Hostname: page-component-848d4c4894-4hhp2 Total loading time: 0 Render date: 2024-04-30T21:00:27.241Z Has data issue: false hasContentIssue false

Power Density Effects in the Physical and Chemical Properties of Sputiered Diamond-Like Carbon thin Films

Published online by Cambridge University Press:  21 February 2011

N.-H. Cho
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
K.M. Krishnan
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
D.K. Veirs
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
M.D. Rubin
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
C.B. Hopper
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
B. Bhushan
Affiliation:
Lawrence Berkeley Laboratory, One Cyclotron Rd., University of California, Berkeley, CA 94720
D.B. Bogy
Affiliation:
Department of Mechanical Engineering, University of California, Berkeley, CA 94720
Get access

Abstract

Thin films of diamond-like amorphous carbon were prepared by dc magnetron sputtering. A systematic variation in the physical properties of the films (mass density and electrical resistivity) was found as a function of sputtering power density. Chemical bonding and microstructure of the carbon thin films were investigated using electron energy loss spectroscopy (EELS) and Raman spectroscopy. Films grown at a lower power density were found to have more sp3 -bonded atomic sites and larger graphite microcrystals than films produced at higher sputtering power densities.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Anderson, D.A., Phil. Mag., 35, 17, 1977.Google Scholar
2. Bubenzer, A., Dischler, B., Brandt, B., and Koidl, P., J. Appl. Phys., 54(8), 4590, 1983.Google Scholar
3. Weissmantel, C., Bewilogua, K., Breuer, K., Dietrich, D., Ebersbach, U., Erler, H.J., Rau, B. and Riessen, G., Thin Solid Films, 96, 31, 1982.Google Scholar
4. Savvides, N., J. Appl. Phys., 58, 518, 1985.Google Scholar
5. Tsai, H. and Bogy, D.B., J. Vac. Sci. Tech., A5(6), 3287, 1987.Google Scholar
6. Dillon, R.O., Woollam, J.A., and Katkanant, V., Phys. Rev.B, 29(6), 3482, 1984.Google Scholar
7. Wada, N., Gaczi, P.J., and Solin, S.A., J. Non-Cryst. Solids, 35, 543, 1980.Google Scholar
8. McFeely, F.R., Lowlaczyk, S.P., Ley, L., Cavell, R.G., Pollak, R.A., and Shirley, D.A., Phys. Rev., B9, 5268, 1974.Google Scholar
9. Batson, P.E. and Craven, A.J., Phys. Rev. Lett., 42, 893, 1979.Google Scholar
10. Raether, H., in “Excitation of Plasmons and Interband Transitions by Electrons,” Springer-Verlag.Google Scholar
11. Liang, W.Y. and Cundy, S., Phil. Mag., 19, 1031, 1969.Google Scholar
12. Taft, E.A. and Phillip, H.R., Phys. Rev., 138, 197, 1965.Google Scholar
13. Williams, D.B. and Edington, J.W., J. Microscopy, 108(2), 113, 1976.Google Scholar
14. Nemanich, R.J. and Solin, S.A., Phys. Rev.B, 20(2), 392, 1979.Google Scholar
15. Tuninstra, F. and Koenig, J.L., J. Compos. Mater., 4, 492, 1970.Google Scholar
16. Zallen, R., in “The Physics of Amorphous Solids,” Wiley-Interscience Pub., NY, 1983.Google Scholar
17. Beeman, D., Silverman, J., Lynds, R., and Anderson, M.R., Phys. Rev.B, 30, 870, 1984.Google Scholar
18. Richter, A., Scheibe, H.-J., Pompe, W., Brzezinka, K.-W., and Muhling, I., J. Non-Cryst. Solids, 88, 131, 1986.Google Scholar