Hostname: page-component-7479d7b7d-jwnkl Total loading time: 0 Render date: 2024-07-12T07:32:37.305Z Has data issue: false hasContentIssue false
  • English
  • Français

Influence of Temperature on Hydraulic Conductivity in Compacted Bentonite

Published online by Cambridge University Press:  10 February 2011

W. J. Cho ,
J. O. Lee  and
K. S. Chun
W. J. Cho
Affiliation:
Korea Atomic Energy Research Institute P.O. Box 105, Yusong, Taejon 305-606, Korea
J. O. Lee
Affiliation:
Korea Atomic Energy Research Institute P.O. Box 105, Yusong, Taejon 305-606, Korea
K. S. Chun
Affiliation:
Korea Atomic Energy Research Institute P.O. Box 105, Yusong, Taejon 305-606, Korea
Get access

Abstract

The hydraulic conductivities in water saturated bentonites at different densities were measured within temperature range of 20 to 80 °C. The results show that the hydraulic conductivities increase with increasing temperature. The hydraulic conductivities of bentonites at the temperature of 80 °C increase up to about 3 times as high as those at 20 °C. The measured values are in good agreement with those predicted. The change in viscosity of water with temperature contributes greatly to increase of hydraulic conductivity.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 506: Symposium – Scientific Basis for Nuclear Waste Management XXI , 1997 , 305
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Pusch, R., “Permeability of highly compacted bentonite,” SKB Technical Report 80–16 (1980).Google Scholar
2 Mingarro, E. et al. , “Characterization of clay(bentonite)/crushed granite mixtures to build barriers against the migration of radionuclides: diffusion studied and physical properties,” Commission of the European Communities Report EUR 13666 (1989).Google Scholar
3 Peterson, E. and Kelkar, S., “Laboratory tests to determine hydraulic and thermal properties of bentonite-based backfill materials,” SAND-82-7221, Sandia National Lab. New Mexico (1982).Google Scholar
4 , Ouyang, Daemen, J.J.K., “Sealing performance of bentonite and bentonite/crushed rock borehole plugs,” NUREG/CR-5685, U.S. Nuclear Regulatory Commission, Wa (1992).Google Scholar
5 Carman, P. C., “Permeability of saturated sands, soils, and clays,” J. of Agricultural Science, Vol. XXIX, Part 2, 262–273 (1939).Google Scholar
6 Hahn, P. S. et al., “Technology development for HLW disposal system evaluation,” KAERI-NEMAC/RR-170/96, Korea Atomic Energy Research Institute, Korea (1996).Google Scholar
7 Kahr, G., Muller-Vonmoos, F., Kraehenbeuhl, F., and Stoeckil, H.F., “Water uptake and motion in highly densified bentonite,” NTB-86-14, NAGRA, Baden, Switzerland (1986).Google Scholar
8 Pusch, R., “Permanent crystal lattice contraction - a primary mechanism in thermally induced alternation of Na-bentonite. In Scientific Basis for Nuclear Waste Management, Edited by Bates, J.K. and Seefeldt, W.B., Material Research Society, 791–802 (1986).Google Scholar
9 Pusch, R. and Guven, N., “Electron microscopic examination of hydrothermally treated bentonite clay,” Engineering Geology, 28, 303–314 (1990).Google Scholar
10 Derjaguin, B.V., Karasev, V.V. and Khromova, E.N., “Thermal expansion of water in fine pores,” J. of Colloid and Interface Science, 106, 586–587 (1986).Google Scholar