Hostname: page-component-8448b6f56d-dnltx Total loading time: 0 Render date: 2024-04-19T16:22:30.025Z Has data issue: false hasContentIssue false
  • English
  • Français

Line-Source Processing of SOI Structures with Laser and Electron Beam

Published online by Cambridge University Press:  21 February 2011

Leslie J. Palkuti  and
Chan-Sui pang
Leslie J. Palkuti
Affiliation:
Advanced Research and Applications Corp., 1223 E. Arques Ave., Sunnyvale, CA
Chan-Sui pang
Affiliation:
Advanced Research and Applications Corp., 1223 E. Arques Ave., Sunnyvale, CA
Get access

Abstract

Line-shaped laser and electron beams in combination with halogen-lamp substrate heating were used to fabricate single-crystal SOI films. Electron-beam and laser systems were developed to achieve a minimum beam cross section of 10–100 microns and aspect ratios up to 70. Unseeded SOI films were fabricated with a (100) textured single-crystal structure. Seeded films were recrystallized with 20 × 80-micron single crystal islands with no low-angle grain boundaries. A process window of 1 to 10 percent in electron-beam power was measured. Single-crystal films were obtained at a line-scan velocity up to 2 cm/s suggesting a potential throughput of about 100 wafers per hour. The high scan velocity allows for minimizing the high-temperature cycle to under 30 seconds that the wafer is exposed to during recrystallization. This short temperture cycle is compatible with the fabrication of three dimensional devices, since unwanted diffusion and substrate damage are minimized.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 33: Symposium D – Comparison of Thin Film Transistor and SOI Technologies , 1984 , 93
Copyright
Copyright © Materials Research Society 1984

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Gat, A., Gerzberg, L., Gibbons, J.F., Magee, T.J., Peng, J., Hong, J., Appl. Phys. Lett., 33(5), October 1978.Google Scholar
2. Lam, H.W., Tasch, A.F., Jr., and Holloway, T.C., IEEE Electron Device Lett. EDL-1, 206 (1980).Google Scholar
3. Knapp, T.A. and Picraux, , J. Appl. Phys., 53(7), 1982.Google Scholar
4. Ohmura, Y., Shibata, K., Inque, T., et.al., IEEE Electron Dev. Lett. EDL- 4:3, March 1983.Google Scholar
5. Lam, H.W., ” Appl. Phys. Lett. 41(11), December 1982.Google Scholar
6. Fan, J.C.C., et.al., ” Appl. Phys. Lett. 41(2), July 1982.Google Scholar
7. Stultz, T.J. and Gibbons, J.F., Appl. Phys. Lett, 41(9), November 1982.Google Scholar
8. Magee, T.J., Palkuti, L.J., Ormond, R., et.al., Appl. Phys. Lett. 38(4), 248 (1981).Google Scholar
9. Stultz, T.J. and Gibbons, J.F., Appl. Phys. Lett. 39(2) 1981.Google Scholar
10. Nissim, Y.I., Lietoila, A., Gold, R.B. and Gibbons, J.F., J. Appl. Phys. 51(1), January 1980.Google Scholar
11. Carslaw, H.s. and Jaeger, T.C., Conduction of Heat in Solids, 2nd ed. (Oxford University, New York 1959).Google Scholar
12. Davis, J.R., McMahon, R.A. and Ahmed, H., Electronics Lett. 18, 163 (1982).Google Scholar
13. Rensch, D.B. and Chen, J.Y., IEEE Electron Dev. Lett., EDL- 5:2, February 1984.Google Scholar
14. Hayafuji, Y., Yanada, T., Usur, S., et.al., Appl. Phys. Lett., 43(5), September 1983.Google Scholar
15. Palkuti, L.J., et.al., “The Influence of Surface Encapsulation on SOI Recrystallization,” ECS Meeting, Montreal, Canada, 1982.Google Scholar