Hostname: page-component-7bb8b95d7b-dvmhs Total loading time: 0 Render date: 2024-09-12T13:17:56.311Z Has data issue: false hasContentIssue false

Growth of (110) GaAs/GaAs by Molecular Beam Epitaxy

Published online by Cambridge University Press:  28 February 2011

L.T. Parechanian
Affiliation:
Univ. of Calif. at Berkeley, Dept. of Materials Science and Center for Advanced Materials (Lawrence Berkeley Laboratories), Berkeley, CA 94270
E.R. Weber
Affiliation:
Univ. of Calif. at Berkeley, Dept. of Materials Science and Center for Advanced Materials (Lawrence Berkeley Laboratories), Berkeley, CA 94270
T.L. Hierl
Affiliation:
Varian Solid State Microwave Div., 3251 Olcott St, Santa Clara, CA 95050
Get access

Abstract

The simultaneous molecular beam epitaxy (MBE) growth of (100) and (110) GaAs/GaAsintentionally doped with Si(∼lE16/cm^3) was studied as a function of substrate temperature, arsenic overpressure, and epitaxial growth rate. The films wereanalyzed by scanning electron and optical microscopy, liquid helium photoluminescence (PL), and electronic characterization.

For the (110) epitaxal layers, an increase in morphological defect density and degradation of PL signal was observed with a lowering of the substrate temperature from 570C. Capacitance-voltage (CV) and Hall Effect measurements yield room temperature donor concentrations for the (100) films of n∼l5/cm^3 while the (110) layers exhibit electron concentrations of n∼2El7/cm^3. Hall measurements at 77K on the (100) films show the expected mobility enhancement of Si donors, whereas the (110) epi layers become insulating or greatly compensated. This behavior suggests that room temperature conduction in the (110) films is due to a deeper donor partially compensated by an acceptor level whose concentration is of the same order of magnitude as that of any electrically active Si. Temperature dependent Hall effect indicates that the activation energy of the deeper donor level lies ∼290 meV from the conduction band. PL and Hall effect indicate that the better quality (110) material is grown by increasingthe arsenic flux during MBE growth. The nature of the defects involved with the growth process will be discussed.

Type
Research Article
Copyright
Copyright © Materials Research Society 1985

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Skeath, P., Lindau, I., Su, C.Y., and Spicer, W.E., J.Vac.Sci.Techol., 19, 556 (1981).Google Scholar
2. Kubler, B., Ranke, W., and Jacobi, K., Surface Sci., 92, 519 (1980).Google Scholar
3.J.Mckenna and Reinhart, F.K., J.Appl.Phys., 47, 5, 2069, (1976).Google Scholar
4. Chang, C., Appl.Phys.Lett., 40, 1037, (1982).Google Scholar
5. Katnani, A.D., Chiaradia, P., Sang, H.W. Jr, and Bauer, R.S., J.Vac.Sci. Technol., B2, 471, (1984).Google Scholar
6. Wang, W.I., J.Vac.Sci.Technol., B1, 630, (1983).Google Scholar
7. Almassy, R.J., Reynolds, D.C., Litton, C.W., and McCoy, G.L., GaAs and Related Compounds, 1978, (Inst.of Phys.Conf.Ser. 45, 190, 1979).Google Scholar
8. Kunzel, H. and Ploog, K., AppL.Phys.Lett., 37, 416, 1980.Google Scholar