Hostname: page-component-848d4c4894-jbqgn Total loading time: 0 Render date: 2024-06-24T23:21:20.874Z Has data issue: false hasContentIssue false
  • English
  • Français

Power and Efficiency Calculation and Evaluation of Material Properties in Thermoelectric Power Generators

Published online by Cambridge University Press:  01 February 2011

Konstantinos Zorbas ,
Euripides Hatzikraniotis  and
Konstantinos M Paraskevopoulos
Konstantinos Zorbas
Affiliation:
kzorbas@physics.auth.gr, Aristotle University of Thessaloniki, Dept. of Physics, Section of Solid State Physics, University Campus, Thessaloniki, GR 54124, Greece
Euripides Hatzikraniotis
Affiliation:
evris@physics.auth.gr, Aristotle University of Thessaloniki, Dept. of Physics, Section of Solid State Physics, University Campus, Thessaloniki, GR 54124, Greece
Konstantinos M Paraskevopoulos
Affiliation:
kpar@auth.gr, Aristotle University of Thessaloniki, Dept. of Physics, Section of Solid State Physics, University Campus, Thessaloniki, GR 54124, Greece
Get access

Abstract

Thermoelectric elements convert a part of thermal power into electrical, developing the Seebeck effect. A number of thermoelectric elements can be connected electrically in parallel and/or in series shaping a thermoelectric generator (TEG) device. The generator efficiency, η, is determined by comparing the amount of electricity produced (PTEG) to the total amount of heat induced (QH). The possible use of such a device for the recovery of wasted heat can considerably help the world effort for energy savings and the reduction of greenhouse gases.

A measuring system and a modeling approach which takes into account the thermal contact resistances have been developed, allowing the characterization of TEG devices under various loads and temperature gradients and thus, the evaluation of material properties. The model was applied on investigating the expected gained power and efficiency, at different places of the exhaust pipe of an intermediate size car with the use of conventional thermoelectric elements. Furthermore, the reliability of a TEG module was examined and the repercussion on fuel consumption is discussed.

Keywords

thermoelectricitydeviceselectrical properties
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1044: Symposium U – Thermoelectric Power Generation , 2007 , 1044-U09-15
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Cobble, , Milan, H., “Calculations of Generator Performance”, Chap. 39 in CRC Handbook of Thermoelectrics edited by Rowe, D. M., CRC Press LLC, New York, pp. 489–501, 1995.Google Scholar
2. Iwasaki, Hideo, J. Appl. Phys. 41 6606–6609 (2002)Google Scholar
3. Min, , Rowe, , and Kontostavlakis, , J. Phys. D: Appl. Phys., 37 1301–1304 (2004)Google Scholar
4. Downey, and Hogan, in Circuit model of a thermoelectric module for AC electrical measurements”(Proc. 24th ICT Clemson 2005) pp. 79–82 Google Scholar
5. Rauscher, L, Fujimoto, S, Kaibe, H T and Sano, S, Meas. Sci. Tech., 16 1054–1060 (2005)Google Scholar
6. Vázquez, J., Sanz-Bobi, M.A., Palacios, R., and Arenas, A. in State of the Art of Thermoelectric Generators Based on Heat Recovered from the Exhaust Gases of Automobiles, (Proc. 7th European Workshop on Thermoelectrics, Pamplona, Spain 2002), p.17 Google Scholar
7. Zorbas, K., Hatzikraniotis, E. and Paraskevopoulos, K.M. in Study of Power efficiency in Thermoelectric Power Generators, (Proc. XXII Greek Conference of Solid State Physics and Science of Materials, Patra Greece, September 24-27, 2006)Google Scholar
8. Salgon, J., Robbe-Valloire, F. and Blouet, J., Int. J. Heat Mass Transfer. 40 1121–1129 (1997)Google Scholar
9. Zorbas, K., Hatzikraniotis, E. and Paraskevopoulos, K.M. in Power and Efficiency Calculation in Commercial TEG and Application in Wasted Heat Recovery in Automobile (Proc. ECT2007 5th European Conf. on Thermoelectrics, Odessa, Ukraine, 2007) p. 30 Google Scholar
10. LaGrandeur, J., Crane, D. and Eder, A., presented in 2005 Diesel Engine Emissions Reduction (DEER) Conference, Chicago, Il, 2005 Google Scholar
11. Hatzikraniotis, E., Zorbas, K. and Paraskevopoulos, K.M. in Investigation of possible use of a thermoelectric device for waste heat recovery from a gasoline engine (Proc. XXIII Greek Conf. of Solid State Phys. and Sc. of Mat., Athens Greece, 2006)Google Scholar