Hostname: page-component-848d4c4894-sjtt6 Total loading time: 0 Render date: 2024-06-16T21:44:56.458Z Has data issue: false hasContentIssue false
  • English
  • Français

Study of Chemical Compatibility and Interfacial Resistance Between Oxide Cathode Materials and A LaGao3 –Based Electrolyte for Solid Oxide Fuel Cells

Published online by Cambridge University Press:  10 February 2011

Weitung Wang  and
Eric. E. Hellstrom
Weitung Wang
Affiliation:
Department of Materials Science and Engineering University of Wisconsin-Madison, Madison, WI 53706
Eric. E. Hellstrom
Affiliation:
Department of Materials Science and Engineering University of Wisconsin-Madison, Madison, WI 53706
Get access

Abstract

The chemical compatibility of (La0.6Sr0.4)MnO3 (LSM), (La0.6Sr0.4)CoO3 (LSC), (La0.6Sr0.4)(Co0.2Fe0.8)O3 (LSCF), and (La1.7Sr0.3)CuO4 (LSU) as cathode materials with the oxygen conductor (La0.9Sr0.l)(Ga0.8Mg0.2)O3-δ (LSGM) was studied. The interfacial resistance between the cathode materials and LSGM was measured using AC impedance spectroscopy. The same studies were done with yttria-stabilized zirconia (YSZ) electrolyte. The results showed that no new compounds formed between LSGM and the cathode materials LSM, LSC, and LSCF up to at least 1200°C; however, a solid solution formed between the materials. With YSZ, only LSM did not form new compounds, and no solid solutions formed. The interfacial resistance was much lower between all the cathode materials and LSGM than YSZ. The lowest interfacial resistances were for LSC/LSGM and LSCF/LSGM, which are suggested for medium temperature solid oxide fuel cells.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 411: Symposium T – Electricaly-Based Microstructural Characterization , 1995 , 261
Copyright
Copyright © Materials Research Society 1996

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Ishihara, T., Matsuda, H. and Takita, Y., J. Am. Chem. Soc. 116, 3801, 1994.Google Scholar
2. Ishihara, T., Matsuda, H. and Takita, Y., Proc. 2nd Intl. Symp. on Ionic and Mixed Conducting Ceramics, Electrochem. Soc., Pennington, NJ, 94-12, 85, 1994.Google Scholar
3. Ishihara, T., Minami, H., Matsuda, H. and Takita, Y., Proc. 4th Intl. Symp. on Solid Oxide Fuel Cells (SOFC-IV), Electrochem. Soc., Pennington, NJ, 95–1, 345, 1995.Google Scholar
4. Wang, W. and Hellstrom, E.E., to be published in J. Am. Cer. Soc.Google Scholar
5. Anderson, H.U., Tai, L-W., Chen, C.C., Nasrallah, M.M. and Huebner, W., Proc. 4th Intl. Symp. on Solid OxideFuel Cells (SOFC-IV), Electrochem. Soc., Pennington, NJ, 95–1, 375, 1995.Google Scholar
6. Tai, L-W., Nasrallah, M.M. and Anderson, H.U., Proc. 3rd Intl. Symp. on Solid Oxide Fuel Cells (SOFC-III), Electrochem. Soc., Pennington, NJ, 93–4, 241, 1993.Google Scholar
7. Chen, C.C., Nasrallah, M.M. and Anderson, H.U., ibid, 598.Google Scholar
8. Youngblood, G.E., Rupaal, A.S., Pederson, L.R. and Bates, J.L., ibid, 585.Google Scholar
9. Ivers-Tiffee, E., Schiebl, M., Oel, H.J. and Wersing, W., ibid., 613.Google Scholar
10. Priestnall, M.A. and Steele, B.C.H., Proc. 1 st Intl. Symp. on Solid Oxide Fuel Cells (SOFC-I), Electrochem. Soc., Pennington, NJ, 89–11, 157, 1989.Google Scholar
11. Takeda, T., Kanno, R., Noda, M., Tomida, Y. and Yamamoto, O., J. Electrochem. Soc. 134, 2656, 1987.Google Scholar
13. Mizusaki, J., Solid State Ionics, 52, 79, 1992.Google Scholar
14. Yokokawa, H., Sakai, N., Kawada, T. and Dokiya, M., ibid., 52, 43, 1992.Google Scholar
15. Bauerle, J.E., J. Phys. Chem. Solids, 30, 2657, 1969.Google Scholar
16. Boukamp, B.A., Solid State Ionics, 18–19, 136, 1986.Google Scholar