Hostname: page-component-76fb5796d-45l2p Total loading time: 0 Render date: 2024-04-26T00:45:39.940Z Has data issue: false hasContentIssue false
  • English
  • Français

Interplay Between the Crystal and Liquid Crystalline Ordering of iPP and Carbon Nanotube Composites under Melt-Shear

Published online by Cambridge University Press:  02 February 2011

Georgi Georgiev ,
Michael B. McIntyre ,
Robert Judith ,
Erin A. Gombos  and
Peggy Cebe
Georgi Georgiev
Affiliation:
Department of Natural Sciences, Assumption College, Worcester, MA 01609, U.S.A. Department of Physics and Astronomy, Tufts University, Medford, MA 02155, U.S.A.
Michael B. McIntyre
Affiliation:
Department of Natural Sciences, Assumption College, Worcester, MA 01609, U.S.A.
Robert Judith
Affiliation:
Department of Physics and Astronomy, Tufts University, Medford, MA 02155, U.S.A.
Erin A. Gombos
Affiliation:
Department of Natural Sciences, Assumption College, Worcester, MA 01609, U.S.A.
Peggy Cebe
Affiliation:
Department of Physics and Astronomy, Tufts University, Medford, MA 02155, U.S.A.
Get access

Abstract

Carbon nanotubes (CNTs) exhibit liquid crystalline order and their nematic director couples to the one of low molecular weight liquid crystals. Here we explore the interactions between CNTs and the smectic liquid crystal phase of a polymer and the possibility for a similar coupling in this system. Isotactic Polypropylene (iPP) and iPP/CNTs nanocomposites were made in solution with varying CNT concentrations and hot pressed into 50-100μm thick films. The pure iPP and iPP/CNT films were then sheared at one rotation per second in the melt state. Shearing continued as the temperature was decreased from 200°C to 145°C to induce a smectic liquid crystal phase. The sheared samples were analyzed using polarized optical microscopy, Two Dimensional Microscopic Transmission Ellipsometry (2D-MTE) and Two Dimensional Wide Angle X-Ray Scattering (2D-WAXS). During shearing we detected a sudden increase of birefringence at 151°C in the samples, higher than the iPP crystallization temperature, indicating liquid crystalline ordering. The samples were then crystallized at 135°C for 30 minutes. We measured anisotropic 2D-WAXS patterns of the samples that contained CNTs, indicating strong ordering of the crystals. Upon reheating, we measured birefringence at temperatures higher than the melting endotherm for the iPP crystals, using polarized microscopy, which indicates that some smectic order still persists in the samples, even after crystallization and complete melting of all crystals. Our results indicate that CNTs couple to the smectic phase of iPP, improve its order upon shearing and the crystals created after the formation of the oriented smectic phase are strongly aligned parallel to the direction of shearing.

Keywords

liquid crystalpolymercrystal
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1308: Symposium DD – Artificially Induced Crystalline Alignment in Thin Films and Nanostructures , 2011 , mrsf10-1308-dd07-09
Copyright
Copyright © Materials Research Society 2011

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Li, L., Jeu, W., Faraday Discuss. 128, 299–319 (2005).Google Scholar
2. Hobbie, E. K., Wang, H., Kim, H., Lin-Gibson, S. and Grulke, E. A. Physics of Fluids 15(5), 1196 (2003).Google Scholar
3. Georgiev, G., Cabrera, Y., Wielgus, L., Iftikhar, Z., Mattera, M., Gati, P., Potter, A. and Cebe, P., in Artificially Induced Grain Alignment in Thin Films, edited by Matias, V., Hammond, R., Moon, S.-H., Hühne, R. (Mater. Res. Soc. Symp. Proc. 1150, Warrendale, PA, 2009), RR04-16, p. 185–190.Google Scholar
4. Song, W., Kinloch, I.A., Windle, A.H., Science 302, 1363 (2003).Google Scholar
5. Dawid, A., Gwizdała, W., Journal of Non-Crystalline Solids 355, 1302–1306 (2009).Google Scholar
6. Gwizdała, W., Górny, K., Gburski, Z., Journal of Molecular Structure 887, 148–151 (2008).Google Scholar
7. Georgiev, G., Gombos, E. A., McIntyre, M., Mattera, M., Gati, P., Cabrera, Y. and Cebe, P., in Nanoscale Pattern Formation, edited by Chason, E., Cuerno, R., Gray, J., Heinig, K.-H., (Mater. Res. Soc. Symp. Proc. 1228E, Warrendale, PA, 2010), KK11–81.Google Scholar
8. Varga, J., Journal of Materials Science 27, 2557–2579 (1992).Google Scholar
9. Georgiev, G., Cabrera, Y., Cronin, M., Rocheleau, C., Feinberg, B. and Cebe, P., Bulletin of the American Physical Society, 53(1) R1.00132 (2008).Google Scholar
10. Assouline, E., Lustiger, A., Barber, A. H., Cooper, C. A., Klein, E., Wachtel, E. and Wagner, H. D., Journal of Polymer Science: Part B: Polymer Physics 41, 520 (2003).Google Scholar
11. Avila-Orta Francisco, C. A., Medellýn-Rodrýguez, J., Davila-Rodrýguez, M. V., Aguirre-Figueroa, Y. A., Yoon, K. and Hsiao, B. S., Journal of Applied Polymer Science, 106, 2640 (2007).Google Scholar
12. Georgiev, G., “Structural Studies of Polymers and Polymer Liquid Crystals by X-ray Scattering, Thermal Analysis and Ellipsometric Studies Through Polarized Light Microscopy.” Ph.D. Thesis, Tufts University, Medford, MA (2002).Google Scholar