Hostname: page-component-848d4c4894-tn8tq Total loading time: 0 Render date: 2024-06-18T23:17:58.541Z Has data issue: false hasContentIssue false

Rapid Thermal Oxidation of GeSi Strained Layers

Published online by Cambridge University Press:  28 February 2011

D. K. Nayak
Affiliation:
Dept. of Electrical Engineering, University of California, Los Angeles, CA 90024
K. Kamjoo
Affiliation:
Dept. of Electrical Engineering, University of California, Los Angeles, CA 90024
J. S. Park
Affiliation:
Dept. of Electrical Engineering, University of California, Los Angeles, CA 90024
J. C. S. Woo
Affiliation:
Dept. of Electrical Engineering, University of California, Los Angeles, CA 90024
K. L. Wang
Affiliation:
Dept. of Electrical Engineering, University of California, Los Angeles, CA 90024
Get access

Abstract

A cold-wall rapid thermal processor is used for the oxidation of commensurately grown GexSi1−x layers on Si substrates. It is shown for dry oxidation that the oxidation rate of GeSi is the same as that of Si. The dry oxidationrate of GeSi is independent of Ge concentration (up to 20 % considered in this study) in the GeSi layer. For wet oxidation, however, the rate of oxidation of the GexSi1−x layer is found to be significantly higher than that of pure Si, and the oxidation rate increases with the Ge concentration in GexSi1−x layer. Employing highfrequency and quasistatic Capacitance-Voltage measurements, it is found for a thin oxide that a fixed negative oxide charge density in the range of 1011 – 1012/cm2, and the interface trap level density (in the mid-gap region) of about 1012 /cm2.eV are present. Further, the density of this fixed oxide charge at the SiO2 /GeSi interface is found.to increase with the Ge concentration in the commensurately grown GeSi layers.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] People, R., J. Quantum Electron., 22, 1696 (1986).Google Scholar
[2] Iyer, S. S., Patton, G. L., Stork, J. M. C., Meyerson, B. S., and Harame, D. L., IEEE Trans. Electron Devices, 36, 2043 (1989).Google Scholar
[3] Rhee, S. S., Park, J. S., Karunasiri, R. P. G., Ye, Q., and Wang, K. L., Appl. Phys. Lett., 53, 204 (1988).Google Scholar
[4] Ishizaka, A. and Shiraki, Y., J. Electrochem. Soc., 133, 666 (1989).Google Scholar
[5] Lassig, S. E., Debolske, T. J., and Crowley, J. L. in Rapid Thermal Processing of Electronic Materials, edited by Wilson, S. R., Powell, R. A., and Davies, D. E. (Mater. Res. Soc. Proc. 92, Pittsburgh, PA 1987) pp. 103108.Google Scholar
[6] Nayak, D., Kamjoo, K., Woo, J. C. S., Park, J. S., and Wang, K. L., Appl. Phys. Lett., 56, 66 (1990).Google Scholar
[7] Pedinoff, M. E. and Stafsudd, O. M., Appl. Opt., 21, 518 (1982).Google Scholar
[8] Nicollian, E. N., and Brews, J. F., MOS Physics and Technology, (Wiley, New York 1982) p. 331.Google Scholar
[9] LeGoues, F. K., Rosenberg, R., Nguyen, T., Himpsel, F., and Meyerson, B. S., J. Appl. Phys., 65, 1724 (1989).Google Scholar