Hostname: page-component-848d4c4894-5nwft Total loading time: 0 Render date: 2024-05-21T01:46:53.247Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of SiH2Cl2 Addition on the Growth Mechanism of Si Films Prepared by Photochemical Vapor Deposition

Published online by Cambridge University Press:  15 February 2011

T. Oshima ,
K. Yamaguchi ,
K. Abe ,
A. Yamada ,
M. Konagai  and
K. Takahashi
T. Oshima
Affiliation:
Department of Physical Electronics, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
K. Yamaguchi
Affiliation:
Department of Electrical and Electronic Engineering, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
K. Abe
Affiliation:
Department of Electrical and Electronic Engineering, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
A. Yamada
Affiliation:
Department of Electrical and Electronic Engineering, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
M. Konagai
Affiliation:
Department of Electrical and Electronic Engineering, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
K. Takahashi
Affiliation:
Department of Physical Electronics, Tokyo Institute of Technology, 2–12–1 O-okayama, Meguroku, Tokyo 152, Japan.
Get access

Abstract

Effects of SiH2Cl2 and H2 addition to SiH4 on photochemical vapor deposition (photo-CVD) of amorphous Si (a-Si) and epitaxial Si films were investigated, and roles of Cl and H in the growth mechanism were discussed. The surface morphology and the defect density of the obtained a-Si films were evaluated by atomic force microscope (AFM), and constant photocurrent method (CPM), respectively. It was found that the H2 dilution of SiH4 is effective to prepare the a-Si films with smooth surfaces and low defect density. Furthermore, nearly flat surface with the root mean square (RMS) of the roughness of 0.35nm was obtained by the SiH2Cl2 addition to H2-diluted SiH4. In the Si epitaxy, the SiH2Cl2 addition is also efficient to improve the film quality. It is suggested that the growing surface is terminated by both Cl and H, and the surface is more stable than that terminated by only H. Therefore, the diffusion on the growing surface of the film precursors such as SiH3 is enhanced, resulting in the improvement of the surface morphology and the film quality.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 377: Symposium A – Amorphous Silicon Technology 1995 , 1995 , 125
Copyright
Copyright © Materials Research Society 1995

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1) Oshima, T., Yamaguchi, K., Yamada, A., Konagai, M. and Takahashi, K., Mat. Res. Soc. Symp. Pros. 336 (1994) 91.Google Scholar
2) Oshima, T., Sano, M., Yamada, A., Konagai, M. and Takahashi, K., Appl. Surf. Sci. 79/80 (1994) 215.Google Scholar
3) Niki, H. and Mains, G.J., J. Phys. Chem. 68 (1964) 305.Google Scholar
4) Austin, E.R. and Lampe, F.W., J. Phys. Cham. 81 (1977) 1134.Google Scholar
5) Danesh, P., Savatinova, I., Anachnova, E., Georgiev, St., Anastassakis, E. and Liarokapis, E., J. Non-Cryst. Solids, 90 (1987) 303.Google Scholar
6) Kerr, J.A., in Handbook of Chemistry and Physics 1988–1989, edited by Weast, R.C. (the Chemical Rubber Co., Ohio, 1989) pp. F–174-F-182.Google Scholar