Hostname: page-component-77c89778f8-rkxrd Total loading time: 0 Render date: 2024-07-17T09:33:12.463Z Has data issue: false hasContentIssue false

Investigation of the Surface Morphology of a-Si:H by Atomic Force Microscopy and In-Situ Ellipsometry

Published online by Cambridge University Press:  15 February 2011

H. N. Wanka
Affiliation:
Univ. Stuttgart, Inst. f. Physikalische Elektronik, Pfaffenwaldring 47, D-70569 Stuttgart, Germany
A. Hierzenberger
Affiliation:
Univ. Stuttgart, Inst. f. Physikalische Elektronik, Pfaffenwaldring 47, D-70569 Stuttgart, Germany
M. B. Schubert
Affiliation:
Univ. Stuttgart, Inst. f. Physikalische Elektronik, Pfaffenwaldring 47, D-70569 Stuttgart, Germany
Get access

Abstract

Combining real-time ellipsometry and atomic force microscopy (AFM) the growth of hydrogenated amorphous silicon (a-Si:H), deposited on crystalline silicon wafers with a native oxide layer on top and on fused silica from a dc glow discharge, has been studied from initial nucleation to the final morphology. By in-situ ellipsometry we detected the evolution of morphology changes. The surface structure has been determined by AFM in the nucleation phase and in the subsequent growth stage. During nucleation on crystalline silicon only few (about 40 per 1μm) flat islands of a-Si:H (up to 4 nm high and up to 50 nm in diameter) grow with a strongly enhanced rate compared to bulk deposition. Once the crystalline surface has completely been covered by a-Si:H, the fast deposition of these islands stops and further surface structures, comparable with the initial ones, start to grow gradually until a homogeneous final roughness up to 5nm high is formed. Nucleation of a-Si:H on fused silica yields densely distributed nuclei (up to 1.5 nm high and up to 25 nm in diameter), indicating a shorter surface diffusion length on this substrate compared to the growth on silicon wafers. The ongoing film deposition, however, finally results in a morphology comparable to the one of a-Si:H grown on crystalline silicon. Using hydrogen dilution we found that the final roughness is affected by the dilution ratio; furthermore infrared spectroscopy reveals the surface structure to be correlated with the hydrogen content of the a-Si:H films.

Type
Research Article
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Collins, R.W. and Pawlowski, A., J. Appl. Phys. 59 (4), 1160 (1985).Google Scholar
2. Collins, R.W. and Cvese, J.M., J. Appl. Phys. 61 (5), 1869 (1987).Google Scholar
3. Drevillon, B., Thin Solid Films 130, 165 (1985).Google Scholar
4. Antoine, A.M. and Drevillon, B., J. Appl. Phys. 63 (2), 360 (1988).Google Scholar
5. Collins, R.W. and Yang, B.Y., J. Vac. Sci. Technol. B 7 (5), 1155 (1989).Google Scholar
6. Li, Y.M., An, Ilsin, Nguyen, H.V., Wronski, C.R., and Collins, R.W., Phys. Rev. Let. 68 (18), 2814 (1992).Google Scholar
7. Stutzin, G.C., Ostrom, R.M., Gallagher, A., and Tanenbaum, D.M., J. Appl. Phys. 74 (1), 91 (1993).Google Scholar
8. Tanenbaum, D.M., Laracuente, A., and Gallagher, A. in Amorphous Silicon Technology, (Mat. Res. Soc. Symp. Proc. 336, Pittsburgh, PA, 1994) pp. 4954.Google Scholar
9. Wanka, H.N., Lotter, E., and Schubert, M.B. in Amorphous Silicon Technology, (Mat. Res. Soc. Symp. Proc. 336, Pittsburgh, PA, 1994) pp. 657662.Google Scholar
10. Wanka, H.N., Schubert, M.B., and Lotter, E., presented at the 1th WCPEC, Hawai, (in print) 1994.Google Scholar
11. Jasperson, S.N., Bürge, D.K., and O'Handley, R.C., Surf. Sci. 37, 548 (1973).Google Scholar
12. Azzam, R.M.A. and Bashara, N.M., in Ellipsometry and Polarized Light, (North-Holland, Amsterdam, 1977), pp. 332340.Google Scholar
13. Bruggeman, D.A.G., Ann. Phys. 24, 636 (1935).Google Scholar
14. Maley, N., Phys. Rev. B 46 (4), 2078 (1992).Google Scholar
15. McCaughey, M.J. and Kusher, M.J., J. Appl. Phys. 65 (1), 186 (1989).Google Scholar