Hostname: page-component-76fb5796d-2lccl Total loading time: 0 Render date: 2024-04-26T16:28:51.360Z Has data issue: false hasContentIssue false
  • English
  • Français

Studies of residual stress, microcracks, hardness and microstructure of cold compacted metallic green bodies

Published online by Cambridge University Press:  11 February 2011

Torsten Ericsson ,
Cecilia Larsson  and
Ru Lin Peng
Torsten Ericsson
Affiliation:
Linköping University, 581 83 Linköping, Sweden
Cecilia Larsson
Affiliation:
Linköping University, 581 83 Linköping, Sweden
Ru Lin Peng
Affiliation:
Linköping University, 581 83 Linköping, Sweden
Get access

Abstract

The residual stresses have been measured by X-ray and neutron diffraction on PM green bodies manufactured by conventional and high speed compaction of iron powder with and without added copper and brass powder. Compressive residual stresses are present in a thin layer in both top and side surfaces. They are largest in the side surfaces due to plastic deformation of the surface material caused by the friction forces during ejection out of the die. In the interior of the green body residual stresses exist with certain region under compression (periferical regions) and other under tension (more central regions). It is unclear whether mixing iron powder with brass or copper powder leads to considerable phase stresses between the two phases.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 759: Symposium MM – Granular Material-Based Technologies , 2002 , MM2.6
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Skoglund, P.: High density PM parts by high velocity compaction, Powder metallurgy, Vol. 44, No. 3, 2001.Google Scholar
2. ASM Handbook, Vol. 7, ASM International, Materials Park, OH, 1994.Google Scholar
3. German, R.M., Powder Metallurgy Science, Metal Powder Industries Federation, Princeton, USA, 1994.Google Scholar
4. Redanz, P., Int. J. Mech. Sci., 40, 1175–1189, 1998.Google Scholar
5. Jonsen, P. and Häggblad, H-Å.: Finite element analysis of stresses in green bodies of metal powder, Proceedings of PM 2002, Orlando, USA, June 2002.Google Scholar
6. Luukkonen, P. and Ericsson, T., Residual stresses in green bodies of steel powder and their relaxation during heat treatment, in Proc. 20th ASM Heat treating Society Conf., ASM International, Materials Park, 2001.Google Scholar
7. Ericsson, T. and Luukkonen, P.: residual stresses in green bodies of steel powder after conventional and high speed compaction, Proc. 6th European Conference on Residual Stresses, Coimbra, Portugal, TTP, Zurich, 2002.Google Scholar
8. Luukkonen, P. and Ericsson, T.: A robust Direct Current Potential Drop, DCPD, method to inspect cold pressed green bodies, Submitted to Powder Metallurgy, 2002.Google Scholar
9. Noyan, I. C. and Cohen, J. B.: Residual stress, Springer-Verlag, 1987.Google Scholar