Hostname: page-component-77c89778f8-n9wrp Total loading time: 0 Render date: 2024-07-16T23:59:23.191Z Has data issue: false hasContentIssue false
  • English
  • Français

Tailoring Suspension Flow for the Gelcasting of Oxide and Nonoxide Ceramics

Published online by Cambridge University Press:  21 February 2011

O. O. Omatete  and
A. Bleffir
O. O. Omatete
Affiliation:
Oak Ridge National Laboratory, P. O. Box 2008, Oak Ridge, TN 37831
A. Bleffir
Affiliation:
Oak Ridge National Laboratory, P. O. Box 2008, Oak Ridge, TN 37831
Get access

Abstract

The rheology of gelcasting slurries of concentrated (30 - 60 vol%) alumina, zirconia, silicon nitride, and sialon powders with isoelectric points varying between pH 5 and 9, was studied by measuring the viscosity and yield stress as functions of pH. Typically, the rheology is non-Newtonian. The lowest values of viscosity and yield stress that permit the highest solids loading were obtained at high and low pH values, where the powders are colloidally stable, far from the isoelectric points. This relationship applies whether or not a polymer dispersant is present. The acrylamide monomer which is used in gelcasting slurries, lowers these non-Newtonian properties permitting the preparation of more concentrated slurries. Fluid and pourable gelcasting slurries of each powder had apparent viscosities and yield stresses less than 2.0 Pa·s and 50 Pa, respectively.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 346: Symposium N – Better Ceramics Through Chemistry VI , 1994 , 357
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Omatete, O. O., Janney, M. A., and Strehlow, R. A., Am. Ceram. Soc. Bull. 70 (10), 1641-1649(1991).Google Scholar
2 Young, A. C., Omatete, O. O., Janney, M. A., and Menchhofer, P. A.. J. Am. Ceram. Soc. 74 (3), 612-618 (1991).Google Scholar
3 Omatete, O. O., Bleier, A., Westmoreland, C. G., and Young, A. C., Ceram. Eng. Sci. Proc. 12 (9-10) 2083-2094 (1991).Google Scholar
4 Omatete, O. O., and Bleier, A., “Evaluation of Dispersants for Gelcasting” in Dispersion and Aggregation of Particulate Suspensions, Engineering Foundation, NY (in press).Google Scholar
5 Bleier, A., Omatete, O. O., and Westmoreland, C. G., Mat. Res. Soc. Symp. Proc. 271. 269-275 (1992).Google Scholar
6 Hunter, R. J., Foundations of Colloid Science. Vol I & II, Oxford Univ Press, NY (1992).Google Scholar