S.H., Kim, D.J., Hong, J.G., Streiffer, S.K., and Kingon, A.I., Integrated Ferroelectrics, 22, 133 (1998).Google Scholar
2. Traynor, S.D., Hadnagy, T.D., and Kammerdiner, L., Integrated Ferroelectrics, 16, 63 (1997).Google Scholar
3. Suizu, R.I. and Chapman, S.P., Integrated Ferroelectrics, 16, 87 (1997).Google Scholar
4. Warren, W.L., Tuttle, B.A., Dimos, D., Pike, G.E., Al-Shareef, H.N., Ramesh, R., and Evans, J.T. Jr, Jpn.J.Appl.Phys., 35, 1521 (1996).Google Scholar
5. Mihara, T., Watanabe, H., and Araujo, C.A. Paz de, Jpn.J.Appl.Phys., 32, 4168 (1993).Google Scholar
6. Warren, W.L., Al-Shareef, H.N., Dimos, D., Tuttle, B.A., and Pike, G.E., Appl.Phys.Lett., 68, 1681 (1996).Google Scholar
7. Lee, J.J., Thio, C.L., and Desu, S.B., Phys.Stat.Sol.(a), 151, 171 (1995).Google Scholar
8. Sadashivan, S., Aggarwal, S., Song, T.K., Ramesh, R., Evans, J.T. Jr, Tuttle, B.A., Warren, W.L., and Dimos, D., J.Appl.Phys., 83, 2165 (1998).Google Scholar
9. Warren, W.L., Dimos, D., Pike, G.E., Tuttle, B.A., and Raymond, M.V., Ramesh, R., Evans, J.T. Jr, Appl.Phys.Lett., 67, 866 (1995).Google Scholar
10. Grossmann, M., Lohse, O., Bolten, D., Waser, R., Hartner, W., Schindler, G., Dehm, C., Nagel, N., Joshi, V., Solayappan, N., and , Dergenwick, Integrated Ferroelectrics, 22, 95 (1998).Google Scholar
11. Al-Shareef, H.N., Dimos, D., Warren, W.L., and Tuttle, B.A., J.Appl.Phys, 80, 4573 (1996).Google Scholar